0000000000025797
AUTHOR
O. Alanen
showing 18 related works from this author
Network and System Performance Management for Next Generation Networks
2006
The physical and logical structures of next generation network and service environment is complex and requires increasingly sophisticated and complicated tools to be fully controllable and well managed. The main problem that has risen is that the old telemanagement model has not enough flexibility to manage rapidly and constantly changing network environment. 3G and 4G networks are basically IP based and the knowledge of IP type traffic management is somewhat new and challenging to telecom vendors. The present way of controlling and managing telecom systems is to use Non Real Time off-line PM (Performance Monitoring) and tools. Time periods between tuning can now be some days to some weeks …
On ARQ feedback intensity of the IEEE 802.16 ARQ mechanism
2008
The IEEE 802.16 standard defines the ARQ mechanism as a part of the MAC layer. The functioning of the ARQ mechanism depends on a number of parameters. The IEEE 802.16 specification defines them but it does not provide concrete values and solutions. We ran simulation scenarios to study how the ARQ feedback intensity impacts the performance of application protocols. The simulation results reveal that a low ARQ feedback intensity results only in a marginal improvement. Though it is possible to optimize the ARQ feedback intensity, it is reasonable to rely upon more frequent ARQ feedback messages as they do not result in a performance degradation. At the same time, ARQ connections, which work on…
Scheduling solution for the IEEE 802.16 base station
2008
The IEEE 802.16 standard defines a wireless broadband access network technology called WiMAX. It introduces several advantages, one of which is the support for QoS at the MAC level. To ensure meeting the QoS requirements, the 802.16 base station must run some algorithm to allocate slots between connections. This algorithm is not defined in the 802.16 specification but rather is open for alternative implementations. We propose a simple, yet efficient, solution that is capable of allocating slots based on the QoS requirements, bandwidth request sizes, and the 802.16 network parameters. To test the proposed solution, we have implemented the 802.16 MAC and PHY layers in the NS-2 simulator. Seve…
Performance Evaluation of the IEEE 802.16 ARQ Mechanism
2007
The IEEE 802.16 technology defines the ARQ mechanism that enables a connection to resend data at the MAC level if an error is detected. In this paper, we analyze the key features and parameters of the ARQ mechanism. In particular, we consider a choice for the ARQ feedback type, a scheduling of the ARQ feedbacks and retransmissions, the ARQ block rearrangement, ARQ transmission window and ARQ block size. We run a number of simulation scenarios to study these parameters and how they impact a performance of application protocols. The simulation results reveal that the ARQ mechanism plays an important role in transmitting data over wireless channels in the IEEE 802.16 networks.
Adaptive contention resolution parameters for the IEEE 802.16 networks
2007
In the IEEE 802.16 networks, the base station allocates resources to subscriber stations based on their QoS requirements and bandwidth request sizes. A subscriber station can send a bandwidth request when it has an uplink grant allocated by the base station or by taking part in the contention resolution mechanism. This paper presents analytical calculations for parameters that control the contention resolution process in the IEEE 802.16 networks. In particular, the backoff start/end values and the number of request transmission opportunities are considered. The simulation results confirm the correctness of theoretical calculations. They also reveal that the adaptive parameter tuning results…
Optimal MAC PDU Size in IEEE 802.16
2008
In the IEEE 802.16 the number of errors and the MAC PDU size have an impact on the performance of the network. We present a way to estimate the optimal PDU size and we run a number of simulation scenarios to study these parameters and how they impact on the performance of application protocols. The simulation results reveal that the channel bit error rate has a major impact on the optimal PDU size in the IEEE 802.16 networks. Also, the ARQ block rearrangement influences the performance.
ARQ Aware Scheduling for the IEEE 802.16 Base Station
2008
The IEEE 802.16 technology defines the ARQ mechanism that enables a connection to resend data at the MAC level if an error is detected. In this paper, we analyze the ARQ aware scheduling for the 802.16 base station. In particular, we consider how the BS scheduler can account for the ARQ block size, absence of the ARQ block rearrangement, and the ARQ transmission window. We propose a set of constraints that can be applied to any base station scheduler algorithm. To test them, we run a number of simulation scenarios. The simulations results confirm that the ARQ aware scheduling can improve the overall performance.
WINSE: WiMAX NS-2 extension
2009
IEEE 802.16 standard defines the wireless broadband technology called WiMAX. When compared to other wireless technologies, it introduces many interesting advantages at PHY, MAC, and QoS layers. Heavy simulations are needed to study IEEE 802.16 performance and propose further enhancements to this standard. Link level simulations are not always sufficient, while system level simulators are not always accurate to capture MAC and transport protocol details. We implemented a 802.16 extension for the NS-2 network simulator. It includes upper PHY modeling, almost all the features of the 802.16 MAC layer, as well as the QoS framework. This article describes the implemented features, simulation meth…
Analysis of the Non-Transparent In-Band Relays in the IEEE 802.16 Multi-Hop System
2010
This paper presents extensive dynamic simulations of the non-transparent in-band relays working in the distributed scheduling mode. The simulation results show that in-band relays can improve noticeably the spectral efficiency without acquiring an additional radio spectrum. Also, packet transmission delays become smaller. An important outcome of the dynamic simulations is that it is very crucial to choose a correct relay zone size where the base station and relay nodes exchange data. Otherwise, throughput fairness of the whole system declines. It indicates an importance of the relay zone size adjustment algorithm that the base station must run.
