0000000000072676
AUTHOR
J. Cascante-vindas
Control of the chromatic dispersion of photonic crystal fibers for supercontinuum and photon pairs generation
The interplay between chromatic dispersion and nonlinear effects is crucial for an efficient exploitation of non linear propagation in photonic crystal fibers (PCF). Once a PCF preform has been prepared, changing the parameters that control the fabrication process it is possible to adjust the dispersion properties of the fiber. In addition, it is particularly useful to develop postprocessing techniques that enable a fine adjustment of the dispersion along a section of PCF. The tapering of PCF, using a fusion and pulling technique, has been established as a rather useful technique to engineer the dispersion properties along tens of centimeters. Some of our recent experiments demonstrate that…
Fabrication of polarizing photonic crystal fibres and photonic crystal fibre tapers: Applications
We report the fabrication of an anisotropic photonic crystal fibre with polarization properties and photonic crystal fibre tapers for supercontinuum generation. The anisotropy of the fibre was created by enlarging four airholes next to the silica core. Different polarization regimes as a function of the geometric parameters, including polarizing behaviour at 1.55 mum, were obtained. In the second part of the paper, we report the fabrication of photonic crystal fibre tapers. We present experimental results on supercontinuum generation in photonic crystal fibre tapers using quasi-continuous pump pulses of 7 ns duration at 532 nm and at 1064 nm.
Tapering photonic crystal fibres for supercontinuum generation with nanosecond pulses at 532nm
Experimental results on supercontinuum generation in photonic crystal fibre tapers using pump pulses of 7 ns duration at 532 nm are presented. Photonic crystal fibre tapers with the first wavelength of zero dispersion around 532 nm were fabricated. The generation of supercontinuum was investigated in normal and anomalous dispersion regimes. Supercontinuum spectra spanning more than 400 nm in the visible region are reported.
Supercontinuum generation in Ge-doped Y-shaped microstructured tapered fiber
We have investigated the generation of supercontinuum in tapered Y-shaped fibers in the nanosecond pump regime. This fiber used to fabricate the tapers has, in addition, a Ge-doped core which enhances the nonlinearity of the material and the Raman gain. The fiber was pumped at 1064 nm in the ns pump regime (0.6 ns pulses and up to 3.2 kW peak power). The taper had a uniform waist of 0.9 μm diameter and 130 mm length, and the adiabatic transitions were 110 mm long. A flat spectrum spanning from 420 nm to 1870 nm was obtained using a single tapered fiber.
Enhanced supercontinuum generation in the nanosecond pump regime using specialty microstructured fibers
Several alternatives have been investigated to achieve enhanced supercontinuum generation in the nanosecond pump regime using specialty silica-based microstructured optical fibers (MOFs). Among these alternatives we can point out the use of (a) MOF tapers, (b) highly Ge-doped core Y-shaped MOF and (c) Er-doped MOF. These specialty MOFs provide either an increased material nonlinear response or a rather small effective area, at the same time that the dispersion characteristics are adjusted to work at different excitation conditions. In our experiments, we have been using either a Q-switched Nd:YAG laser (10 Hz repetition rate) or an Yb-doped fiber laser (2 kHz repetition rate), both emitting…
Supercontinuum Q-switched Yb fiber laser using an intracavity microstructured fiber
We report on an intracavity configuration for supercontinuum generation in a Q-switched Yb fiber laser. The supercontinuum laser includes a section of microstructured fiber within the Q-switched laser cavity. With 380 mW of pump power, the supercontinuum laser can emit broadband pulses of 6 microJ energy and 10 ns temporal width, at repetition rates from few hertz up to 2 kHz. The supercontinuum spectrum spans over a wavelength range in excess of 1.4 microm.
Generation of supercontinuum in erbium-doped microstructured optical fibers
We present experimental results on supercontinuum (SC) generation in Er-doped microstructured optical fibers (MOF) pumped with nanosecond pulses at 1064 nm. The Er doping increases the effective nonlinear refractive index [1]. As a result, nonlinear interactions are enhanced and broad supercontinuum spectra are generated with relatively low pump power. Supercontinuum spectra generated in two fibers with the zero dispersion wavelengths (ZDW) close to the pump wavelength are presented. The first MOF is an endlessly singlemode fiber with normal dispersion at the pump wavelength, while the second fiber is a large air-filling fraction MOF with anomalous dispersion at 1064 nm.
Manufacturing of All-Fiber Q-Switch lasers for supercontinuum generation
This work exposes the fabrication process of an All-Fiber Q-Switch laser and its use as a pump source for the generation of supercontinuum (SCG) with tapered microstructured fiber devices (tapers).
Supercontinuum generation with 532 nm quasi-continuum pulses in photonic crystal fibre tapers
We report experimental results on supercontinuum generation in PCF tapers using quasi-continuous pump pulses of 7 ns duration at 532 nm. SC generation in normal and anomalous dispersion regimes are presented. Introduction Supercontinuum generation (SC) in photonic crystal fibres (PCF), fibre tapers, and PCF tapers has been demonstrated in the past with pump pulses of fs, ps, and tenths of ns duration [1-2]. Here, we present experimental results on SC generation in PCF tapers using quasi-continuous pump pulses of 7 ns duration at 532 nm. Fabrication of the PCF tapers The PCF from which the tapers were made, was a large-air-hole PCF ("cobweb" PCF) with two rings of air holes around a solid si…
Bistable phase locking in rocked lasers
Abstract We investigate analytically and numerically the dynamics of single mode lasers with periodic ac injection (rocked lasers). Such lasers show phase bistability as the phase of the light emitted by such lasers can lock to either of two values shifted by π. Locking regimes for different lasers are studied showing that the system response is strongly modified in class B lasers due to the influence of relaxation oscillations.
White light supercontinuum generation in a Y-shaped microstructured tapered fiber pumped at 1064 nm.
We report the generation of supercontinuum in a Ge-doped Y-shape tapered fiber pumped at 1064 nm in the ns pump regime. The taper was designed to have long taper transitions and a taper waist with a core diameter of 0.9 mum. The large air-filling fraction and diameter of the air-hole microstructure reduces the confinement loss at long wavelengths so, enabling the extension of the spectrum to longer wavelengths. Along the taper transition the zero-dispersion wavelength decreases as the diameter of the taper becomes smaller. The spectral components generated along the taper transition pump the taper waist, enhancing the generation of short wavelengths. A flat spectrum spanning from 420 nm to …
Novel spectra in the supercontinuum generation with applications in the biodiversity conservation
This paper presents some spectra of the supercontinuum generation obtained with microstructured fibers and tapered fiber devices excited with quasi-continuous pumps. These spectra are part of a group (collection) of multiple configurations that were studied and evaluated by our working group, and that could be very useful in LIDAR as well as bio-imaging applications. This work is limited to present some spectra that could be useful in applications of biodiversity conservation. The prototypes for specific applications will be evaluated in future research.