0000000000060496
AUTHOR
Pere Pérez-millán
Evaluation of all-optical demultiplexing in millimeter-wave subcarrier-system for wireless communication
In this paper, a scheme for multiplexing millimeter-wave carriers on a single optical carrier and using an all-optical millimeter-wave demultiplexer is presented. The optical demultiplexing of radio-over-fiber signals is based on dual sideband modulation with suppressed optical carrier combined with the filtering properties of dual over-written fiber Bragg gratings. The performance of the system is investigated using a single optical carrier and independent data modulated millimeter-wave signals at 20 and 40 GHz. The signals are transmitted over optical fiber, demultiplexed and wirelessly distributed to a mobile unit. It is found that performance of the demultiplexing using fiber Bragg grat…
Active Q-switched distributed feedback erbium-doped fiber lasers
This letter presents a distributed feedback fiber laser that operates in an actively controlled Q-switched regime. The laser is based on a Bragg grating made in an erbium-doped fiber. The grating has a defect induced by a magnetostrictive transducer that configures the distributed feedback laser structure. The phase shift generated by the defect can be dynamically modified by an electric current, permitting active Q-switching of the laser. The laser generates pulses of 75 ns duration and the repetition rate can be continuously adjusted from 0 to 10 kHz.
Passive compensation of the thermal drift of magnetostriction based Q-switched fiber lasers
Abstract The authors propose and demonstrate a method to compensate the thermal drift of magnetostriction based Q-switched fiber lasers, which is caused by the eddy currents induced in the Terfenol-D magnetostrictive actuators. The consequent wavelength detuning between the fiber gratings of the laser is passively compensated by the use of Monel 400 as thermal actuator of the non-modulated grating. A highly stable pulsed signal is achieved in the range of 1 Hz–5 kHz, with a wavelength detuning between gratings maintained below 10 pm. Furthermore, an optimization of the use of the pump power is proposed, utilizing part of it for simultaneously pumping a fiber optic based amplification stage.
Comprehensive Theoretical and Experimental Study of Short- and Long-Term Stability in a Passively Mode-Locked Solitonic Fiber Laser
We demonstrate the short- and long-term stable operation of an all-polarization-maintained Fabry–Perot cavity passively mode-locked fiber laser. The laser operates in an all-anomalous-dispersion solitonic regime. Laser stability is studied by a variety of measurements, which confirm the high stability of the laser in the temporal and spectral–both optical and electrical-domains. Pulse durations of 540 fs, period-relative time jitters of $\sim$ 0.015‰, and long-term uninterrumped operation with 0.4% variation (standard deviation) in the average output power are obtained. The highly stable operation of the laser oscillator was maintained after amplifying the laser output with a conventional E…
Stable Optically Generated RF Signals from a Fibre Mode-Locked Laser
Phase stability of RF signals obtained by two-mode filtering of a fibre mode-locked laser is analyzed. Time jitter is shown to be constant with selected mode spacing, confirming the scheme capability for generating stable RF signals up to extremely-high frequency.
Optical demultiplexing of millimeter-wave subcarriers for wireless channel distribution employing dual wavelength FBGs
An optical mm-wave demultiplexer is presented. Double sideband modulation with suppressed optical carrier and filtering properties of dual overwritten fiber Bragg gratings are the fundamentals for optical demultiplexing of mm-wave radio-on-fiber signals: using a single optical carrier, Millimeter-wave signals of 20 and 40 GHz frequencies carrying independent data are created, transmitted over fiber, demultiplexed and wireless distributed to be detected and data recovered in a mobile unit. Double sideband modulation with suppressed optical carrier yields no power penalty due to chromatic dispersion, while the filtering properties of the dual overwritten fiber Bragg gratings allow less than −…
Electronic tuning of delay lines based on chirped fiber gratings for phased arrays powered by a single optical carrier
We propose a variable delay line for phased arrays antennas based on a chirped fiber grating. The line operates with an optical carrier at constant wavelength and the time delay of the radiofrequency modulating signal is modified stretching the grating with a piezoelectric translator, the grating response can be tuned at a speed of 0.68 nm/ms.
