Search results for "temperature measurement."
showing 10 items of 120 documents
Emissivity measurements of several soils and vegetation types in the 8–14, μm Wave band: Analysis of two field methods
1997
Abstract The two variants of the box method (with one and two lids) has been rigorously analyzed. As a result of this analysis, a correction factor that takes into account the nonideality of the materials used for the box, as well as its geometry, has been derived A simple method for determining the effective downward atmospheric temperature that uses only the temperature measurement at the zenith also has been proposed. Finally, by using one of the two variants of the box method, 72 in situ emissivity measurements in the 8–14 pin wave-band region of typical vegetation, soils, and rocks of Europe and South America, has been obtained. The use of these data for the ernissivity correction of s…
Study of Temperature Heterogeneities at Sub-Kilometric Scales and Influence on Surface–Atmosphere Energy Interactions
2019
The retrieval of land surface temperature (LST) from remote sensing techniques has been studied and validated during the past 40 years, leading to important improvements. Accurate LST values are currently obtained through measurements using medium resolution thermal infrared (TIR) sensors. However, the most recent review reports demonstrated that the future TIR LST products need to obtain reliable temperature values at a high spatial resolution (100 m or higher) to study temperature variations between different elements in a heterogeneous kilometric area. The launch of high-resolution TIR sensors in the near future requires studies of the temporal evolution and spatial heterogeneities of th…
A qualitative examination of performance and energy yield of photovoltaic modules in southern Norway
2010
Three different, commercially available photovoltaic modules have been monitored outdoors in the town of Grimstad, Norway. The present paper describes the experimental setup that was implemented, in particular details of the low-cost electronic loads. Results compare measured performance with manufacturer's data, and temperature measurements enable a comparison with performance at standard test condition temperature. Overall, the monocrystalline module performed best both regarding maximum efficiency and overall energy production, whereas the module based on triple junction amorphous silicon technology had the worst performance considering these criteria. The gross numbers of energy yield c…
Development of a test station for accurate in situ I-V curve measurements of photovoltaic modules in Southern Norway
2011
The development of an outdoor test station for accurate in situ I-V curve measurements of photovoltaic (PV) modules is described. The modules are installed in an open-rack configuration at the University of Agder in Southern Norway. Seven new and three aged PV modules of different type and make are being tested, including mono-and multicrystalline silicon from differing manufacturing routes, triple-junction amorphous silicon, and CIS. Data acquisition is controlled with a multichannel electronic load system and LabVIEW software, recording high-resolution I-V curves at one-minute intervals. Between I-V curve sweeps, each module is operated at the maximum power point. Characteristic electrica…
Surface temperature in the context of FLuorescence EXplorer (FLEX) mission
2007
It has been demonstrated that the spectrum of fluorescence emission is dependent on leaf temperature, thus there is a need for thermal information in order to interpret fluorescence signals. Temperature is also related to transpiration and stomata closure, which affects CO2 uptake and fluorescence. Therefore temperature measurements help to confirm the trends observed in fluorescence measurements. While fluorescence is immediately and uniquely related to photosynthesis, temperature provides additional information about plant status and instantaneous energy/water fluxes between plants and the atmosphere. The objective of this paper is to demonstrate the role of surface temperature in the con…
CARS spectroscopy of CH4 for implication of temperature measurements in supercritical LOX/CH4 combustion
2007
International audience; Experimental and theoretical investigations of coherent anti-Stokes Raman spectroscopy of CH4 have been carried out. Experimental spectra were measured in a heated high-pressure test cell and compared with numerical simulations. Good agreement was obtained for the temperature and the pressure dependence of CARS spectra in the ranges 300-1100 K and 0.1-5.0 MPa. The observed dependencies provide useful guidance for CARS thermometry, allowing quantitative measurements of temperature in high-pressure combustors. Application of multiplex CH4 CARS thermometry for single-shot measurements in a LOX/CH4 combustion at high pressure was demonstrated at supercritical conditions …
Temperature measurement in gas mixtures by femtosecond Raman-induced polarization spectroscopy
2003
The potential of femtosecond Raman-induced polarization spectroscopy (RIPS) for the simultaneous determination of temperature and concentrations was investigated. These measurements were related to the rotational time response of the molecular gas mixture, which was measured as a function of the pump-probe time delay. The change of the polarizability anisotropy with respect to the vibrational levels was taken into account. The results of temperature measurements in pure CO2 showed good agreement with the values obtained by a thermocouple. The RIPS technique was also applied to a CO2-N2 gas mixture to determine simultaneously temperatures and concentrations at temperatures up to 600 K. The a…
Temperature imaging and image processing in the steel industry
1996
Our aim is twofold: to present our temperature measurement system based on CCD technology, which gives a linear response versus temperature, and to display two industrial applications in which our system has been involved to optimize and characterize the process. We present a short summary dealing with temperature evaluations from radiation measurements. We consider especially the problems of the surroundings, the atmosphere, and the emissivity assumption. After selecting a value for the emissivity, we show that the use of the CCD technology enables us to obtain high spatial and temporal resolution temperature imaging, and provides further information, mainly a linear response versus temper…
Riming of Graupel: Wind Tunnel Investigations of Collection Kernels and Growth Regimes
2009
Abstract Laboratory experiments were carried out in the vertical wind tunnel in Mainz, Germany, to study the collision coalescence growth of single spherical ice particles having initial radii between 290 and 380 μm while they were freely floated in a laminar flow containing a cloud of supercooled droplets with radii between 10 and 20 μm. The experiments were performed in a temperature range between −8 and −12°C, where riming proceeds in the atmosphere, and with cloud liquid water contents lying between 0.9 and 1.6 g m−3 (i.e., values typically found in mixed-phase clouds). The collection kernels were calculated from the mass increase of the rimed ice particles and the average liquid water …
A Measurement System for Power Inductors in Non-Linear Operating Conditions
2021
The exploitation of power inductors in switching converters outside the linear region requires detailed information on the magnetization curve that often is not included among those usually available on their datasheets. This paper proposes an automatic system in which the inductor is characterized in real operating conditions taking into account also the core temperature. It is based on a switching converter suitably controlled by a virtual instrument. The system was tested by retrieving the inductance vs current curves of two commercial inductors for core temperatures up to 105°C, showing the different behaviors of the magnetization curves. Results are coherent with data given by manufact…