Urban Waste as Resource for Sustainable Environment

2013

The emerging model of waste disposal, develops an integrated approach based on waste reduction, selection, recycling, energy recovery and residual use of landfill. Here we discuss the fundamentals of a proper planning of waste disposal system, specially the thermal recovery, the integration and the methodological approach, either from the environmental and economic point of view. The growing demand for energy, the resulting environmental problems due to satisfy the demand for energy and the complex-economic system, necessitate the study of new technologies such as energy from municipal solid waste (MSW) obtaining as a result of decrease huge mass of solid waste to sanitary landifill and emi…

Design of Bilateral Switched Reluctance Linear Generator to Convert Wave Energy: Case Study in Sicily

2013

The aim of this work is a case study of the adaptation bilateral switched reluctance linear generator to the exploitation of energy of the sea. This type of generator can be used to convert wave energy in electrical energy. In this paper we present an analytical sizing and FEM simulation. As for the results, analysis of the data extracted through the simulations it was possible to calculate the emf. The emf was calculated in two cases of motion of the slider: first hypothesis has set the constant speed while the second is a variable speed according to the law of an oscillatory motion of the sea.

Energy Savings through Integration of the Illumination Natural and Artificial, Using a System of Automatic Dimming: Case Study

2013

The reduction of electrical energy consumption in buildings is a subject of great interest in the international scientific community. In buildings with a lot of available natural light, designed with large glazed surfaces, the artificial lighting system is often oversized and cannot be divided into segments to meet lighting demands during daylight hours.This article presents an experimental study, conducted in a university lecture hall that has a glazed surface covering the whole wall at one end, which provides a level of internal illumination that is only sufficient for the area next to the window itself, even when the outside lighting conditions are very bright. It is therefore necessary …

A Case Study to evaluate the indoor global quality

2013

This paper proposes two complementary procedures for assessing the global quality comfort: the first one, prevalently objective, is based on the acquisition of microclimate measured data and computed subjective values; the second one, that is purely subjective, uses a questionnaire drawn from the ISO/DP 10551 Recommendation. An application to some lecture-halls and laboratories of the school is here showed.

Indoor Environmental Quality Survey: A Brief Comparison between Different Post Occupancy Evaluation Methods

2013

Building occupants are important factor in giving information on indoor conditions such as comfort, productivity, building performance and occupants ́ health. Even that, being their appraisal mainly based on subjective judgments, it is difficult to set up a standard and objective method for this purpose. The present work aimed to describe, analyze and compare the most common tests on this topic, in order to highlight critical, failings and strengths.

Energy and Economic Comparison of Different Conditioning System among Traditional and Eco-Sustainable Building

2013

The use of bioclimatic principles can reduce energy demands and CO2 emissions in the building sector [1-. Costs are one of the most important barriers to a widespread adoption of the green architecture technologies [4-. The aim of this study is to compare the energy and economic performances of two buildings: a real residential bioclimatic building located in Cinisi (a small town near Palermo, Sicily) and an imaginary residential building supposed having the same geographical location, cubature, shape and orientation as the bioclimatic building but built by conventional building materials. The tools used for this study were TRNSYS and HOMER

Are the best available technologies the only viable for energy interventions in historical buildings?

2015

Worth aged buildings represent among the existing buildings a special case when it comes to their energy refurbishment. Unfortunately, the available technologies for building components characterized by high level of thermal performances show, not rarely, a limited compatibility with the architectural integrity of the building. In other words, the so-called Best Available Technologies, which are effectively adopted to optimize the building energy performances, in case of buildings to which a certain artistic, historic and/or architectural merit is recognized, i.e. heritage houses, might determine such kind of conflicts. This situation may lead to the selection of “non-invasive” but less per…

Experimental Evidence on the Thermal Performance of Opaque Surfaces in Mediterranean Climate

2013

The thermal insulation of buildings, intended as wrap feature which determines the dispersion of heat, the reference parameter is necessary to contain the thermal losses during the winter season. The transmittance of the opaque components, used as an indicator of the energy quality of a casing, together with the overall coefficient of dispersion, represents a proper descriptor of the behavior during the heating season. However, if a strong insulation in winter conditions brings only positive effects, the same cannot be said for the summer conditions. A high value of the insulation in the casing is convenient only when the gains free, either in the form of solar contribution that of endogeno…

Regional policies for sustainability in the Mediterranean countries: the role of a proper HVAC system maintenance in museums

2013

Italy, like several Mediterranean countries, holds a very large number of cultural artifacts that are often exhibited and saved inside museums. Museums are usually part of historical buildings that, not rarely, originally had a different intended use and that have been currently transformed in place for conservation and for exhibition of works of art. The use of historical buildings as museums leads to limitations in the management and distribution of exhibition space, in design and managing HVAC systems and in the achievement of targets relating to the continuous monitoring of the microclimate for people comfort and for preservation of works of art. Moreover, the costs of the operation and…

Are the Best Available Technologies the only viable for energy interventions in historical buildings?

2014

Worth aged buildings represent among the existing buildings a special case when it comes to their energy refurbishment. Current available technologies for building components, characterized by high level of thermal performances, unfortunately, are also characterized, not rarely, by limited compatibility with the architectural integrity of the building. In other words, the so-called Best Available Technologies that are effectively adopted to optimize the energy performances of buildings, in the case of aged buildings to which a certain artistic, historic and/or architectural merit is recognized (heritage houses) could, actually, determine such kind of conflicts and therefore leading to the s…

Indagine sulle condizioni del microclima luminoso di una sala lettura. Un approccio multidisciplinare.

2010

A Mathematical Model For Evaluating Energy Consumptions In Life Cycle Assessment.

2014

This paper takes up the ecobalance topic giving prominence to a calculation procedure of necessary energy consumptions for the production of a product in the different phases of a whole life cycle. Are used to identify all stages of the life cycle are determined and simplified formulas for the calculation of specific energy consumption. Is also examined a case where the components of the final product are up to 8. The model is valid for any type of product and through operations research (ie, placing constraints on the variables) you could get to optimal solutions minimizing the objective function.

Evaluation through adaptive model (ATC) in the levels of thermal comfort in summer in offices in Mediterranea locations.

2014

The design of the building-plant system in the case of office buildings has rarely considered the adaptive model of comfort almost always limited to the control of temperature and humidity and only in some cases of PMV and PPD. Specifically when the building interacts with a climate characterized by high values of external temperature and humidity for long periods, and with high solar radiation in the presence of large glazed areas, it is crucial to take into account relevant aspects of the principle of thermal adaptation. The long stay of the occupants in an air-conditioned environment leads, at the request of colder temperatures very distant from those indicated by the criteria of accepta…

Experimental Evidence on the Thermal Performance of Opaque Surfaces in Mediterranean Climate

2013

The thermal insulation of buildings, intended as wrap feature which determines the dispersion of heat, the reference parameter is necessary to contain the thermal losses during the winter season. The transmittance of the opaque components, used as an indicator of the energy quality of a casing, together with the overall coefficient of dispersion, represents a proper descriptor of the behavior during the heating season. However, if a strong insulation in winter conditions brings only positive effects, the same cannot be said for the summer conditions. A high value of the insulation in the casing is convenient only when the gains free, either in the form of solar contribution that of endogeno…