All-fiber actively Q-switched Yb-doped laser
Abstract An all-fiber actively Q-switched Yb-doped laser is presented. Q-switching is performed by modulating a fiber Bragg grating via a magnetostrictive rod which is fixed to the fiber at the position of the grating. By exposing the rod to a changing magnetic field, the rod is stretched and relaxed causing the Bragg wavelength of the grating to shift and thereby changes the Q-factor of the cavity. Using Yb-doped fiber, pulses at 1052 nm are obtained at repetition rates from 1 to 200 kHz. At 75 kHz, 0.5 μJ pulses with peak powers of 3 W can be produced when 180 mW of pump power is applied. To the knowledge of the authors, this is the first all-fiber actively Q-switched Yb-doped laser prese…
Threshold of a Symmetrically Pumped Distributed Feedback Fiber Laser With a Variable Phase Shift
In this paper, we study, both theoretically and experimentally, the threshold characteristics of a distributed feedback fiber laser that depend on the value of a phase shift introduced into the fiber Bragg grating structure. We show that as the phase shift possesses a noticeable birefringence, the laser oscillates at any phase shift value. We also reveal that the laser threshold is different for the cavity eigen polarizations and depends on the phase shift value. We derive a simple analytical formula to calculate the laser threshold in the case of pi phase shift; this formula can be utilized to estimate a minimal threshold value for the laser with certain active fiber and Bragg grating para…
High frequency microwave signal generation using dual-wavelength emission of cascaded DFB fiber lasers with wavelength spacing tunability
[EN] A dual wavelength fiber laser source based on two cascaded phase-shifted fiber Bragg gratings is presented The gratings are written in an erbium-doped fiber each configuring the cavity of a distributed feedback fiber laser The spacing between lasing modes is controlled dynamically by the use of piezoelectric actuators A continuous tuning range of 5-724 pm of the wavelength difference which is equivalent to a photodetected 072-92 GHz range is obtained Efficient generation from the L to the W microwave and millimeter bands has been achieved by heterodyne photodetection of the dual-wavelength optical signal (C) 2010 Elsevier BV All rights reserved
Tunable microwave photonic filter based on chirped fiber gratings working with a single optical carrier at constant wavelength
This paper presents a tunable transversal filter working with a single optical carrier at constant wavelength. The filter consists of a set of chirped gratings whose time delay is tuned with respect to the emission wavelength of a fiber laser by a piezoelectric actuator; extra lengths of fiber are inserted in the filter arms in order to avoid interferences between signals reflected in different gratings. Two and three taps filters are experimentally demonstrated, the filters transfer function is electronically tuned within the free spectral range.
Transform-limited pulses generated by an actively Q-switched distributed fiber laser.
A single-mode, transform-limited, actively Q-switched distributed-feedback fiber laser is presented, based on a new in-line acoustic pulse generator. Our technique permits a continuous adjustment of the repetition rate that modulates the Q factor of the cavity. Optical pulses of 800 mW peak power, 32 ns temporal width, and up to 20 kHz repetition rates were obtained. The measured linewidth demonstrates that these pulses are transform limited: 6 MHz for a train of pulses of 10 kHz repetition rate, 80 ns temporal width, and 60 mW peak power. Efficient excitation of spontaneous Brillouin scattering is demonstrated.
Real-time and low-cost sensing technique based on photonic bandgap structures
[EN] A technique for the development of low-cost and high-sensitivity photonic biosensing devices is proposed and experimentally demonstrated. In this technique, a photonic bandgap structure is used as transducer, but its readout is performed by simply using a broadband source, an optical filter, and a power meter, without the need of obtaining the transmission spectrum of the structure; thus, a really low-cost system and real-time results are achieved. Experimental results show that it is possible to detect very low refractive index variations, achieving a detection limit below 2 x 10(-6) refractive index units using this low-cost measuring technique. (C) 2011 Optical Society of America[
Dynamic control of the operation regimes of a mode-locked fiber laser based on intracavity polarizing fibers: experimental and theoretical validation.
[EN] An intracavity polarizing fiber is proposed to control the emission regime of a passively mode-locked fiber laser. Stable operation in self-starting high and low dispersion soliton mode-locking and 100 GHz multiwavelength regimes is demonstrated through numerical simulations and experimental validation. Mode-locking stability is ensured by a saturable absorber in the ring cavity. The effective selection of operation regime is dynamically carried out by controlling the intracavity polarization state.
Fabrication of chirped fiber Bragg gratings by simple combination of stretching movements
Abstract A new stretching technique to fabricate chirped fiber Bragg gratings using a nonchirped phase mask is presented. It is based on continuous stretching and continuous UV beam scanning, which ensures phase matching between periods along the grating. Simple combinations of the fiber stretching movements of a pair of piezoelectric transducers are used to avoid unwanted period blurring and wavelength shifting. A third piezoelectric transducer can be easily added to the system to provide independent apodization through phase mask dithering. Successful fabrication of apodized and nonapodized chirped fiber gratings has been performed with this technique.
