0000000000067463
AUTHOR
I. Książek
Impurity analysis of JET DiMPle pulses
Divertor monitoring pulses (DiMPle) have been run in JET from the C35 campaign onwards. They provide an opportunity to study the impurity contamination of the plasma when it is limited by different surfaces within the machine, as well as the longer term behaviour of the impurities. In these discharges the plasma is first limited on the outer wall, then on the inner wall and, subsequently, in the X-point configuration the outer strike point is positioned on the horizontal tile 5 of the machine followed by tile 6 and then the vertical tile 7. The present study details the impurity behaviour in the DiMPle pulses from JET-ILW campaigns C35 to C38, which ran from 2015 to 2019. The impurities can…
Studies of the bromine spectrum and determination of transition probabilities for Br I and Br II lines
In a wall-stabilized cascade arc at atmospheric pressure in mixtures of argon and bromine vapors thermal plasmas were generated. Arc currents between 25 and 60 A were used. Applying a spectrometer of medium dispersion, equipped with an optical multichannel analyzer (CCD detector), the spectra of neutral and singly ionized bromine in the range between 3300 and 10400 A were recorded. Line intensity measurements, corrected for self-absorption, at different operating conditions of the arc, were performed. A complete set of Br I transitions (5 lines) originating from a common upper level (branching fractions) was measured. In the case of the Br II spectrum intensities of 14 lines were determined…
Modeling And Measurements Of The Arc Plasma In A Mixture Of Gases
Radial distributions of Ar mass fractions and temperatures in plasmas produced in a wall-stabilized arc have been calculated. Modeling have been performed for many different mixtures of Ar+N2 and three different arc currents. The obtained results show that the radial distributions of Ar mass fractions strongly depend on the chemical composition of the plasma. In plasmas containing large amount of Ar the distributions have local minima at the arc axis (in high temperature plasma regions), whereas in plasmas consisting mainly of nitrogen the distributions reveal maxima on the discharge axis. Those features seem to be connected with the dissociation of the nitrogen.
Study of uniformity of plasmas produced in a wall-stabilized arc
In this contribution the plasma of an arc discharge in a mixture of helium and argon is studied. The gas mixture is introduced uniformly along the arc column between each of the stabilizing plates. From the measured lateral distribution of radiation (HeI, HI, ArI, ArII, NI, FI line intensity and width measurements), after Abel inversion, the radial temperature distributions were obtained at various positions of the arc column. Beside the expected radial temperature gradients, a distinct temperature gradient along the arc column was found.
ITER-relevant calibration technique for soft x-ray spectrometer
The ITER-oriented JET research program brings new requirements for the low-Z impurity monitoring, in particular for the Be—the future main wall component of JET and ITER. Monitoring based on Bragg spectroscopy requires an absolute sensitivity calibration, which is challenging for large tokamaks. This paper describes both “component-by-component” and “continua” calibration methods used for the Be IV channel (75.9 Å) of the Bragg rotor spectrometer deployed on JET. The calibration techniques presented here rely on multiorder reflectivity calculations and measurements of continuum radiation emitted from helium plasmas. These offer excellent conditions for the absolute photon flux calibration d…
Improved EDGE2D-EIRENE simulations of JET ITER-like wall L-mode discharges utilising poloidal VUV/visible spectral emission profiles
A discrepancy in the divertor radiated powers between EDGE2D-EIRENE simulations, both with and without drifts, and JET-ILW experiments employing a set of NBI-heated L-mode discharges with step-wise density variation is investigated. Results from a VUV/visible poloidally scanning spectrometer are used together with bolometric measurements to determine the radiated power and its composition. The analysis shows the importance of D line radiation in contributing to the divertor radiated power, while contributions from D radiative recombination are smaller than expected. Simulations with W divertor plates underestimate the Be content in the divertor, since no allowance is made for Be previously …