Search results for "spinel"
showing 10 items of 103 documents
Batch-to-Melt Conversion Kinetics in Sodium Aluminosilicate Batches Using Different Alumina Raw Materials
2016
The batch-to-melt conversion in batches of sand, soda ash and corundum (C), alumina spinel (A), boehmite (B), or gibbsite (G) as Al2O3 carrier are studied using thermal analysis, X-ray diffraction, and 27Al nuclear magnetic resonance spectroscopy. Laboratory-scaled batches are either heated continuously or quenched from 1600°C in a series of increasing dwell times. The results show that the conversion from the raw materials to the fresh melt proceeds in two kinetic stages. During the first stage (3–5 min), fast conversion of nearly 95% by mass occurs and the conversion coefficient increases in the order G < C ≈ A < B. The second stage is controlled by the slow dissolution of intermediate cr…
First principles simulations on migration paths of oxygen interstitials in magnesium aluminate spinel
2018
This study has been carried out within the framework of the EURO fusion Consortium and has been provided funding from the Euratom research and training program 2014–2018 under grant agreement No. 633053. The authors are indebted to A.I. Popov, A.C. Lushchik and R. Vila for stimulating discussions. Technical assistance from O. Lisovski is appreciated too. The views and opinions expressed herein do not necessarily reflect those of the European Commission. Calculations have been performed using Marconi supercomputer system based in Italy at CINECA Supercomputing Centre.
Gel combustion synthesis and magnetic properties of CoFe2O4, ZnFe2O4, and MgFe2O4 using 6-aminohexanoic acid as a new fuel
2020
Abstract For the first time, 6-aminohexanoic acid is used as an alternative fuel in the synthesis of the spinel ferrites with compositions CoFe2O4, ZnFe2O4 and MgFe2O4 using gel combustion synthesis with different oxidizer-to-fuel (O/F) ratios. The gel precursors were studied by differential thermal analysis and thermogravimetry (DTA/TG), which showed that the ignition temperature depends on the gel precursor, being around 230 °C, 130 °C and 275 °C for CoFe2O4, ZnFe2O4, and MgFe2O4, respectively. These results showed than the 6-aminohexanoic acid has an ignition temperature lower than the urea and the citric acid when were used in the synthesis of the spinel ferrites by gel combustion. More…
Luminescence characteristics of magnesium aluminate spinel crystals of different stoichiometry
2019
We are grateful to Drs E. Vasil’chenko and A. Maaroos for the help with experiments and useful discussions. This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the Euratom research and training programme 2014-2018 under grant agreement No 633053. The views and opinions expressed herein do not necessarily reflect those of the European Commission. In addition, the research leading to these results has received funding from the Estonian Research Council Institutional Research Funding IUT02-26.
Melt inclusions track melt evolution and degassing of Etnean magmas in the last 15 ka
2019
We present major elements compositions and volatiles contents of olivine-hosted melt inclusions from Etna volcano (Italy), which extend the existing database with the aim of interpreting the chemical variability of Etnean magmas over the last 15 ka. Olivine phenocrysts were selected from the most primitive Fall Stratified (FS) eruptive products of picritic composition (Mg# = 67–70, Fo 89–91 ), the Mt. Spagnolo eccentric lavas (Mg# = 52–64, Fo 82–88 ) and among the more recent 2002–2013 eruptive products (Mg# = 33–53, Fo 68–83 ). Crystal fractionation and degassing processes were modeled at temperatures of 1050–1300 °C, pressures <500 MPa, and oxygen fugacity between 1 and 2 log units abo…
Crystal structure of sinhalite MgAlBO4 under high pressure
2015
We report on high-pressure angle-dispersive X-ray diffraction data up to 27 GPa for natural MgAlBO4 sinhalite mineral and ab initio total energy calculations. The experimental bulk modulus of sinhalite is B-0 = 171(3) GPa with a first-pressure derivative of B-0' = 4.2(3). A comparison with other olivine-type compounds shows that the value for B0 is 27% larger than that of Mg2SiO4 forsterite and 29% smaller than that of Al2BeO4 chrysoberyl. These differences are interpreted, on the basis of our ab initio calculations, in terms of the relative incompressibility of Al-O bonds in AlO6 octahedra (with a calculated bulk modulus of 250(1) GPa) as compared to Mg-O bonds in MgO6 octahedra (with a ca…
Effect of NiO and/or TiO2 mullite formation and microstructure from gels
1998
Polymeric and colloidal gels with a constant molar ratio of (Al+Ni and/or Ti)/Si=3/1 and various (Al/Ni and/or Ti) ratios (up to 21.42 mol% NiO+TiO2) were prepared and used to study the effect of the precursor chemical homogeneity on mullite formation processes and the resulting microstructure. Both kinds of gel precursors were preheated at 750°C for 3 h in order to obtain appropriate gel-derived glasses for further thermal processing. After annealing for several time periods at temperatures between 750 and 1500°C, differences in crystallization pathways were observed. Polymeric gels crystallized Al–Si and NiAl2O4 spinels from the amorphous form at temperatures in the range between 900 and …
Hydrothermal synthesis of nanostructured inorganic powders by a continuous process under supercritical conditions
2005
Abstract In this study, using a prototype of hydrothermal synthesis in subcritical and supercritical water working in a continuous way, nanometric ceramic precursors with perfectly defined composition are produced: spinel ferrites such as Fe2CoO4, TiO2 with anatase structure and also perovskite structures such as BaZrO3. The as-prepared powders are fully characterized by complementary experiments: X-ray diffraction, electron microscopies, EDX spectrometry, surface area measurement, etc. Thus, particles size, morphology, aggregation state, crystal structure, composition are investigated. Moreover, magnetic properties of the ferrites products are studied. The powders obtained are pure phases …
Overview of the magnetic properties experiments on the Mars Explorations Rovers
2009
[1] The Mars Exploration Rovers have accumulated airborne dust on different types of permanent magnets. Images of these magnets document the dynamics of dust capture and removal over time. The strongly magnetic subset of airborne dust appears dark brown to black in Panoramic Camera (Pancam) images, while the weakly magnetic one is bright red. Images returned by the Microscopic Imager reveal the formation of magnetic chains diagnostic of magnetite-rich grains with substantial magnetization (>8 Am2 kg−1). On the basis of Mossbauer spectra the dust contains magnetite, olivine, pyroxene, and nanophase oxides in varying proportions, depending on wind regime and landing site. The dust contains a …
Influence of preoxidation on the corrosion of steels in liquid lead-bismuth eutectic
2004
Abstract Oxidation studies of martensitic/ferritic and austenitic steels have been conducted in static lead bismuth eutectic (LBE). Samples were preoxidized in an air/H2O gas mixture prior to immersion in LBE. Preoxidation films grown on HT-9 at 800°C for 48 h had a bilayer structure, an outer Fe-rich layer, and an inner Cr-rich layer. Glancing angle x-ray diffraction data found that two distinct structures were present in this oxide: Fe1+xCr2−xO4 spinel (cubic, face-centered cubic [fcc]) and (Cr,Fe)2O3 (rhombohedral, corundum). Magnetite formation (Fe3O4) was ruled out. Immersion in LBE resulted in the growth of an Fe-rich film on top of the preoxidation layer. It was concluded that the gr…