Search results for "splitting"

Influence of Co content on structural and magnetic properties of CoxFe84−xNb7B9 alloys

2003

Nanocrystallization of CoxFe84� xNb7B9 (x ¼ 17; 25, 33) alloys has been studied. Crystallization of specimens starts above 4501C. After annealing of specimens in the range 500–7001C, apart from amorphous component and BCC Fe-Co alloy, a non-magnetic component also appears, which is attributed to (Fe1� xCox)2Nb phase with a relative area of about 14%. Decrease of quadrupole splitting with annealing temperature indicates some possible ordering of the nonmagnetic phase. r 2002 Elsevier Science B.V. All rights reserved.

Cathodoluminescence characterization of ZnO/ZnS nanostructures anodized under hydrodynamic conditions

2018

[EN] ZnO/ZnS nanostructures were successfully synthesized by a simple electrochemical anodization of zinc in a glycerol based electrolyte containing sulfide-ammonium fluoride. The influence of different hydrodynamic conditions and anodization potentials during anodization on the morphological and electronic properties of the obtained ZnO/ZnS nanostructures was studied. The anodized samples were characterized using confocal Raman microscopy, X-Ray Diffraction (XRD), Field Emission Scanning Electronic Microscopy (FE-SEM), cathodoluminescence (CL), and photoelectrochemical water splitting tests under standard AM 1.5 conditions. The results showed that hydrodynamic conditions and higher potenti…

Solution-processed Nickel Oxide electrocatalyst for Electrochemical Water Splitting

2020

Correlating the axial Zero Field Splitting with the slow magnetic relaxation in GdIII SIMs

2021

The field-induced out-of-phase magnetic response of a GdIII complex, selected by its good isolation in the network, has been analyzed and the behaviour of this quasi-isotropic cation has been related to its weak axial zero field splitting ∼0.1 cm-1.

Heat-capacity anomaly due to spin reorientation and thermodynamic functions of ErFeO3 and TmFeO3

2001

Abstract Heat capacities of orthoferrites, ErFeO 3 and TmFeO 3 , have been measured below room temperature by adiabatic calorimetry. A broad but definite anomaly due to the spin reorientation phenomenon was successfully detected in the expected temperature range (ca. 90 K). The results are compared with a vast anomaly reported for YbFeO 3 . The temperature dependence of the electric quadrupole splitting of the Fe nuclear levels was determined by Mossbauer spectroscopy through the spin reorientation. A heat capacity anomaly centered at 3.60 K due to the magnetic ordering of Er 3+ ions was clearly detected. Some Schottky anomalies were resolved and energy splittings involved were roughly esti…

EPR Study of Gd3+local structure in ScF3crystal with negative thermal expansion coefficient

2015

Zero field splitting (ZFS) of Gd3+ impurity in ScF3 is studied by electron paramagnetic resonance at 77 and 295 K. ZFS parameter b4 values obtained from angular dependence simulations show that regardless of negative thermal expansion in ScF3 temperature dependence of |b4| is similar to other cubic fluoroperovskites. Our analysis of ZFS parameters indicates that the local structure of Gd3+ centres expands positively with temperature.

Synthesis of Multifunctional Inorganic Materials

2018

Abstract Both, novel and older widely and routinely used methods of chemical synthesis fornew multifunctional inorganic (nano) materials with different sizes and morphologies are reviewed and summarized in this chapter. Illustrative examples of micro- and nanoparticle preparations are provided regarding different applications: renewable and sustainable energy harvesting, water splitting and hydrogen generation, fuel and solar cell devices, luminescent materials for white light–emitting diodes and clean environment. We give our perspective on the current status of the topic: methods of colloidal chemistry, coprecipitation, reverse-micelle technique, sol–gel, spray pyrolysis, microwave-assist…

Enhancement of calcium copper titanium oxide photoelectrochemical performance using boron nitride nanosheets

2020

International audience; Photoelectrochemical water splitting under visible light has attracted attention for renewable hydrogen production. Despite prevalent investigations, many challenges still hindered an efficient energy conversion, such as enhancing the reaction efficiency in visible light. Thus controlling the photoelectrode materials is an essential step in designing new materials for water splitting. CaCu3Ti4O12 (CCTO) has received great attention as photocatalyst under solar light due to its combined band gap as result of the presence in its structure of TiO2 active in UV light and CuO active under visible light. In this work, a cubic CCTO with different amount of exfoliated hexago…

C-, N-, S-, and Fe-Doped TiO2 and SrTiO3 Nanotubes for Visible-Light-Driven Photocatalytic Water Splitting: Prediction from First Principles

2015

The ground state electronic structure and the formation energies of both TiO2 and SrTiO3 nanotubes (NTs) containing CO, NO, SO, and FeTi substitutional impurities are studied using first-principles calculations. We observe that N and S dopants in TiO2 NTs lead to an enhancement of their visible-light-driven photocatalytic response, thereby increasing their ability to split H2O molecules. The differences between the highest occupied and lowest unoccupied impurity levels inside the band gap (HOIL and LUIL, respectively) are reduced in these defective nanotubes down to 2.4 and 2.5 eV for N and S doping, respectively. The band gap of an NO+SO codoped titania nanotube is narrowed down to 2.2 eV …

Yttrium-doped hematite photoanodes for solar water splitting: Photoelectrochemical and electronic properties

2018

Abstract We investigate yttrium-doped hematite thin-film photoelectrochemical properties and find yttrium incorporation to amply improve the performance as a photoanode for water splitting under visible light. We used the spray pyrolysis method to prepare a set of yttrium doped Fe2-xYxO3 (x = 0, 0.05, 0.10, 0.15, 0.2) thin films (thickness below 500 nm) on glass and transparent conductive oxide coated glass slides. Using a substitutional homovalent (Y3+) dopant, the effect on functionality is rationalised as a combined effect on the electronic structure and small polaron mobility from the lattice structure, impurity levels, lattice stability and variance in hybridisation. The photoelectroch…