Search results for "signal processing"
showing 10 items of 2451 documents
New distributed model for synthesis of classical dual mode filters
2010
Up to now, distributed models for classical dual mode filters have not been developed. In this paper, the whole procedure to derive such distributed models is shown step by step. The resulting formulas are very similar to those standard ones used for in-line filters since the 1960s. Model limitations, very similar to those related to classical formulas, in terms of precision and bandwidth, are pointed out. Finally, two practical examples of distributed models of dual mode filters for satellite transponders with different orders have been extracted.
Modeling the Sequential Switching Shunt Series Regulator
2005
This letter characterizes, in terms of the bandwidth and limit cycle frequency of its constituent subsystems, the sequential switching shunt series regulator -S/sup 4/R, a high-efficiency, low-mass and volume power cell devised to power the next generation of regulated power buses in telecommunication spacecrafts. Transconductance power source modeling is used to obtain linear and nonlinear models. These are used to establish a design control strategy which involves the dynamic response in large load requirements or at the end of the satellite life. Simulations and experimental results are also given to demonstrate the validity of the model.
A New Digital Demodulator for Sensorless Control of Electrical Drives with Permanent Magnet Synchronous Motors
2008
This paper deals a new digital demodulator algorithm for sensorless control of interior permanent magnet synchronous motors (IPMS) based on the estimation of speed and rotor angular position. To this aim a signal similar to that generated by a resolver connected to the shaft of the motor is obtained injecting high frequency stator currents. A new digital algorithm has been designed and set up to demodulate the above signal whose implementation can be carried out on the same DSP that processes the whole control algorithm. The proposed demodulator scheme is presented and justified on the theoretic point of view. Simulations results finally validate the effectiveness of the demodulator within …
Piezoelectric Rainfall Energy Harvester Performance by an Advanced Arduino-Based Measuring System
2018
This paper presents the performances of rainfall energy harvesting through the use of a piezoelectric transducer and an Arduino-based measuring system. Different studies agree on the possibility of generating electricity from rainfall, but to date, a study on measuring the quantity of energy produced during rainfall is still missing. The present study begins with results obtained from laboratory researchers using piezoelectric transducers and oscilloscopes, finalized to measure the energy produced from a single raindrop, and concludes with an ad hoc Arduino-based measuring system, aimed to measure the actual amount of electrical energy produced by a piezoelectric transducer that is exposed …
Guidelines for the design and implementation of the ARPCC control applied to grid-connected converters
2013
Abstract This paper presents implementation details of the adaptive robust predictive current control (ARPCC) applied to a grid-connected converter, such as feed-forward cancellation protocol, the selection of the observer gain and adaptive parameters or the sampling options, needed to get the best performance of this control. The feed-forward term cancellation permits to achieve a very low harmonic distortion in current waveforms when the voltage sensing circuits are well calibrated. A detailed gain adjustment protocol of the voltage sensing circuits is presented in this paper. Moreover, a control design procedure based on the observer gain L o boundaries and the adaptive parameters has be…
A New Generalized Robust Predictive Current Control for Grid-Connected Inverters Compensates Anti-Aliasing Filters Delay
2016
In this paper, a new predictive control for grid-connected inverters is presented, which provides the best performance in terms of transient response and stability margins when analog filters in current sensing circuits are used. These filters are necessary to avoid aliasing in the A/D conversion process, which causes an important ripple on injected current into the grid and increases the total harmonic distortion. However, predictive controls are very sensitive to delays on the acquisitions, so when such anti-aliasing filters are used a reduction of stability margins is produced and the transient response is affected. The proposed predictive control allows to compensate the effect of the f…
The Use of Accelerometers and Gyroscopes to Estimate Hip and Knee Angles on Gait Analysis
2014
In this paper the performance of a sensor system, which has been developed to estimate hip and knee angles and the beginning of the gait phase, have been investigated. The sensor system consists of accelerometers and gyroscopes. A new algorithm was developed in order to avoid the error accumulation due to the gyroscopes drift and vibrations due to the ground contact at the beginning of the stance phase. The proposed algorithm have been tested and compared to some existing algorithms on over-ground walking trials with a commercial device for assisted gait. The results have shown the good accuracy of the angles estimation, also in high angle rate movement.
Enhanced LMMSE equalizer for high-speed single frequency network in HSDPA
2011
Currently, considerable interest has been shown in the research and standardization communities in multicell transmission schemes for HSPA, with a number of possible schemes under discussion that include Multiflow, Fast Cell Switching (FCS) and High-Speed Single Frequency Network (HS-SFN). In particular, HS-SFN is a promising technique that not only combines received energy from participating cells, but also reduces intercell interference with low UE complexity. In principle, HS-SFN can be implemented with a small modification to an LMMSE receiver at the UE. This paper introduces a more advanced LMMSE equalizer for High-Speed Single Frequency Network in HSDPA that achieves further performan…
Development of a high-accuracy PC-based wattmeter with commercial data acquisition boards
2011
This paper presents the development of a high accuracy sampling wattmeter, which makes use of two commercial data acquisition boards (DAQs) connected to a common personal computer. Commercial software is also used for data processing and implementation of the virtual instrument. The set up of the PC-based wattmeter is described and a preliminary evaluation of its metrological performances is made by means of two series of experimental tests, which were carried out with an electric power standard and a high performance multifunction calibrator. © 2011 IEEE.
On the Problems of Symbol-Spaced Tapped-Delay-Line Models for WSSUS Channels
2007
Article from the journal: Wireless Communications and Mobile Computing The deposited fulltext is a preprint of the definitive article at Wiley Interscience http://dx.doi.org/10.1002/wcm.683 This paper analyzes the validity and statistical behavior of symbol-spaced tapped-delay-line (SSTDL) models for wide-sense stationary uncorrelated scattering (WSSUS) mobile radio channels. SSTDL models are obtained by sampling the channel impulse response (CIR) in delay domain at a rate equal to the reciprocal of the symbol duration. They were proposed more than four decades ago as canonical channel models for band-limited timevariant linear (TVL) systems, and are nowadays widely in use for assessing the…