Search results for "shear"

Flow-induced structures in magnetorheological suspensions

1999

We have measured the yield stress of a magnetic suspension as a function of the external field. To explain the existence of this yield stress, we report a comparison between two models, one based on isolated chains of particles and the other taking into account that the structure is formed by aggregates of particles.

SHEAR BEHAVIOUR OF MOLTEN LINEAR LOW DENSITY POLYETHYLENE.

1984

The rheological behaviour of molten polyethylene has been widely studied especially with respect to the different structure of the high density and low density samplesI–I0. In particular it is well known that the presence in the LDPE of long chain branching alters dramatically the whole flow curve, the activation energy, the die-swell, the instability phenomena, etc.

Red Cell Interactions with the Microcirculation

1976

We have measured RBC velocity profiles for mammalian arterioles and venules from high-speed cinematographic motion pictures. Measurements were made at 320× and 400× optical magnification over an averaging time period of 10 ms. In vivo profiles are uniformly nonsymmetrical, the RBCs exhibit rotation, and they frequently deviate sidewise from the overall axial direction of motion. In general, this is more pronounced on the venous side. Since all of the profiles are time variant and the average values are synchronous with the midstream velocity, individual RBC velocities will vary about the average. Profiles become more blunted in vessels with smaller diameters. In vessels below 16 μm diameter…

Flexible magnetic filaments in a shear flow

2006

By flexible magnetic filament model its behavior under the simultaneous action of the shear flow and the magnetic field is investigated. It is found that for magnetoelastic numbers larger as the critical value, which depends on the shear rate, the periodic regime is established. For the values of the magnetoelastic number close to the critical the periodical regime is characterized by a rather slow development of the buckling instability due to the action of magnetic torques with the subsequent stage of the fast straightening of the filament. For the magnetoelastic numbers below the critical slightly bent shape of the filament orientated along the flow is established. The application of the…

Shear behaviour of undiluted polyisobutylenes

1979

Some new data in shear flow are presented for two commercial polyisobutylene samples, namely Vistanex LMMH and L 100. In particular beyond a few steady state results, the tangential stress build-up after a sudden imposition of a shear rate and the decay after cessation of steady shear flow have been collected. The data are used to further test a constitutive equation already advanced by some of the authors. The comparison seems to confirm the validity of the proposed model, whose single adjustable parameter is shown to be independent of molecular weight.

1983

The viscosity of solutions of poly(decyl methacrylate)s, PDMA, in 1-pentanol (thermodynamically poor solvent) and in toluence or isooctane (good solvents) was measured up to shear rates of 3 · 104s−1 by means of rotational viscosimeters. The observed pronounced shear thinning is for all solutions well described by the theory of Graessley, with the extension, introduced by Ito. Two parameters, resulting from the evaluation of the flow curves on the basis of the above theory, are discussed: τ0, a characteristic relaxation time of the polymer chain, is found to be in the range of ms. ηfric, a frictional parameter, independent of shear rate, amounts upto 50% of the zero-shear viscosity for the …

Rheological studies of moderately concentrated polystyrene solutions. I. A new method for the extrapolation of the zero-shear viscosity

1983

Measurements of the viscosity coefficient η of solutions of polystyrene (Mw = 6.0 × 105 and 1.77 × 106) in trans-decalin (TD, θ solvent) and toluene (TL, good solvent) as function of shear rate (11−104 s−1), concentration (4.24−11.21 wt %), and temperature (10–50°C) are reported. As a new theoretically grounded method for the determination of the zero-shear viscosity η0 it is proposed to plot η as a function of . The intercepts of the straight lines obtained by this procedure give η0 in good agreement with directly measured values.

Phase separation of flowing polymer solutions

2008

Effect of several electrolytes on the rheopectic behaviour of concentrated soy lecithin dispersions

2005

Abstract Concentrated dispersions of soy lecithin (60 g/L) prepared by sonication-freezing–unfreezing method show a non-newtonian behaviour and a significant rheopexy. Shear stress versus shear rate plots shows a loop hysteresis area, which have been studied in soy lecithin dispersions prepared with aqueous solutions of various electrolytes (NaCl, CaCl2, MgCl2 and AlCl3) with concentrations in the range 10−5 to 10−2 mol/L. Also we have studied the effect of different pH on soy lecithin dispersions. The results have revealed a very sensitive influence of nature, valence and concentration of the respective cations and the pH value on the loop hysteresis area values. It seems to indicate that …

Consistency of Carbopol 971-P NF gels and influence of soluble and cross-linked PVP.

2002

A study is made of the polymerization process of polyacrylic acid, commercially known as Carbopol® 971 NF, assessing its consistency as a function of the degree of neutralization at pH values from 3 to 12, approximately. Percentage concentrations ranging from 0.1 to 1.4% (w/w) were studied. The gels obtained were non-Newtonian, and pseudoplastic. As concentration and pH rise, the consistency of the gels increase to a maximum, which appears between pH 6 and 8, allowing their use as vehicles in bioadhesive formulations for mucosal application. Over the increasing viscosity interval, functions were obtained to indicate the consistency of the gel as a function of pH and concentration. Since the…