0000000000013020
AUTHOR
Miguel Bello-jiménez
showing 16 related works from this author
Actively mode-locked fibre ring laser based on in-fibre acousto-optic amplitude modulation
2011
Recent advances in the development of all-fibre amplitude modulators have led to the implementation of a series of different actively mode-locked fibre lasers [1–4]. In-fibre acousto-optic modulation based on intermodal coupling induced my a standing flexural acoustic wave permits the implementation of broad bandwidth (1.5 nm), high modulation depth (0.72), low-insertion-loss (0.75 dB) all-fibre amplitude modulators that operate in the MHz frequency range. The experimental characterization of a laser with the configuration depicted in Fig. 1 (a) as a function of the radio frequency voltage that controls the modulator (see Fig. 1 (b)), the length of the Erbium doped fibre (EDF), and the opti…
Actively mode-locked all-fiber laser by 5 MHz transmittance modulation of an acousto-optic tunable bandpass filter
2018
Active mode-locking of an all-fiber ring laser by transmittance modulation of an in-fiber acousto-optic tunable bandpass filter (AOTBF) is reported. Cavity loss modulation is achieved by full acousto-optic mode re-coupling cycle induced by standing flexural acoustic waves. The modulator permits the implementation of 28 dB of nonresonant light suppression, 1.4 nm of modulation bandwidth, 74% of modulation depth and 4.11 dB of optical loss in a 72.5 cm-long all-fiber configuration. The effects of the modulated AOTBF on the laser performance are investigated. Transform-limited optical pulses of 8.8 ps temporal width and 6.0 W peak power were obtained at 4.87 MHz repetition rate.
High Sensitivity Refractive Index Sensor Based on Highly Overcoupled Tapered Fiber Optic Couplers
2017
In this paper, a simple and compact fiber-optic sensor based on an overcoupled tapered fiber coupler is studied. The coupler is fabricated to be operated well beyond the initial coupling cycles, where the rapid exchange of energy between outputs ports enable the fabrication of a highly sensitive device. The suitability and sensitivity of the proposed scheme is demonstrated by measuring refractive index (RI) variations of sugar concentrations in water. The device presents a linear response in terms of power transmission or wavelength shift versus RI changes. The best achieved sensitivity is 0.442 units of normalized transmission per unit of sugar concentration, with a noise detection limit o…
Q-switched mode locking noise-like pulse generation from a thulium-doped all-fiber laser based on nonlinear polarization rotation
2021
Abstract Q-switched mode locking (QML) noise-like pulse (NLP) emission from an all-fiber thulium-doped laser based on the nonlinear polarization rotation effect is reported. The QML emission is obtained in a cavity with net anomalous dispersion in a pump power interval in between the CW laser threshold and the threshold of the NLP regime. Highest-energy QML pulses were observed with a repetition rate of 812 kHz with a pump power of 520 mW at the optical wavelength of 1881.09 nm. A maximum overall energy of 460 nJ at an average output power of 6.4 mW was reached, which corresponds to a burst of mode-locked noise-like sub-pulses with 8.7 ns of pulse duration within a QML envelope of 11 µs. Th…
Q switching and mode locking pulse generation from an all-fiber ring laser by intermodal acousto-optic bandpass modulation
2018
Q-switched and mode-locked (QML) pulse generation from an all-fiber ring laser based on intermodal acousto-optic bandpass modulation is reported. The modulator relies on full-acousto-optic mode re-coupling cycle induced by a standing flexural acoustic wave, with a transmission response that is controlled by amplitude modulation of the acoustic wave signal. The Q factor of the cavity is controlled by a rectangular pulse wave with variable frequency and duty cycle, whereas mode locking is achieved by amplitude modulation derived from a standing flexural acoustic wave. The best QML pulses were obtained at 0.5 kHz repetition rate, with a pump power of 549.2 mW, at the optical wavelength of 1568…
Low repetition rate gain-switched double-clad thulium-doped fiber laser operating in the 2 µm wavelength region
2021
Abstract The experimental demonstration of a gain-switched pulsed fiber laser with low repetition rate emission in the 2 µm wavelength region is presented. The laser cavity is based on the figure-9 shape, where the gain-switched operation of the laser is obtained by using a double-clad Tm-doped fiber (DCTDF) as gain medium and a commercial pulsed laser diode at 793-nm with configurable parameters as pump source. The pulse parameters of the pump source are optimized for efficient suppressing of unstable gain-switched laser oscillations. As a result, laser pulses with low repetition rate in a range from 10 to 20 kHz with laser emission at the wavelength of 1951 nm are obtained. The generated …
Design of double-tapered fibers for tailoring the acousto-optic spectral response
2016
A model to shape the spectral response of acousto-optic devices based on tapered fibers is reported. A double-tapered structure was designed in order to obtain a flat attenuation response with 34 nm bandwidth.
Acousto-optic interaction in biconical tapered fibers: shaping of the stopbands
2016
The effect of a gradual reduction of the fiber diameter on the acousto-optic (AO) interaction is reported. The experimental and theoretical study of the intermodal coupling induced by a flexural acoustic wave in a biconical tapered fiber shows that it is possible to shape the transmission spectrum, for example, substantially broadening the bandwidth of the resonant couplings. The geometry of the taper transitions can be regarded as an extra degree of freedom to design the AO devices. Optical bandwidths above 45 nm are reported in a tapered fiber with a gradual reduction of the fiber down to 70 μm diameter. The effect of including long taper transition is also reported in a double-tapered st…
Abrupt-tapered fiber filter arrangement for a switchable multi-wavelength and tunable Tm-doped fiber laser.
