0000000000067109
AUTHOR
Bernard Vannes
Optimisation of refractory coatings realised with cored wire addition using a high-power diode laser
Laser; Cladding; Refractory alloys; Factorial experiments; International audience; The objective or our research was to obtain refractory alloys using the high-power diode laser (HPDL) coating technique. After optimisation using factorial experiments, two different cladding regimes were clearly distinguished. It was also shown that a very narrow transition zone exists between the two regimes, and, inside this zone, clad layers having a satisfactory compromise between the response functions (surface aspect and cavity presence) were obtained. The main objective of our study, namely, the control of the operating parameters (geometrical and kinematical) to realise adequate coatings, without cav…
MoSi2 laser cladding—A new experimental procedure: double-sided injection of MoSi2 and ZrO2
International audience; In the last decade, development of low density advanced material systems for service at temperatures up to 1300 °C was one of the goals of many researches. This kind of material should mainly have moderate fracture toughness and should exhibit oxidation resistant behaviour at low and intermediate temperature. One of the most studied materials continues to be the intermetallic compound MoSi2. The molybdenum disilicide has been considered as an attractive candidate due to its melting point (2030 °C) and excellent oxidation resistance at high temperatures. The main problem associated with the MoSi2 layer synthesized using laser beam is the layer fragility. To avoid this…
Study and evaluation of fretting critical slip conditions by applying the design of experiments method
Tribological systems are complex systems that require a multi-disciplinary (mechanical, material, physico-chemical) approach where numerous influence factors can be involved. To characterize a contact couple, the intrinsic parameters of the materials as well as the parameters related to the contact loading and the surrounding environment need to be taken into account. Fretting analysis, by means of running condition-fretting maps (RCFM), allows the behavior of the contact couple to be taken into account and to predict the boundary between partial slip and gross slip conditions. This article presents the study of a steel/polycarbonate couple during fretting tests. The study was carried out b…
MoSi2 laser cladding—elaboration, characterisation and addition of non-stabilized ZrO2 powder particles
International audience; The cladding process using laser beam radiation comprises different operational regimes, depending on the involved lasers (usually CO2 or Nd:YAG) and materials. A series of experiments has been carried out to investigate Nd:YAG laser cladding using MoSi2 powder. Procedures and operating parameters for producing clad layers has been developed and their properties evaluated. The feasibility of the laser cladding technique, using a high power Nd:YAG laser, by projecting MoSi2 powder on steel substrate was demonstrated. The results indicate a low density of cracks, elevated powder catchment efficiency (between 65 and 90%) and hardness values around 1200–1300 HV. Our goal…