Search results for "transfer function"

Identification and Robust Control of a Quadratic DC/DC Boost Converter by Hammerstein Model

2015

This paper deals with the theoretical framework definition and the experimental application of the Hammerstein (HM) identification and related robust control technique to a quadratic dc/dc single-switch boost (Q-boost) converter. A set of fourth-order transfer functions (TFs) has been identified with the Hammerstein approach, on the basis of a pseudorandom-binary-sequence (PRBS) excitation signal. The set of identified TFs has been then used to design a suitable robust control technique, able to properly deal with the converter parameter uncertainty and load variations. The proposed approach has been tested in numerical simulation and validated experimentally on a suitably developed test se…

A new Frequency Domain Measure of Causality based on Partial Spectral Decomposition of Autoregressive Processes and its Application to Cardiovascular…

2019

We present a new method to quantify in the frequency domain the strength of directed interactions between linear stochastic processes. This issue is traditionally addressed by the directed coherence (DC), a popular causality measure derived from the spectral representation of vector autoregressive (AR) processes. Here, to overcome intrinsic limitations of the DC when it needs to be objectively quantified within specific frequency bands, we propose an approach based on spectral decomposition, which allows to isolate oscillatory components related to the pole representation of the vector AR process in the Z-domain. Relating the causal and non-causal power content of these components we obtain…

Design of Measurement-Based Stochastic Wideband MIMO Channel Simulators

2009

In this paper, we propose a method for designing measurement-based stochastic models for simulating wideband multiple-input multiple-output (MIMO) wireless channels. The proposed method allows synthesizing channel transfer functions with the spatial-temporal-frequency correlation properties approximating those of real-world radio channels. The parameters of a channel simulator are determined by fitting the space-timefrequency cross-correlation matrix of the simulation model to the estimated space-time-frequency cross-correlation matrix of a physical channel. For this purpose, an iterative parameter computation algorithm has been developed. The proposed design method is verified by creating …

Discussion of “Soil Water Retention Characteristics of Vertisols and Pedotransfer Functions Based on Nearest Neighbor and Neural Networks Approaches …

2013

Synthetic individual binaural audio delivery by pinna image processing

2014

Purpose – The purpose of this paper is to present a system for customized binaural audio delivery based on the extraction of relevant features from a 2-D representation of the listener’s pinna. Design/methodology/approach – The most significant pinna contours are extracted by means of multi-flash imaging, and they provide values for the parameters of a structural head-related transfer function (HRTF) model. The HRTF model spatializes a given sound file according to the listener’s head orientation, tracked by sensor-equipped headphones, with respect to the virtual sound source. Findings – A preliminary localization test shows that the model is able to statically render the elevation of a vi…

Monitoring soil volume wetness in heterogeneous soils by electrical resistivity. A field-based pedotransfer function.: A field-based pedotransfer fun…

2014

11 pages; International audience; Modern irrigation techniques require accurate, rapid, cost-effective, spatial measurement of soil moisture. Electrical Resistivity Tomography (ERT) meets most of these requirements, but needs to be calibrated for each use because it is very sensitive to differences in soil characteristics. In this study, a pedotransfer function approach is used to remove the need for site-specific calibration, allowing ERT to be used directly to measure soil moisture. The study site was a hillslope vineyard, where eight calcaric-cambisol soil profiles were identified. From 2012 to 2013, 23 000 soil volume wetness measurements were acquired by Time Domain Reflectometry, and …

Using a transient infiltrometric technique for intensively sampling field-saturated hydraulic conductivity of a clay soil in two runoff plots

2012

The point measurement of soil properties allows to explain and simulate plot scale hydrological processes. An intensive sampling was carried out at the surface of an unsaturated clay soil to measure, on two adjacent plots of 4 × 11 m2 and two different dates (May 2007 and February–March 2008), dry soil bulk density, ρb, and antecedent soil water content, θi, at 88 points. Field-saturated soil hydraulic conductivity, Kfs, was also measured at 176 points by the transient Simplified Falling Head technique to determine the soil water permeability characteristics at the beginning of a possible rainfall event yielding measurable runoff. The ρb values did not differ significantly between the two d…

Using Static and Dynamic Indicators to Evaluate Soil Physical Quality in a Sicilian Area

2013

Both capacitive indicators derived from the water retention curve and dynamic measurements of the flow-weighted mean pore radius, R0, were used to assess the soil physical quality of two agricultural areas (cropland and olive orchard) and two natural areas (grassland and managed woodlot plantation) potentially subject to soil degradation. The overall idea of the study was to investigate whether a dynamic indicator quantitatively derived from hydraulic conductivity measurements could be used to supplement the traditionally applied capacitive indicators retrieved from water retention measurements. According to the available criteria, only the surface layer of the cropland site showed optimal …

Modeling soil cation exchange capacity in multiple countries

2017

Abstract Cation exchange capacity (CEC), as an important indicator for soil quality, represents soil's ability to hold positively charged ions. We attempted to predict CEC using different statistical methods including monotone analysis of variance (MONANOVA), artificial neural networks (ANNs), principal components regressions (PCR), and particle swarm optimization (PSO) in order to compare the utility of these approaches and identify the best predictor. We analyzed 170 soil samples from four different nations (USA, Spain, Iran and Iraq) under three land uses (agriculture, pasture, and forest). Seventy percent of the samples (120 samples) were selected as the calibration set and the remainin…

Comparison of aggregate stability indices for soil classification and assessment of soil management practices

1989

Summary In view of soil structure analysis and land-use and management history evaluation, several mechanical indices of soil structure were tested on 13 Italian soils. From the wet and dry sieving aggregate distributions, a pseudo-textural aggregation index (Ipta) and a mechanical aggregation index (Ima)) were determined and compared with other soil structure stability indices based on single-sieve analysis. The single-sieve indices S and WSI were good correlated with Ipta and Ima, showing the possibility of substituting the time-consuming aggregate-size distribution determinations. All the soil structure indices were correlated with selected semi-permanent soil characteristics. Soil struc…