Search results for "volumetric"
showing 10 items of 175 documents
A theoretical plate model accounting for slow kinetics in chromatographic elution.
2011
The chromatographic elution has been studied from different perspectives. However, in spite of the simplicity and evident deficiencies of the plate model proposed by Martin and Synge, it has served as a basis for the characterization of columns up-to-date. This approach envisions the chromatographic column as an arbitrary number of theoretical plates, each of them consisting of identical repeating portions of mobile phase and stationary phase. Solutes partition between both phases, reaching the equilibrium. Mobile phase transference between the theoretical plates is assumed to be infinitesimally stepwise (or continuous), giving rise to the mixing of the solutions in adjacent plates. This yi…
CO2 conversion in a photocatalytic continuous membrane reactor
2016
The reduction of CO2 with water by using photocatalysts is one of the most promising new methods for achieving CO2 conversion to valuable hydrocarbons such as methanol (MeOH). In this work, prepared TiO2-Nafion (TM)-based membranes were used in a photocatalytic membrane reactor, operated in continuous mode, for converting CO2 to methanol. By using the membrane with the best TiO2 distribution, a MeOH flow rate/TiO2 weight of 45 mu mol (g(catalyst) h)(-1) was measured when operating at 2 bar of feed pressure. This value is higher than those reported in most of the literature data to date. Moreover, methanol production is considered as a relevant advance over the existing literature results wh…
Interpretive optimisation of organic solvent content and flow-rate in the separation of β-blockers with a Chromolith RP-18e column
2009
The chromatographic performance of a Chromolith RP-18e column was comprehensively examined for a group of basic drugs (beta-blockers), eluted with isocratic ACN-water mixtures at increasing flow-rate up to 6 mL/min. As the flow-rate increases at fixed mobile phase composition, peak distribution (selectivity) is maintained, but the relative peak widths increase. This reduces the resolution below satisfactory values for closely eluting compounds. With the monolithic column, flow-rate becomes thus an important factor to be optimised, in addition to the mobile phase composition. Since, theoretically, retention factors (k) are independent of the flow-rate, the classical quadratic model relating …
Impact of pore structural parameters on column performance and resolution of reversed-phase monolithic silica columns for peptides and proteins
2007
In this work, monolithic silica columns with the C4, C8, and C18 chemistry and having various macropore diameters and two different mesopore diameters are studied to access the differences in the column efficiency under isocratic elution conditions and the resolution of selected peptide pairs under reversed-phase gradient elution conditions for the separation of peptides and proteins. The columns with the pore structural characteristics that provided the most efficient separations are then employed to optimize the conditions of a gradient separation of a model mixture of peptides and proteins based on surface chemistry, gradient time, volumetric flow rate, and acetonitrile concentration. Bo…
Description of the Retention and Peak Profile for Chromolith Columns in Isocratic and Gradient Elution Using Mobile Phase Composition and Flow Rate a…
2014
The effect of the modifier concentration and flow rate on the chromatographic performance of a second generation Chromolith® RP-18e column, under isocratic and gradient elution with acetonitrile-water mixtures, was examined using four sulphonamides as probe compounds. The acetonitrile concentration was varied between 5 and 55% (v/v), and the flow rate between 0.1 and 5.0 mL/min, keeping the other factors constant. The changes in both retention and peak profile were modelled, and used to build simple plots, where the logarithm of the retention factor was represented against the modifier concentration (in gradient elution, against the initial modifier concentration), and the half-widths or wi…
Solid-liquid mass transfer coefficients in gas-solid-liquid agitated vessels
1998
The research on mass transfer coefficients in solid-liquid agitated systems has received substantial attention in the past, due both to the interest in fundamental aspects of mass transfer between particles and turbulent fluids and to the importance of practical applications. In contrast, little information is available on solid-liquid mass transfer when a third gaseous phase is also dispersed into the system, in spite of the importance of the applications of gas-solid-liquid agitated systems. In this work a suitable dissolution technique was used to measure the solid-liquid mass transfer coefficient in gas-solid-liquid vessels stirred by either radial or axial impellers. The mechanical pow…
Correction of the deviations in the retention times with Chromolith columns associated to the flow rate: Implications in the modelling of the retenti…
2011
In a previous work (J. Sep. Sci. 2009, 32, 2793-2803), we reported an interpretive optimisation approach to achieve maximal resolution in minimal analysis time, based on models describing the retention and peak shape as a function of mobile phase composition and flow rate. The method was applied to the separation of a group of basic drugs in a Chromolith column. In that work, we found that the retention factors were sensitive to the flow rate. The reason of the observed deviations in retention times is the increase in the column volume at the applied pressure, which decreases the linear velocity inside the column. This behaviour forced to include a correction term in the model that describe…
Conical Two-Phase Swirl Flow Atomizers—Numerical and Experimental Study
2021
This paper presents the results of numerical simulations for the developed and discussed conical two-phase atomizers with swirl flow, differing in the ratio of the height of the swirl chamber to its diameter. Experiments were carried out for SAN-1 with HS/DS = 1 and SAN-2 with HS/DS = 4 atomizers. The study was conducted over a range of Reynolds number for liquid ReL = (1400
Natural Convection Cooling of a Hot Vertical Wall Wet by a Falling Liquid Film
2008
Abstract The system studied is a plane channel in which one of the two vertical walls is kept at an arbitrary temperature profile and may be partially or completely wet by a falling liquid film, while the opposite wall is adiabatic. Air from the environment flows along the channel with a mass flow rate which depends on the balance between hydraulic resistances and buoyancy forces. These latter, in their turn, depend on the distribution of temperature and humidity (hence, density) along the channel and eventually on the heat and mass transferred from wall and film to the humid air. A simplified computational model of the above system was developed and applied to the prediction of relevant qu…
Mixed MHD convection and Tritium transport in fusion-relevant configurations
2005
Mixed MHD flow and Tritium transport were computed for a slender poloidal duct, representative of a DEMO HCLL blanket element. 2-D flow and temperature fields were computed in the duct's cross section under the assumption of parallel, fully developed flow, while Tritium concentration C was found by solving a fully 3-D problem with simplifying assumptions at the duct's ends. The spatial distribution of C depended on the intensity and direction of the forced flow. Significant peak factors were obtained if the net flow rate was so low that re-circulation occurred; C maxima were attained near the walls for upward flow, in the core region for downward flow.