Search results for "thermogravimetric analysis"
showing 10 items of 212 documents
Modeling of the catalytic effects of potassium and calcium on spruce wood gasification in CO2
2016
Abstract Using previously reported thermogravimetric analysis measurements, the effects of calcium and potassium on the char gasification rate of spruce wood were modeled. Spruce wood was leached of inorganic ash elements and doped with measured amounts of potassium and calcium. The wood was gasified in an isothermal thermogravimetric analysis device in CO 2 where the devolatilization of the wood, char formation and char gasification all occurred inside the preheated reactor. A new method for separating the effects of devolatilization and char gasification is presented. Kinetic models were evaluated for their ability to describe the observed catalytic effects of potassium and calcium on the…
Synthesis and mesomorphism of related series of triphilic ionic liquid crystals based on 1,2,4-triazolium cations
2021
Abstract The synthesis, liquid crystal and conductivity properties of a series of 27 salts based on the 5-(4-(alkyloxy)phenyl)-1,2,4-triazol-4-ium cation bearing a perfluoroalkyl chain with triflate, tetrafluoroborate and bistriflimide anion are reported. The cations are regarded as triphilic on account of their three distinct regions – hydrocarbon, fluorocarbon and ionic. The mesophases were characterised by a combination of polarised optical microscopy, calorimetry and small-angle scattering experiments using both X-rays and neutrons, while thermal stability was probed using thermogravimetric analysis. The liquid crystal properties are found to be dependent on the anion and the length of …
Evaluation of wood-polyethylene composites biodegradability caused by filamentous fungi
2017
Abstract This study describes the impact of filamentous fungi on wood-polymer composites (WPCs) containing various types of fillers (coniferous, deciduous, cellulose) in the amount of 30 wt.% to 50 wt.%. The selection of fungal strain of filamentous fungi was performed prior to the study on the impact of the wood type on the progress of WPCs biodegradability. The changes associated with various water absorption of the examined WPCs, were observed using scanning electron microscopy (SEM). The impact of fungal mycelium, which had affected the changes in WPCs material, was examined using thermogravimetric analysis (TG). The results showed, that the growth of mycelium on WPCs, influenced mainly…
Rapid synthesis of tin (IV) oxide nanoparticles by microwave induced thermohydrolysis
2008
Abstract Tin oxide nanopowders, with an average size of 5 nm, were prepared by microwave flash synthesis. Flash synthesis was performed in aqueous solutions of tin tetrachloride and hydrochloric acid using a microwave autoclave (RAMO system) specially designed by the authors. Energy dispersive X-ray analysis (EDX), X-ray powder diffraction (XRD), Brunauer–Emmett–Teller (BET) surface area analysis, nitrogen adsorption isotherm analysis, differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), Fourier transform infrared (FTIR) spectroscopy, and transmission electron microscopy (TEM), were used to characterize these nanoparticles. Compared with conventional synthesis, nanopow…
Pyrolysis study of sol-gel derived TiO2powders
2004
An amorphous TiO2 gel was obtained by hydrolysing titanium(IV) isopropoxide with a stoichiometric amount of water using SnCl2 as catalyst. In these operative conditions, a TiO2 gel matrix containing a lower fraction of organic residual was obtained with respect to samples prepared by previously modifying the titanium alkoxide precursor with chelating ligands. Dried gel powders were characterized by N2 adsorption analyses, FT-IR and XRD measurements. Thermogravimetric (TG) and differential thermal analysis (DTA) coupled with mass spectrometric (MS) and gas chromatographic (GC) measurements were performed in order to identify the organic products released from TiO2 gel pyrolysis. The Tg-MS se…
Influence of the Preparation Temperature on the Photocatalytic Activity of 3D-Ordered Macroporous Anatase Formed with an Opal Polymer Template
2018
Even if many aspects of three-dimensionally ordered macroporous (3DOM) titania have been extensively studied, the interplay between the amorphous and crystalline components of their skeleton wall has not attracted too much attention, although it should strongly influence the properties of these materials. In order to gain new insight on this interplay, we have studied in detail the wall structure of three 3DOM titania samples prepared by heating the 3DOM titania precursor at 673, 773, and 873 K by X-ray diffraction, thermogravimetric analysis, differential thermal analysis, N2 adsorption/desorption, pore-size distribution, high-resolution transmission electron microscopy, and IHmagic-angle-…
Extraction–Pyrolytic Method for TiO2 Polymorphs Production
2021
The authors thank V. Kuzovkov, A. Lushchik and M. Lushchik for many useful discussions. The research was (partly) performed in the Institute of Solid State Physics, University of Latvia ISSP UL. ISSP UL as the Center of Excellence is supported through the Framework Program for European universities Union Horizon 2020, H2020-WIDESPREAD-01–2016–2017-TeamingPhase2 under Grant Agreement No. 739508, CAMART2 project.
PMMA-titania nanocomposites: Properties and thermal degradation behavior
2012
Titania nanoparticles were prepared using a solegel method and calcination at 200 and 600 � C in order to obtain anatase and rutile phases, respectively. The obtained powders were used to prepare PMMAe titania nanocomposites by a melt compounding method. The effect of the crystalline phase and the amount of titania, in the range 1e5 wt.%, on the morphology, mechanical properties and thermal degradation kinetics of PMMA was investigated by means of X-ray diffractometry (XRD), transmission electron microscopy (TEM), 13 C cross-polarization magic-angle spinning nuclear magnetic resonance spectroscopy ( 13 C{ 1 H}CP-MAS NMR), including the measurement of proton spinelattice relaxation time in t…
POSS-tetraalkylammonium salts: A new class of ionic liquids
2012
A series of new polyhedral oligomeric silsesquioxane ionic liquids (POSS-ILs) based on the trimethylpropylammonium dielectric constants, which, conversely, display slight differences originating from the nature of the anions. The long alkyl-chain substituents on the POSS core infer on this series of ILs an overall hydrophobic character and solution properties comparable to those of classic cationic surfactants, resulting in an effective extractant capability of polyanions from aqueous solutions. Their solution diffusion properties, as investigated by room-temperature dynamic light scattering, solution conductivity, density, and osmometric measurements, do not provide evidence for the occurr…
Tungstophosphoric acid supported on polycrystalline TiO2 for the photodegradation of 4-nitrophenol in aqueous solution and propan-2-ol in vapour phase
2009
Abstract The present work reports the preparation of samples based on Millennium PC-500 TiO 2 loaded with different amounts of tungstophosphoric acid (up to 30% in weight) and their characterisation by means of different physicochemical techniques: powder X-ray diffraction, N 2 adsorption–desorption at −196 °C, transmission electron microscopy, UV–vis and FT-IR spectroscopies and thermogravimetric analyses. The acidity of samples was evaluated by FT-IR using pyridine as probe molecule, and the catalysts activity was tested for the photodegradation of 4-nitrophenol in aqueous solution and for the photo-oxidation of propan-2-ol in vapour phase. The results show a noticeable improvement (8 and…