Search results for "volumetric"

Airborne birch pollen in Poland and Latvia in the light of data obtained from aerobiological monitoring and tauber traps in relation to mean air temp…

2012

Birch pollen contains allergens belonging to those with the strongest allergenic properties. In order to trace pollen season patterns of this taxon and pollen annual sums at a wider regional scale, cooperation was established with the University of Latvia in Riga (Latvia). A comparison of the results obtained in the years 2003-2008 in Lublin and in Riga, using volumetric samplers, shows that there was a similar trend in the abundance of birch pollen. The highest sums were noted at both sites in 2003. In all the study years, more birch pollen grains were recorded in Lublin than in Riga, on the average by 7110. The birch pollen seasons started earlier in Lublin than in Riga, on the average by…

Cadmium and Copper Removal by a Granular Activated Carbon in Laboratory Column Systems

2000

Single and competitive removal of Cd and Cu from aqueous solutions by using Darco 12–20 mesh granular activated carbon in column systems has been investigated. Seven experiments modifying the initial pH and the flow rate were performed. Results showed the efficiency of activated carbon as a sorbent for both metals. pH is shown to be the decisive parameter on metal removal in the column; metal removal increases when the influent pH value is raised. The influence of the flow rate for the experimental conditions is negligible. Batch adsorption and column data are compared. Column modeling assuming local equilibrium and rate-controlled pore diffusion was performed.

Adaptive PI Control of Bottom Hole Pressure during Oil Well Drilling

2018

Abstract In this paper, we studied the bottom hole pressure (BHP) control in an oil well during drilling. Today marginal wells with narrow pressure windows are frequently being drilled. This requires accurate and precise control to balance the bottom hole pressure between the pore and fracture pressure of the reservoir. This paper presents three control schemes to stabilize the BHP prole, including proportional-integral(PI) control, PI with feed-forward control and adaptive PI with feed-forward control. The proposed schemes are carried out through simulations on a high-fidelity hydraulic drilling simulator for flow rate changes and BHP set-point changes. In fast set-point changes and flow r…

Inner shell ionization of argon in ECRIS plasma

2018

Abstract The volumetric K α emission rate of argon emitted from the electron cyclotron resonance (ECR) heated plasmas of the JYFL (University of Jyvaskyla, Department of Physics) 14 GHz ECR ion source (ECRIS) and the 14.5 GHz Grenoble Test Source (GTS) at iThemba Laboratory for Accelerator Based Sciences have been measured to gain an understanding of the influence of the ion source tune parameters on the absolute inner shell ionization rate. It was observed that the behaviour of the ionization rate and the extracted ion beam currents react differently, depending the parametric sweep performed. The neutral gas pressure and incident microwave power was found to have the strongest influence on…

Dosimetric effect of respiratory motion on planned dose in whole-breast volumetric modulated arc therapy using moderate and ultra-hypofractionation.

2021

Abstract Background and purpose The interplay effect of respiratory motion on the planned dose in free-breathing right-sided whole-breast irradiation (WBI) were studied by simulating hypofractionated VMAT treatment courses. Materials and methods Ten patients with phase-triggered 4D-CT images were included in the study. VMAT plans targeting the right breast were created retrospectively with moderately hypofractionated (40.05 Gy in 15 fractions of 2.67 Gy) and ultra-hypofractionated (26 Gy 5 fractions of 5.2 Gy) schemes. 3D-CRT plans were generated as a reference. All plans were divided into respiratory phase-specific plans and calculated in the corresponding phase images. Fraction-specific d…

Dobór metody oceny czystości mikrobiologicznej powietrza w zakładach przemysłu spożywczego

2016

Source shape and data analysis procedure effects on hydraulic conductivity of a sandy-loam soil determined by ponding infiltration runs

2017

Performing ponding infiltration runs with non-circular sources could represent a good means to sample completely an area of interest. Regardless of the shape of the source, predicting the expected reliability of the collected data by infiltrometers should facilitate soil hydraulic characterisation and also allow a more conscious use of the field data. The influence of the shape of the infiltration source (i.e., circular or square) and the analysis procedure of the steady-state infiltration data on the saturated hydraulic conductivity, Ks, of a sandy-loam soil was tested in this investigation. Circular and square surfaces sampled with the pressure infiltrometer (PI) yielded similar estimates…

THE EXPLORED ARCHITECTURE. THE VIRTUAL MODEL OF A HISTORICAL STRATIFICATION

2010

The present study deepens -through documents of historical iconography and critical studies on morphological, geometrical and structural aspects- spatial and volumetric relationships between the medieval Torre Pisana of Palazzo Reale to Palermo (also known as Palazzo dei Normanni) and the Astronomical Observatory, site on the summit of the tower. A brief historical and architectural description of the evolution of the tightly correlated structure to the historical-cultural vicissitudes, to the advancement of the scientific theories and to the innovation of the tools of observation and of survey, is a deepening of knowledge for the conservation and safeguard of the architectural testimony. T…

Numerical and experimental MHD studies of Lead-Lithium liquid metal flows in multichannel test-section at high magnetic fields

2018

Abstract Numerical simulation and experiments have been performed at high magnetic fields (1–3T) to study the MHD assisted molten Lead-Lithium (PbLi) flow in a model test-section which has typical features of multiple parallel channel flows as foreseen in various blanket module of ITER. The characteristics Hartmann number of the presented case study is up to 1557 which is relevant to typical fusion blanket conditions. Symbols B0, a, σ, μ in the definition of Hartmann number are strength of the applied magnetic field, characteristic length scale which is half the channel width parallel to the magnetic field, electrical conductivity and dynamic viscosity of PbLi respectively. Flow distributio…

Origin and correction of the deviations in retention times at increasing flow rate with Chromolith columns.

2010

Chromoliths can be used at flow rates beyond those feasible for conventional microparticulate packed columns. Ideally, the plots of the retention time versus the inverse of delivered flow rate should exhibit y-intercept of zero. However, significant positive deviations correlating with the solute polarity were observed for several compounds chromatographed with a Chromolith column, owing to the increased system pressure. Consequently, the dead time marker exhibits a smaller deviation, making the retention factors depend on the flow rate. Chromoliths are made of a silica-based monolith encapsulated within a PEEK tube, and should suffer larger stress with pressure than stainless steel columns…