All-fiber processing of terahertz-bandwidth signals based on cascaded tapered fibers
Tapered single-mode fibers are employed to perform dynamic pulse shaping in a bandwidth of several terahertz. The transfer function of cascaded biconical tapers is controlled by introducing a phase shift into one of them through mechanical stretching. It is a simple and low-cost technique with potential to process signals with bandwidths as large as those allocated by standard optical fiber while introducing little degradation. Femtosecond pulses are shaped to prove the concept. (C) 2013 Optical Society of America
Q-switching of an all-fiber laser by acousto-optic modulation of a fiber Bragg grating.
We report active Q-switching of an all-fiber laser using a Bragg grating based acousto-optic modulator. Q-switching is performed by modulating a fiber Bragg grating with an extensional acoustic wave. The acoustic wave modulates periodically the effective index profile of the FBG and changes its reflection features. This allows controlling the Q-factor of the cavity. Using 1 m of 300 ppm erbium-doped fiber and a maximum pump power of 180 mW, Q-switch pulses of 10 W of peak power and 82 ns wide were generated. The pulse repetition rate of the laser can be continuously varied from few Hz up to 62.5 kHz.
Fiber Ring Laser Operated by Dynamic Local Phase Shifting of a Chirped Grating
An ultranarrow linewidth erbium-doped fiber ring laser is presented. It is based on the filtering properties of a phase-shifted chirped fiber Bragg grating, which is inserted inside the cavity of the laser. A dynamic control of the phase shifting, which is induced by a magnetostrictive transducer, permits both tunable continuous-wave and actively Q-switched operation. The use of a chirped grating overcomes the limitations imposed by the narrow spectra of uniform gratings observed in previously reported ring lasers based on intracavity transmission filters.
Actively Q-switched all-fiber lasers
Q-switching of fiber lasers using bulk elements has important drawbacks as reduced mechanical stability and high insertion losses. The development of efficient all-fiber modulation techniques is the key to obtain robust, compact and efficient Q-switched all-fiber lasers. Certainly, the development of fiber Bragg gratings (FBG) has been crucial to make progress on fiber lasers. FBGs permit a simple way to assemble all-fiber laser cavities and can be written in the active fiber itself. The Q-factor of this type of cavities is determined by the reflectivity of the FBGs and the losses of the fiber. Here, we focus on the use of magnetostrictive materials and the acousto-optic interaction to deve…
Dispersion induced effects of high-order optical sidebands in the performance of millimeter-wave fiber-optic links
In this paper, chirped fiber Bragg gratings (CFBGs) are proposed as signal-phase controllers for microwave-photonic wireless downstream fiber links. The effect of high-order modulation optical sidebands that disturbs the output mm-wave signal due to the chromatic dispersion induced by the gratings is studied theoretically and experimentally. The 1st and 2nd mm-wave harmonics of the output signal have been measured for conventional intensity modulation and for intensity modulation with optical carrier suppression. In the last case, data transmission at 2.5 Gb/s is demonstrated through a chirped grating of 280 ps/nm dispersion in a 40-GHz modulated link.
Q-switched all-fiber laser based on magnetostriction modulation of a Bragg grating
We report an actively Q-switched all-fiber laser based on magnetostriction modulation of a Bragg grating. The laser employs a pair of Bragg gratings as reflective mirrors, one of which is bonded to a magnetostrictive element. Lengthening of the magnetostrictive element when a magnetic field is applied shifts the Bragg wavelength of the grating, allowing control of the Q-factor of the cavity and, thus, performing active Q-switching. The magnetostrictive modulator is small, compact and requires less than 300 mW electrical drive power. Using erbium-doped fiber and a maximum pump power of 120 mW, Q-switch pulses of more than 1 W peak power were obtained, with a pulse repetition rate that can be…
Measurement technique for real-time and low-cost biosensing using photonic bandgap structures
We present a sensing technique based on using photonic bandgap structures where only the output power is monitored, without the need of tunable sources or spectrum analyzers, thus providing a real-time and low-cost system.
Phase recovery by using optical fiber dispersion
We propose a simple and fast procedure to retrieve the phase profile of arbitrary light pulses. It combines a first experimental stage, followed by a one-step numerical stage. To this end, it is necessary to perform a Fresnel transform, which is obtained just by propagating the light pulses through an optical fiber. We experimentally test this proposal recovering the phase profile in the light pulses provided by a passively mode-locked laser. The proposal is then compared with a temporal variation of the Gerchberg–Saxton recursive algorithm, which is specially modified for this purpose. Fil: Cuadrado Laborde, Christian Ariel. Universidad de Valencia; España. Consejo Nacional de Investigacio…