Search results for "simplified"
showing 10 items of 60 documents
Laboratory evaluation of falling-head infiltration for saturated soil hydraulic conductivity determination
2020
Falling-head one-dimensional infiltration procedures, such as the simplified falling-head (SFH) technique, yield estimates of saturated soil hydraulic conductivity, Ks, with parsimonious and rapid experiments. Factors that can influence determination of Ks by the SFH technique were tested in the laboratory on three repacked soils differing by particle diameter ranges (0-2000, 0- 105 and 105-2000 mm, respectively). Using the theoretically calculated depth of ponding on the infiltration surface, D, instead of the measured one had a small impact on the Ks calculations (means differing by a factor of 1.1-1.2, depending on the soil). For the finest soil, Ks decreased by 3.1 times as D increased …
A Plot-scale uncertainty analysis of saturated hydraulic conductivity of a clay soil
2021
Abstract Simulating soil hydrological processes at the plot or field scale requires using spatially representative values of the saturated soil hydraulic conductivity, Ks. Sampling campaigns should yield a reliable mean of Ks with a sustainable workload since measuring Ks at many points is challenging. Uncertainty analysis can be used to determine the lowest number of measurements that yield a mean Ks value with a specified accuracy level. Potential and limitations of this analysis were tested in this investigation for different extents of the sampled area and sampling densities. A clay soil was sampled intensively on two plots (plot area = 44 m2), two dates and using both small (0.15 m in …
A simplified method based on Beerkan infiltration run
2013
A simplified method based on Beerkan infiltration run (SBI) to determine field saturated soil hydraulic conductivity
Do ventilatory parameters influence outcome in patients with severe acute respiratory infection? Secondary analysis of an international, multicentre1…
2021
Purpose: To investigate the possible association between ventilatory settings on the first day of invasive mechanical ventilation (IMV) and mortality in patients admitted to the intensive care unit (ICU) with severe acute respiratory infection (SARI). Materials and methods: In this pre-planned sub-study of a prospective, multicentre observational study, 441 patients with SARI who received controlled IMV during the ICU stay were included in the analysis. Results: ICU and hospital mortality rates were 23.1 and 28.1%, respectively. In multivariable analysis, tidal volume and respiratory rate on the first day of IMV were not associated with an increased risk of death; however, higher driving pr…
How can droplet formation occur in endodontically treated teeth during bonding procedures?
2008
PURPOSE: The aim of this in vivo study was to clarify how blistering formation occurs along intraradicular dentin bonded interfaces. MATERIALS AND METHODS: Patients were selected and post space was prepared in vivo in endodontically treated teeth. Post space was etched, dried with ethanol, and bonded with one of the following adhesive systems: All Bond 2, XP-Bond, Clearfil SE Bond, Xeno III. The four adhesives were considered as representative of each bonding system class. An additional group was prepared with phosphoric acid treatment + application of Pre-Bond unfilled resin of All Bond 2, without the use of the primer agent. Etching was avoided for self-etching materials. Replicas of the …
Ring diameter effects on determination of field-saturated hydraulic conductivity of different loam soils
2017
Abstract Establishing ring diameter effects on the field-saturated soil hydraulic conductivity, Kfs, determined with ponding infiltrometer methods can help to find a compromise between the need to sample a large area with an individual measurement and the impracticality of using large rings in the field. Five ring sizes (diameter, D = 5.5, 10.9, 16.0, 27.8 and 31.8 cm) were used to determine Kfs by the simplified falling head (SFH) technique in four loamy soils with different salinity (electrical conductivity of saturated extract, ECe = 0.9–29.4 dS/m) and sodicity (exchangeable sodium percentage, ESP = 2.7–81.3%) levels. According to USDA classification, two soils were non-saline, non-sodic…
Comparison between complete and simplified methods for determining the microwave noise parameters of HEMTs
1994
Modem automatic noise parameter measuring systems are based on measurements of some values of F(rs ) for different values of IГs (more than four, for redundancy) realized by adjusting an admittance transformer (tuner) inserted between the noise source and the TUT mput . Such values are then manipulated by means of proper data processing techniques using eqn.( 1) [ 11. This measuring procedure is hereafter referred to as standard to point out that the old `Standards on methods of measuring noise in linear twoports´ published by the IRE Subcommittee on noise in 1960 is considered obsolete by all the experimenters.
A parsimonious dynamic model for river water quality assessment
2010
Water quality modelling is of crucial importance for the assessment of physical, chemical, and biological changes in water bodies. Mathematical approaches to water modelling have become more prevalent over recent years. Different model types ranging from detailed physical models to simplified conceptual models are available. Actually, a possible middle ground between detailed and simplified models may be parsimonious models that represent the simplest approach that fits the application. The appropriate modelling approach depends on the research goal as well as on data available for correct model application. When there is inadequate data, it is mandatory to focus on a simple river water qua…
Isoerosivity and erosion risk map for Sicily
1991
This paper reviews simplified methods for evaluating the rainfall erosivity index and proposes two relationships for estimating the annual value of Wischmeier's rainfall erosivity index at sites equipped with recording and non-recording raingauges. For the Sicilian region, the FAO index was also found to represent the erosion risk. A regional relationship to estimate the standard deviation of the annual erosivity index is proposed. The isoerosivity map is plotted by using 41 values of the rainfall erosivity index calculated by Wischmeier's procedure and 128 values estimated according to a relationship proposed by the authors. Finally, for each of 169 sites, an erosion risk index is calculat…
A field assessment of the Simplified Falling Head technique to measure the saturated soil hydraulic conductivity
2012
Abstract The Simplified Falling Head (SFH) technique to measure field saturated soil hydraulic conductivity, Kfs, has received little testing or comparison with other techniques. Different experiments were carried out to i) determine the effect of ring size on the measured conductivity; ii) compare the SFH and Pressure Infiltrometer (PI) techniques in a clay loam soil; and iii) evaluate the approach used in the SFH methodology to estimate the α* parameter. Sampling a relatively large number of sites allowed to detect statistically significant relationships between the Kfs values obtained with rings differing in diameter (0.15 and 0.30 m, respectively). The ring size effect was substantial (…