Adaptive Contention Resolution for VoIP Services in the IEEE 802.16 Networks
2007
In the IEEE 802.16 networks, a subscriber station can use the contention slots to send bandwidth requests to the base station. The contention resolution mechanism is controlled by the backoff start/end values and a number of the request transmission opportunities. These parameters are set by the base station and are announced to subscriber stations in the management messages. In the case of the VoIP services, it is critical that the contention resolution occurs within the specified time interval to meet the VoIP QoS requirements. Thus, it is the responsibility of the base station to set correct contention resolution parameters to ensure the QoS requirements. This paper presents analytical c…
ARQ parameters for VoIP in IEEE 802.16 networks
2009
IEEE 802.16 standard defines two data retransmission mechanisms. HARQ provides fast retransmissions in cost of slightly increased overhead. On the contrary, ARQ has less overhead in cost of bit longer delays. It is therefore often used with BE connections. In addition to delay tolerant applications, BE can also be used for real-time services. Therefore, in this paper we analyze the ARQ mechanism and provide guidelines on how to set the ARQ parameters to achieve a good balance between the VoIP delay and packet loss.
Analysis and Simulation of the Signaling Protocols for the DiffServ Framework
2006
This paper considers signaling protocols for the DiffServ QoS framework. Originally, DiffServ had no standardized signaling solution, which resulted in the static configuration for the DiffServ domain. However, the dynamic allocation of resources within the domain allows to ensure the per-flow QoS guarantees and achieve better performance. At the moment, several signaling solutions for DiffServ framework are available. Thus, it is crucial to analyse these solutions and interconnections between them. In particular, the RSVP, aggregated RSVP, GIST, COPS, and SIP protocols will be considered. The simulation comprises several scenarios that present that the dynamic allocation of resource within…
Ensuring the QoS requirements in 802.16 scheduling
2006
IEEE 802.16 standard defines the wireless broadband access network technology called WiMAX. WiMAX introduces several interesting advantages, and one of them is the support for QoS at the MAC level. For these purposes, the base station must allocate slots based on some algorithm. We propose a simple, yet efficient, solution for the WiMAX base station that is capable of allocating slots based on the QoS requirements, bandwidth request sizes, and the WiMAX network parameters. To test the proposed solution, we have implemented the WiMAX MAC layer in the NS-2 simulator. Several simulation scenarios are presented that demonstrate how the scheduling solution allocates resources in various cases. S…
Performance analysis of the ieee 802.16 arq mechanism
2007
The IEEE 802.16 technology defines the ARQ mechanism that enables a connection to resend data at the MAC level if an error is detected. In this paper, we analyze the key features and parameters of the 802.16 ARQ mechanism. In particular, we consider a choice for the ARQ feedback type, an algorithm to build block sequences, a scheduling of the ARQ feedbacks and retransmissions, the ARQ block rearrangement, ARQ transmission window and ARQ block size. We run a number of simulation scenarios to study these parameters and how they impact a performance of application protocols. The simulation results reveal that the ARQ mechanism and its correct configuration play an important role in transmittin…
Multicast access control concept for xDSL-customers
2006
Multicast is a tempting possibility for many broad- band services. It makes possible to deliver one data-stream to several receivers simultaneously. IP-Multicast is based on an open group concept. This means that it is possible for all the users to join the group and thus receive the data. The open concept is also the main reason why multicast has not been taken in wider use. There is two different solution to solve this problem, group access control and multicast data encryption. Group access control mechanisms focuses on restricting the group membership at the users edge device. Traffic encryption scheme relies on end-to-end encryption, so a key management architecture is also needed. We …
Analysis and Performance Evaluation of the IEEE 802.16 ARQ Mechanism
2008
The IEEE 802.16 standard defines the ARQ mechanismas a part of the MAC layer. The functioning of the ARQmechanism depends on a number of parameters. The IEEE802.16 specification defines them but it does not provide concrete values and solutions. This paper studies the key features and parameters of the 802.16 ARQ mechanism. In particular, we consider a choice for the ARQ feedback type, an algorithm to build block sequences, the ARQ feedback intensity, a scheduling of the ARQ feedbacks and retransmissions, the ARQ block rearrangement, ARQ transmission window and the ARQ block size. We ran simulation scenarios to study these parameters and how they impact the performance of application protoc…
Multicast polling and efficient voip connections in ieee 802.16 networks
2007
IEEE 802.16 standard defines the wireless broadband access network technology called WiMAX which introduces several interesting advantages including its the support for quality of service (QoS) at the MAC layer. Its several features, such as multicast polling support the base station (BS) to provide the QoS guarantees for subscriber stations (SSs). The specification, however, does not define very exactly how this optional multicast polling technique should be used. We propose a way to use this feature on the base stations and also suggest an addition to the specification, to serve several different delay requirements. To test the proposed solution and the performance of the multicast pollin…
Impact of portable device restrictions on IEEE 802.16 performance
2008
IEEE 802.16 is a good alternative for fast wireless connection in the next generation portable information devices (PID). However it was not originally designed for portable devices, but mobility was added later to the specification. This means that the lack of resources on portable devices might have a significant impact on which IEEE 802.16 features should be chosen and how they should be used. Proper usage of ARQ can increase the IEEE 802.16 performance but it can also require much resources from PIDs. In this paper we focus on how ARQ features are affected by limited resources on PID and how much the limitations affect on the performance.