0000000000172051
AUTHOR
Philip D. P. Taylor
The International Measurement Evaluation Programme (IMEP) IMEP-6: "Trace elements in water"
The sixth round of the International Measurement Evaluation Programme (IMEP) is presented. The programme offers reference values, established by primary methods of measurement, against which participating laboratories can evaluate their performance. The degree of comparability is thus established against the most objective references available at present. In IMEP-6, reference values for total concentrations of 14 trace elements in a synthetic and a natural water were established mainly by isotope dilution mass spectrometry (IDMS). For the majority of the measurands, results traceable to the international system of units (SI) and having expanded uncertainties, U (k=2), of 2% could be establi…
Certification of a 41Ca dose material for use in human studies (IRMM-3703) and a corresponding set of isotope reference materials for 41Ca measurements (IRMM-3701)
Abstract The long-living radioisotope 41Ca could overcome current limitations in assessing the impact of interventions on bone health in controlled human studies. Changes in bone Ca metabolism can be identified directly via the induced changes in 41Ca excretion from 41Ca-labelled bones via the n(41Ca)/n(40Ca) ratio in urine. A 41Ca dose material (IRMM-3703), for use in human studies, was produced by IRMM within the EC funded project OSTEODIET. The 41Ca base material was purified and the purified solution is certified for both isotopic composition and amount content by isotope dilution mass spectrometry. The 44Ca-enriched isotope reference material, IM-6009, was used as spike and the natural…
Producing SI-traceable reference values for Cd, Cr and Pb amount contents in polyethylene samples from the Polymer Elemental Reference Material (PERM) project using isotope dilution mass spectrometry
The present paper describes the certification of the amount content of Cd, Cr and Pb in two different polyethylene materials within the third phase of the Polyethylene Elemental Reference Material (PERM) project. The analytical procedure to establish the reference values for Cd, Cr and Pb amount contents in these materials is based on isotope dilution mass spectrometry used as a primary method of measurement. Cd and Pb were measured with inductively coupled plasma-mass spectrometry and Cr with positive thermal ionization-mass spectrometry. The decomposition of the polymer matrix was carried out using a high pressure asher. Reference values for amount content, traceable to the SI-system, hav…