Search results for "scattering"
showing 10 items of 8332 documents
Small angle scattering study of the structure of isotactic polypropylene-hydrogenated oligo(cyclopentadiene) blends
1996
Abstract Blends of isotactic polypropylene ( i PP) and hydrogenated oligo cyclopentadiene (HOCP) have been studied by means of small angle X-ray scattering in the temperature range 70–160°C. The structure of blends containing less than 25% HOCP is very similar to the one of plain i PP, i.e. lamellae whose thickness increases by increasing the temperature. Blends containing more than 25% HOCP are characterized by two kinds of lamellae formed by layers of i PP and amorphous material rich in i PP and in HOCP, respectively. The crystallizable i PP present in both phases crystallizes from the melt, in analogy to what happens in HDPE/HOCP blends and in agreement with the values of the crystallini…
Layer-by-layer deposited multilayer assemblies of polyelectrolytes and proteins: from ultrathin films to protein arrays
2008
We have recently introduced a new method of creating ultrathin films of polyelectrolytes based on the electrostatic attraction between opposite charges. Multilayer assemblies are adsorbed in a layer-by-layer fashion from aqueous solutions of the polymers. The total film thickness can easily be adjusted by varying the ionic strength of the solution. Here, we report on the temperature stability and the water content of the multilayer assemblies. Furthermore, we have extended our concept to the incorporation of protein layers into films of synthetic polyelectrolytes. The well established system biotin/streptavidin was used to construct such multilayers, also by biospecific recognition. Adsorpt…
Anomalous intensity of the 335 cm−1 phonon in YBa2Cu3O7−δ
1991
Abstract We report results on Raman scattering for the intensity of the 335 cm −1 phonon of A g (pseudo B 1g ) symmetry in thin YBa 2 Cu 3 O 7−δ films on MgO and LaAlO 3 substrates. The intensity of this phonon shows a pronounced increase below 100 K and saturates at low temperatures. We also observe an additional intensity peaking at temperatures close to the superconducting transition T C . This may indicate a structural phase transition in the vicinity of T C .
Eye Cataract Simulation Using Polymer Dispersed Liquid Crystal Scattering Obstacles
2004
Polymer dispersed liquid crystals with electrically induced variations of light scattering extent similar to that of transparent PLZT ceramics are used for simulation of different development stages of eye cataract. Wavelength dependencies of scattering are determined in the visible spectral range, and human visual response looking through the scattering obstacle to the onset of various spatial frequency stimuli is determined psychophysically and electrophysiologically in order to find correlation between the scattering extent, visual acuity and visual evoked potential VEP chromatic characteristics.
Influence of polysaccharides on wine protein aggregation.
2016
Abstract Polysaccharides are the major high-molecular weight components of wines. In contrast, proteins occur only in small amounts in wine, but contribute to haze formation. The detailed mechanism of aggregation of these proteins, especially in combination with other wine components, remains unclear. This study demonstrates the different aggregation behavior between a buffer and a model wine system by dynamic light scattering. Arabinogalactan-protein, for example, shows an increased aggregation in the model wine system, while in the buffer system a reducing effect is observed. Thus, we could show the importance to examine the behavior of wine additives under conditions close to reality, in…
Influence of“controlled processing conditions” on the solidification of iPP, PET and PA6
2002
In this work reliable experimental data for three semicrystalline polymers (iPP, PA6, PET) crystallised under pressure and high cooling rates are supplied. These results were achieved on the basis of a model experiment where drastic controlled solidification conditions are applied. The final objective was to quantify the effect of two typical operating conditions (pressure and cooling rate) on the final properties and morphology of the obtained product. The influence of processing conditions on some macroscopically relevant properties, such as density and micro hardness is stressed, together with the influence of processing conditions on the product morphology, investigated by means of Wide…
Über eine Beziehung zwischen Verdünnunasentropie und Verdünnungsenthalpie in Lösungen von Polystyrol und Polymethylmethacrylat
1973
Durch Lichtstreuungsmessungen wurde der Entropieanteil und der Enthalpieanteil des 2. osmotischen Virialkoeffizienten (A2) von athermischen und exothermischen Losungen von Polystyrol (PS) und Polymethylmethacrylat (PMMA) bei 25°C und Normaldruck bestimmt. Zur Auffindung von athermischen und exothermischen Losungsmitteln fur diese Polymeren wurde die Temperaturabhangigkeit des STAUDINGERindex verwendet. Die ermittelten thermodynamischen Grosen A2, A2,S und A2,H ergeben zusammen mit fruheren Messungen eine beziehung, die nahezu unabhangig vom speziellen System ist. The second osmotic virial coefficient A2 and its entropic and enthalpic parts of athermal and exothermal solutions of polystyrene…
24. Molecular Biology
1987
Publisher Summary This chapter discusses the use of neutron scattering in molecular biology. The neutron small-angle camera D11 is discussed. The objective of scattering studies on biological macromolecules is to determine molecular conformations and arrangements, particularly those that may contribute to specific biological functions. The principles of neutron scattering are very similar to those of x rays, but some important differences exist due to the different characteristics of the two radiations. If the scattering specimen is a single macromolecule with no regular separation between neighboring structures, then the scattering is continuous. In a coherent scattering process, the ampli…
Streulichtmessungen an polymerlösungen zur bestimmung der verteilungsbreite des Molekulargewichtes
1978
By increasing the experimental accuracy of the classical light scattering technique it became possible to determine the width U = Mw/Mn − 1 of the molecular weight distribution of polymers. For this purpose a very stable laser and a lock-in-amplifier were used allowing an accuracy of 0,2–0,3% in the scattering intensity. The numerical evaluation of the polydispersity is done by a Gaus-Newton procedure analysing the small curvature of the reciprocal scattering function. In an appropriate molecular weight range U is obtained with an error between 0,01 and 0,1 depending on the width of the molecular weight distribution of the sample tested.
Single Particle Motion of Hard-Sphere-Like Polymer Micronetwork Colloids Up to the Colloid Glass Transition
1997
Polymer micronetwork spheres swollen in a good solvent can be regarded as colloids which require no special stabilisation to avoid aggregation. Their interactions can be timed by changing the degree of internal crosslinking. The phase behaviour and the static structure factor demonstrate that crosslink density of 1:10 (inverse number of monomer units between crosslinks) is sufficient to achieve hard sphere behaviour. We designed a host-tracer system consisting of core-shell micronetwork spheres (core: polystyrene; shell: poly-t-butylacrylate) in a host of refractive-indexmatched poly-t-butylacrylate micronetwork colloids. Employing a crosslink density of 1:10 and tuning the polydispersity s…