Search results for "silica"
showing 10 items of 1092 documents
From Maya Blue to “Maya Yellow”: A Connection between Ancient Nanostructured Materials from the Voltammetry of Microparticles
2011
The yellow hue of a series of samples from wall paintings in several Mayan archaeological sites can be attributed to the presence of indigoid compounds, including isatin and dehydroindigo, attached to palygorskite, a local phyllosilicate clay. SEM/EDX, TEM, UV/Vis spectroscopy, and voltammetry of microparticles show that the ancient Mayas could prepare indigo, Maya Blue, and "Maya Yellow" during successive stages. Copyright © 2011 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.
Effect of Morphology and Size of Halloysite Nanotubes on Functional Pectin Bionanocomposites for Food Packaging Applications
2017
Pectin bionanocomposite films filled with various concentrations of two different types of halloysite nanotubes were prepared and characterized in this study as potential films for food packaging applications. The two types of halloysite nanotubes were long and thin (patch) (200-30 000 nm length) and short and stubby (Matauri Bay) (50-3000 nm length) with different morphological, physical, and dispersibility properties. Both matrix (pectin) and reinforcer (halloysite nanotubes) used in this study are considered as biocompatible, natural, and low-cost materials. Various characterization tests including Fourier transform infrared spectroscopy, field emission scanning electron microscopy, rele…
CCDC 619252: Experimental Crystal Structure Determination
2007
Related Article: L.Lisnard, P.Mialane, A.Dolbecq, J.Marrot, J.M.Clemente-Juan, E.Coronado, B.Keita, P.de Oliveira, L.Nadjo, F.Secheresse|2007|Chem.-Eur.J.|13|3525|doi:10.1002/chem.200601252
The composition of near-solidus melts of peridotite in the presence of CO2 and H2O between 40 and 60 kbar
2009
Abstract Partial melting experiments at 40, 50 and 60 kbar pressure on three peridotite compositions with 0.5–0.63 wt.% H2O and 2.0–3.2 wt.% CO2 added indicate melting temperatures only marginally above continental geotherms. Most experiments were performed on a composition with 1.5 wt.% K2O added, which causes a further decrease of about 40 °C in melting temperature. Melts progress gradually from carbonate-rich to carbonated silicate in composition: near-solidus melts have Ca/(Ca + Mg) of 0.46–0.53, which fall to 30 wt.%) and Al2O3 ( 9 wt.%) and concomitant decrease in CaO (> 20 to Partial melts of peridotite with CO2 and H2O are too low in MgO to resemble kimberlites, but will act as ef…
Carbon concentration increases with depth of melting in Earth’s upper mantle
2021
Carbon in the upper mantle controls incipient melting of carbonated peridotite and so acts as a critical driver of plate tectonics. The carbon-rich melts that form control the rate of volatile outflux from the Earth’s interior, contributing to climate evolution over geological times. However, attempts to constrain the carbon concentrations of the mantle source beneath oceanic islands and continental rifts is complicated by pre-eruptive volatile loss from magmas. Here, we compile literature data on magmatic gases, as a surface expression of the pre-eruptive volatile loss, from 12 oceanic island and continental rift volcanoes. We find that the levels of carbon enrichment in magmatic gases cor…
Dynamic properties of solvent confined in silica gels studied by broadband dielectric spectroscopy
2007
Abstract We report the results of a broadband (10−2–107 Hz) dielectric spectroscopy study on a solvent system (glycerol–water solution) confined in a porous silica matrix. The dielectric relaxation of the system is studied as a function of both temperature (120–280 K) and solvent composition (0–36 glycerol molar percentage), at constant matrix composition. Our data show that glycerol–water systems confined inside silica gel are characterized by a very complex dynamics quite different from that observed in solution, thus indicating that confinement may deeply modify solvent dynamics. Indeed in addition to the relaxation processes similar to those occurring in bulk samples, new dielectric rel…
Dielectric properties and partial discharge endurance of polypropylene-silica nanocomposite
2010
This paper presents the results of the dielectric properties and partial discharge endurance measurements conducted on polypropylene (PP)-silica nanocomposite. The material compounds were analyzed with micro-Raman spectroscopy, X-ray tomography and transmission electron microscopy (TEM). ac and dc breakdown strength of the materials was measured. Dielectric response, capacitance and loss factor of the film samples were measured as a function of temperature and frequency. Partial discharge (PD) endurance of the reference PP and PP Silica nanocomposite was studied as a function of ac voltage. Material surfaces were analyzed after PD stress with optical microscopy. All dielectric measurements …
Dielectric spectroscopy analysis of EVA-silicate nanocomposite insulating materials
2005
Nanocomposite materials show promising results for applications as electrical insulation. Among several materials presently under investigation, previous works indicate that polypropylene and ethylene-vinilacetate filled by nanosilicates present lower content of space charge and higher electric strength. However, efforts are needed to explain nanocomposite behaviour and characterize their electrical, thermal and mechanical properties. In this paper, the results of broad-band dielectric spectroscopy performed on ethylene-vinylacetate copolymer filled by layered micro and nanosized silicates are reported. The nanofillers consist of montmorillonite and fluorohectorite, that is, natural and syn…
Force Measurements on Myelin Basic Protein Adsorbed to Mica and Lipid Bilayer Surfaces Done with the Atomic Force Microscope
1999
The mechanical and adhesion properties of myelin basic protein (MBP) are important for its function, namely the compaction of the myelin sheath. To get more information about these properties we used atomic force microscopy to study tip-sample interaction of mica and mixed dioleoylphosphatidylserine (DOPS) (20%)/egg phosphatidylcholine (EPC) (80%) lipid bilayer surfaces in the absence and presence of bovine MBP. On mica or DOPS/EPC bilayers a short-range repulsive force (decay length 1.0-1.3 nm) was observed during the approach. The presence of MBP always led to an attractive force between tip and sample. When retracting the tip again, force curves on mica and on lipid layers were different…
Identification of binding peptides on calcium silicate hydrate: a novel view on cement additives.
2014
Cement is the most used industrial product in the world. Although the chemical composition of the material has stayed more or less the same since its discovery by the Romans around 2000 years ago, [ 1 ] the performance has been increased by chemical additives. Spectacular buildings like the Willis Tower in Chicago, Taipei 101 or lately the over 800 m high Burj Khalifa in Dubai were realizable thanks to the development of high performance building materials. [ 2 ] Not only for such prestige objects but also in daily building processes, the trend goes towards always higher buildings because of the continued urbanization which was identifi ed already in 1982 as one of the so-called “megatrends…