0000000000067467
AUTHOR
F.g. Rimini
Impurity analysis of JET DiMPle pulses
Divertor monitoring pulses (DiMPle) have been run in JET from the C35 campaign onwards. They provide an opportunity to study the impurity contamination of the plasma when it is limited by different surfaces within the machine, as well as the longer term behaviour of the impurities. In these discharges the plasma is first limited on the outer wall, then on the inner wall and, subsequently, in the X-point configuration the outer strike point is positioned on the horizontal tile 5 of the machine followed by tile 6 and then the vertical tile 7. The present study details the impurity behaviour in the DiMPle pulses from JET-ILW campaigns C35 to C38, which ran from 2015 to 2019. The impurities can…
The power threshold of H-mode access in mixed hydrogen–tritium and pure tritium plasmas at JET with ITER-like wall
The heating power to access the high confinement mode (H-mode), PLH, scales approximately inversely with the isotope mass of the main ion plasma species as found in (protonic) hydrogen, deuterium and tritium plasmas in many fusion facilities over the last decades. In first dedicated L–H transition experiments at the Joint European Torus (JET) tokamak facility with the ITER-like wall (ILW), the power threshold, PLH, was studied systematically in plasmas of pure tritium and hydrogen–tritium mixtures at a magnetic field of 1.8 T and a plasma current of 1.7 MA in order to assess whether this scaling still holds in a metallic wall device. The measured power thresholds, PLH, in Ohmically heated t…
Overview of the JET results in support to ITER
The 2014–2016 JET results are reviewed in the light of their significance for optimising the ITER research plan for the active and non-active operation. More than 60 h of plasma operation with ITER first wall materials successfully took place since its installation in 2011. New multi-machine scaling of the type I-ELM divertor energy flux density to ITER is supported by first principle modelling. ITER relevant disruption experiments and first principle modelling are reported with a set of three disruption mitigation valves mimicking the ITER setup. Insights of the L–H power threshold in Deuterium and Hydrogen are given, stressing the importance of the magnetic configurations and the recent m…
Letter
We present a study of the power threshold for L–H transitions (PLH) in almost pure helium plasmas, obtained in recent experiments at JET with an ITER-like wall (Be wall and W divertor). The most notable new result is that the density at which PLH is minimum, ${\bar{n}}_{\text{e},\mathrm{min}}$, is considerably higher for helium than for deuterium and hydrogen plasmas. We discuss the possible implications for ITER in its pre-fusion operating power phase.
Recent progress in L-H transition studies at JET: tritium, helium, hydrogen and deuterium
Abstract We present an overview of results from a series of L–H transition experiments undertaken at JET since the installation of the ITER-like-wall (JET-ILW), with beryllium wall tiles and a tungsten divertor. Tritium, helium and deuterium plasmas have been investigated. Initial results in tritium show ohmic L–H transitions at low density and the power threshold for the L–H transition (P LH) is lower in tritium plasmas than in deuterium ones at low densities, while we still lack contrasted data to provide a scaling at high densities. In helium plasmas there is a notable shift of the density at which the power threshold is minimum ( n ¯ e , min ) to higher values relative to deuterium and …