0000000000117696
AUTHOR
O. Bajeat
showing 5 related works from this author
Charge breeding at GANIL: Improvements, results, and comparison with the other facilities
2019
International audience; The 1+/n+ method, based on an ECRIS charge breeder (CB) originally developed at the LPSC laboratory, is now implemented at GANIL for the production of Radioactive Ion Beams (RIBs). Prior to its installation in the middle of the low energy beam line of the SPIRAL1 facility, the 1+/n+ system CB has been modified based on the experiments performed on the CARIBU Facility at Argone National Laboratory. Later, it has been tested at the 1+/n+ LPSC test bench to validate its operation performances. Charge breeding efficiencies as well as charge breeding times have been measured for noble gases and alkali elements. The commissioning phase started at GANIL in the second half-y…
Yields of neutron-rich rubidium and cesium isotopes from fast-neutron induced fission of 238U, obtained by studying their release from a thick ISOL t…
2006
Abstract In the framework of the EURISOL project, the production of neutron-rich isotopes of rubidium and cesium has been studied. The intensities of mass-separated beams of rubidium and cesium isotopes generated from a thick 238 UC x target connected to a surface ionizer have been measured. The release properties of 140 Cs and 91 Rb have been investigated. The obtained results allowed us to determine the relative fission yields of rubidium and cesium isotopes with high accuracy.
New exotic beams from the SPIRAL 1 upgrade
2018
Since 2001, the SPIRAL 1 facility has been one of the pioneering facilities in ISOL techniques for reaccelerating radioactive ion beams: the fragmentation of the heavy ion beams of GANIL on graphite targets and subsequent ionization in the Nanogan ECR ion source has permitted to deliver beams of gaseous elements (He, N, O, F, Ne, Ar, Kr) to numerous experiments. Thanks to the CIME cyclotron, energies up to 20 AMeV could be obtained. In 2014, the facility was stopped to undertake a major upgrade, with the aim to extend the production capabilities of SPIRAL 1 to a number of new elements. This upgrade, which is presently under commissioning, consists in the integration of an ECR booster in the…
A facility for fast-neutron irradiations at Jyväskylä and its use for nuclide cross-section measurements in fission
2013
Abstract An efficient and reliable transport system for fast-neutron irradiations has been built at the Physics Department, Jyvaskyla, Finland. It is constructed from commercial bicycle components and is driven by a computer-controlled stepping motor. It can be operated in single or cyclic mode. The neutron irradiated targets are moved within 1.2 s (full stop to full stop) to a well-shielded position 3 m away where they can be removed or directly investigated by γ spectroscopy. The system has been built with the aim to experimentally verify the calculated production rates of neutron-rich nuclei in the SPIRAL2 uranium target. However, the facility can be used for various kinds of fast-neutro…
Production of neutron-rich surface-ionized nuclides at PARRNe
2002
Yields of neutron-rich isotopes produced by fast neutron induced fission of 238 U were measured at the ISOL set-up Production dAtomes Radioactifs Riches en Neutrons. A surface ion source was used to ionize selectively elements with low ionization potentials. In order to observe also the most n-rich isotopes, the identification was achieved by a combined measurement of b- and c-rays and b-delayed neutrons. The flux of fast neutrons inducing fission was generated by a 1 lA beam of 26 MeV deuterons stopped in a graphite converter. The target was a standard ISOLDE type 238 UC