2018
A switchable and tunable multi-wavelength Tm-doped fiber laser is successfully demonstrated using a filter constructed with two tapered fiber elements in the cavity. The proposed system design uses a low-cost simple filter that allows stable dual, triple, quadruple, and quintuple-wavelength emission operation in the region around 1.9 μm. In the dual wavelength regime, the laser is capable of independently tuning each wavelength. For switching and tuning, a curvature is applied to the tapered fibers.
Long-cavity all-fiber ring laser actively mode locked with an in-fiber bandpass acousto-optic modulator.
2013
We demonstrate low-frequency active mode locking of an erbium-doped all-fiber ring laser. As the mode locker, we used a new in-fiber bandpass acousto-optic modulator showing 74% modulation depth, 3.7 dB power insertion losses, 4.5 nm of optical bandwidth, and 20 dB of nonresonant light suppression. The laser generates 330 ps mode-locked pulses over a 10 ns pedestal, at a 1.538 MHz frequency, with 130 mW of pump power. Fil: Cuadrado Laborde, Christian Ariel. Universidad de Valencia; España. Consejo Nacional de Investigaciones Científicas y Técnicas. Centro Científico Tecnológico La Plata. Centro de Investigaciones Opticas (i); Argentina. Provincia de Buenos Aires. Gobernación. Comisión de In…
The nonlinear optical loop mirror: soliton and noise-like pulse emission in a figure-eight fiber laser
2021
In this article, a symmetrical nonlinear optical loop mirror (NOLM) exhibiting a polarization-dependent transmission is evaluated to generate optical pulse emission in a figure-eight fiber laser in the soliton and noise-like pulse (NLP) regimes. The NOLM structure relies on a 50:50 fiber coupler, a loop with highly twisted single-mode optical fiber and a quarter-wave retarder (QWR) to break the polarization asymmetry. The pulse operation regime is determined by properly adjusting the NOLM low-power transmission, which is easily realized by the rotation of the QWR angle. Soliton pulses of 1.48 ps pulse duration and peak power of 18 W were observed with a peak to peak separation of 1.25 µs, c…
Broadband tuning of a long-cavity all-fiber mode locked Thulium-doped fiber laser using an acousto-optic bandpass filter
2019
A long-cavity passively mode-locked thulium-doped all-fiber laser is reported incorporating a tapered acousto-optic tunable bandpass filter (AOTBF). The operation of the AOTBF relies on the intermodal coupling between core and cladding modes when a flexural acoustic wave propagates along an 80-microm tapered fiber. The filter works in transmission and exhibits a 3-dB bandwidth of 9.02 nm with an insertion loss of 3.4 dB. The laser supports ultrashort pulse generation at a low repetition rate of 784.93 kHz. Optical pulses with 2.43 nm of optical bandwidth and 2.1 ps pulse duration were obtained in a broad tuning range from 1824.77 to 1905.16 nm.
Flat supercontinuum generation pumped by amplified noise-like pulses from a figure-eight erbium-doped fiber laser
2017
The conditions to obtain noise-like pulses (NLPs) from a figure-eight fiber laser (F8L) and their application for supercontinuum (SC) generation in the anomalous dispersion regime are reported. The F8L is designed to remove the undesired low-intensity background radiation from pulse emission, generating NLPs with a 3 dB spectral bandwidth of 17.43 nm at the fundamental repetition frequency of 0.8 MHz. After amplification, NLPs reach a maximum average power of 9.2 mW and 123.32 nm spectral bandwidth. By controlling the amplifier pump power, flat SC generation is demonstrated through both a 800 m long spool of SMF-28 fiber and a piece of 5 m long highly nonlinear optical fiber. The results de…
Improved All-Fiber Acousto-Optic Tunable Bandpass Filter
2017
An all-fiber acousto-optic tunable bandpass filter based on a 1.185-mm long coreless core mode blocker is reported. Experimental results demonstrate a minimal insertion loss of 1.2 dB at the optical resonant wavelength of 1527.7 nm with 3-dB optical bandwidth of 0.83 nm. The optimization of the device takes into account the attenuation of the acoustic wave and leads to an asymmetric configuration in which the coupling section is shorter than the recoupling part. Under the effect of a standing flexural wave the device can be operated as a bandpass modulator. The device exhibits a maximum modulation depth of 28%, 4 dB of insertion loss and 0.97 nm of optical bandwidth at 4.774 MHz.
Experimental Investigation of Fused Biconical Fiber Couplers for Measuring Refractive Index Changes in Aqueous Solutions
2016
A detailed experimental study of a simple and compact fiber optic sensor based on a fused biconical fiber coupler is presented, in which the sensitivity is improved by operating the coupler beyond the first coupling cycle. The sensor is demonstrated to perform high sensitivity measurements of refractive index changes by means of variation of sugar concentration in water. The device is operated to achieve a linear transmission response, allowing a linear relation between the sugar concentration and the output signal. The initial sensitivity was measured as 0.03 units of normalized transmission per unit of sugar concentration (g/100 mL), with a noise detection limit of a sugar concentration o…
Actively mode-locked fiber ring laser by intermodal acousto-optic modulation
2010
We report an actively mode-locked fiber ring laser. A simple and low-insertion-loss acousto-optic modulator driven by standing flexural waves, which couples core-to-cladding modes in a standard single-mode optical fiber, is used as an active mechanism for mode locking. Among the remarkable features of the modulator, we mention its high modulation depth (72%), broad bandwidth (187 GHz), easy tunability in the optical wavelength, and low insertion losses (0.7 dB). The narrowest optical pulses obtained were of 95 ps time width, 21 mW peak power, repetition rate of 4.758 MHz, and 110 mW of pump power.