Search results for "volumetric"

Cover Picture: Direct Metal‐Free Chemical Vapor Deposition of Graphene Films on Insulating Substrates for Micro‐Supercapacitors with High Volumetric …

2019

Effective recovery of perfluoropolyether surfactants from PVDF and PTFE by supercritical carbon dioxide extraction

2007

Abstract The extraction of ammonium carboxylate perfluoropolyether surfactants from poly(vinylidenefluoride) (PVDF) and poly(tetrafluoroethylene) (PTFE) was performed with supercritical carbon dioxide. When proper conditions in terms of temperature, pressure and flow rate were used, extraction recoveries higher than 90% were obtained. For PVDF (with a concentration of surfactant of 5% w/w), at low pressure (12 MPa) and 40 °C, more than 100 min are necessary to have a quantitative extraction. On the other hand, at higher pressure (20 MPa) a quantitative recovery was obtained after few minutes. A strong influence of the temperature on the extraction recovery was also found. In the case of PTF…

CFD Simulation of Particle Distribution in a Multiple-impeller High-Aspect-Ratio Stirred Vessel

2000

Publisher Summary This chapter describes fully predictive simulations of solid–liquid suspensions in a high-aspect-ratio, multiple-impeller stirred tank. These are performed by using the Inner Outer impeller modeling technique coupled with the Multi Fluid Model (MFM) for the treatment of the dispersed phase. The strongly simplified Settling Velocity Model (SVM) is also tested. The effects of free-stream turbulence on the drag coefficient CD and particle settling velocity are accounted for by means of a recently proposed correlation. Comparison of simulation results with experimental particle concentration profiles shows that the MFM approach leads to fair agreement with experimental data. R…

Simulation of Reaction-Induced Phase Separation in Surface Alloy

2008

Using kinetic Monte Carlo method we simulate the dynamics of biatomic Au0.3Ni0.7 surface alloy separation on Ni(111) due to Ni(CO)4 out-reaction. The experiment of Vestergaard et al. is modeled by counterbalancing dynamical processes and interactions between reactants. The simulations demonstrate step flow rate increase with CO coverage, cCO, in qualitative agreement with the experiment only for cCO <∼ 0.45 monolayer. Moreover, we demonstrate both CO influence on reaction process and Au domain formation.

Airborne birch pollen in Poland and Latvia in the light of data obtained from aerobiological monitoring and tauber traps in relation to mean air temp…

2012

Birch pollen contains allergens belonging to those with the strongest allergenic properties. In order to trace pollen season patterns of this taxon and pollen annual sums at a wider regional scale, cooperation was established with the University of Latvia in Riga (Latvia). A comparison of the results obtained in the years 2003-2008 in Lublin and in Riga, using volumetric samplers, shows that there was a similar trend in the abundance of birch pollen. The highest sums were noted at both sites in 2003. In all the study years, more birch pollen grains were recorded in Lublin than in Riga, on the average by 7110. The birch pollen seasons started earlier in Lublin than in Riga, on the average by…

Sedimentation Tanks for Treating Rainwater: CFD Simulations and PIV Experiments

2021

The removal of solids is the most important step when treating rainwater. The article evaluates two designs of sedimentation tanks that can be used for the continuous separation of fine particles from water: OS—standard sedimentation tanks, and OW—swirl sedimentation tanks. The tanks were studied by conducting computational fluid dynamics (CFD) modeling and particle image velocimetry (PIV) experiments. The settling process in sedimentation tank was carried out at varying operating flow rates. A tank with a modified structure was used for the tests, where water was supplied by a nozzle placed at an angle. This solution made it possible to obtain a rotational flow that transported the suspend…

Nitrous oxide fluxes from permafrost regions

2020

This dataset is a synthesis of published nitrous oxide (N2O) fluxes from permafrost-affected soils in Arctic, Antarctic, and Alpine permafrost regions. The data includes mean N2O flux rates measured under field (in situ) conditions and in intact plant-soil systems (mesocosms) under near-field conditions. The dataset further includes explanatory environmental parameters such as meteorological data, soil physical-chemical properties, as well as site and experimental information. Data has been synthesized from published studies (see 'Further details'), and in some cases the authors of published studies have been contacted for additional site-level information. The dataset includes studies publ…

Influence of the pressure head sequence on the soil hydraulic conductivity determined with tension infiltrometer

2005

An increasing and a decreasing sequence of pressure head, h0, values were applied with the tension infiltrometer (TI) to determine the corresponding hydraulic conductivity, K0. The pressure head sequence is expected to influence the K0 results given the hysteretic nature of the hydraulic conductivity relationship. The objective of this study was to evaluate the influence of the selected pressure head sequence on the hydraulic conductivity of a sandy loam soil measured by a multipotential TI experiment. Twenty experiments were carried out by applying h0 values varying between -150 and +5 mm (site A). The h0 values ranged from -150 to -10 mm in another 20 spots (site B). Both wetting and dryi…

Volume change characteristics of fine-grained soils due to sequential thermo-mechanical stresses

2019

Know-how of volume change characteristics, VCC, of the fine-grained soils, exposed to thermal stresses, is essential for design of various thermo-active structures. These stresses are known to induce excess pore-water pressure, Δu θ , in the saturated state of such soils, which in turn affects their compression and shear strength characteristics. In this context, through several experimental studies, the effect of thermo-mechanical stress-path, the over-consolidation ratio (OCR) and degree of saturation on VCC (viz., thermally induced volumetric strain, ε vθ , compression and re-compression indices, c c and c r ) of the fine-grained soils has been demonstrated by earlier researchers. Howeve…

Draining and drying process development of the Tokamak Cooling Water System of ITER

2016

Abstract The ITER Organization (IO) developed a thermal-hydraulic (TH) model of the complex first wall and blanket (FW/BLK) cooling channels to determine gas flow rate and pressure required to effectively blow out the water in the FW/BLK. In addition, US ITER conducted experiments for selected geometries of FW/BLK flow channels to predict the blowout parameters. The analysis indicates that as low as 2 MPa of pressure difference over the blanket modules will ensure substantial evacuation of the water in blankets with just a few percent remaining in the blanket flow channels. A limited validation study indicates that the analysis yields less conservative results to compare against data collec…