0000000000208849
AUTHOR
V. Ferraro
Performance evaluation of a multisource renewable power converter prototype
Achieving maximum power transfer in a multi-source renewable system
In this paper, a multi-source DC-DC power system is proposed for renewable applications. A multi-input, single inductor power converter controlled by two interacting control loops is designed. The steady-state and small-signal analysis of the designed system is carried out. A battery-photovoltaic system is designed as an application example. Both the output voltage and maximum power point of solar panels are properly controlled to achieve high performances of the whole system. Experimental results on a 48 V laboratory prototype are presented to discuss system performances.
Design of a solar-battery-thermoelectric power converter prototype
In this paper a multisource renewable energy system for high-current applications is proposed. The power architecture is based on a multi-input power converter including control and reconfiguration subsystems. Independently of the type of connected renewable sources, a proper control of the output DC voltage bus is provided as well as a proper control on the operating point of each renewable source to achieve the maximum power transfer. A 48V thermoelectric-photovoltaic-battery system in a three input configuration is designed. Three interacting feedback networks are implemented: the outer loop which controls the output voltage and as many inner loops as connected renewable sources to achie…
A measurement setup for electric bicycles powered from renewable energy sources
In this paper a measurement system for a pedalassist rickshaw is described. It has been designed and realized with the purpose of a deep analysis of operating time, range and general performance of the prototype vehicle. The three-wheel velocipede under test, developed in the SDES laboratory of the University of Palermo, is equipped with two battery packs, and a photovoltaic panel which is used to recharge one of the packs at a time. To further improve the autonomy of this mean, a fuel cell will be added as a power source, whose consequent improvement in performance could be easily investigated by the presented measurement setup. An Arduino board has been employed to receive and store all c…
Changes in surgicaL behaviOrs dUring the CoviD-19 pandemic. The SICE CLOUD19 Study
Abstract Background The spread of the SARS-CoV2 virus, which causes COVID-19 disease, profoundly impacted the surgical community. Recommendations have been published to manage patients needing surgery during the COVID-19 pandemic. This survey, under the aegis of the Italian Society of Endoscopic Surgery, aims to analyze how Italian surgeons have changed their practice during the pandemic. Methods The authors designed an online survey that was circulated for completion to the Italian departments of general surgery registered in the Italian Ministry of Health database in December 2020. Questions were divided into three sections: hospital organization, screening policies, and safety profile of…
The critical view of safety during laparoscopic cholecystectomy: Strasberg Yes or No? An Italian Multicentre study
Abstract Background Laparoscopic cholecystectomy is considered the gold standard for the treatment of gallbladder lithiasis; nevertheless, the incidence of bile duct injuries (BDI) is still high (0.3–0.8%) compared to open cholecystectomy (0.2%). In 1995, Strasberg introduced the "Critical View of Safety" (CVS) to reduce the risk of BDI. Despite its widespread use, the scientific evidence supporting this technique to prevent BDI is controversial. Methods Between March 2017 and March 2019, the data of patients submitted to laparoscopic cholecystectomy in 30 Italian surgical departments were collected on a national database. A survey was submitted to all members of Italian Digestive Pathology…
Design and control of a novel multi-source renewable energy system
In this paper, a novel multi-input, single-inductor architecture is proposed. An innovative hysteretic control strategy of both the output voltage and the sources operating point control is designed and tested. Benefits brought by the proposed architecture over existing solutions are widely investigated. As an example, the design of a 48 V dual input system which is fed by photovoltaic and thermo-electric generators is proposed. Design guidelines are given and simulation results are presented to test the efficiency of the proposed architecture.
A multi-input, single-inductor power system for multisource energy harvesting
Today, energy harvesting is drawing a great deal of attention due to modern trends in energy saving and sustainable development purposes. Among renewable energy sources fuel cells and photovoltaic arrays are the most promising for a wide variety of applications, ranging from few mWatts of wireless sensor networks to kWatts for household appliances. Coupling several harvesters and renewable sources is the winning strategy to ensure a proper supply overcoming the uncertainty and limited availability of common harvesters and renewable sources. Multisource energy harvesting is actually an open research topic involving several pressing and often conflicting requirements. System cost, complexity,…