0000000000235193

AUTHOR

Riccardo Campo

New applications in integrated fixed film activated sludge-membrane bioreactor (IFAS-MBR) systems

Abstract This chapter provides an overview on the development and application of integrated fixed film activated sludge-membrane bioreactor (IFAS-MBR) systems. IFAS-MBRs represent a novel configuration for advanced wastewater treatment, and only a few studies are available in literature. With this aim, the results of some studies on IFAS-MBR systems already published are discussed and compared in this chapter. Literature shows that the influent carbon to nitrogen ratio (C/N) strongly affects the biological process in IFAS-MBR. The organic matter removal efficiency (removed biologically) decreases from 60% to 23.5% with the decrease of influent C/N from 10 to 2 mgCOD mgTN− 1. Nitrogen remova…

research product

Aerobic granular sludge treating shipboard slop: Analysis of total petroleum hydrocarbons loading rates on performances and stability

Abstract The work focuses on the feasibility of treating slop with aerobic granular sludge. For this purpose, a 3.5 L granular sequencing batch reactor was activated and it was monitored for 156 days. The experimental campaign was divided into two periods, named Period I (100 days) and Period II (56 days). Total Petroleum Hydrocarbon (TPH) concentration in the slop was, on average, equal to 6.8 ± 1.5 mg L−1 and 13 ± 1.5 mg L−1 in Period I and Period II respectively. The obtained results during the first experimental period indicated that about 80 days were required to reach steady state with mature granules, when TPHs removal efficiency was approximately 90%. The results indicated that both…

research product

Study of aerobic granular sludge stability in a continuous-flow membrane bioreactor.

A granular continuous-flow membrane bioreactor with a novel hydrodynamic configuration was developed to evaluate the stability of aerobic granular sludge (AGS). Under continuous-flow operation (Period I), AGS rapidly lost their structural integrity resulting in loose and fluffy microbial aggregates in which filamentous bacteria were dominant. The intermittent feeding (Period II) allowed obtaining the succession of feast and famine conditions that favored the increase in AGS stability. Although no further breakage occurred, the formation of new granules was very limited, owing to the absence of the hydraulic selection pressure. These results noted the necessity to ensure, on the one hand the…

research product

Reactivation of aerobic granular sludge for the treatment of industrial shipboard slop wastewater: Effects of long-term storage on granules structure, biofilm activity and microbial community

Abstract This work reports on reactivation of aerobic granular sludge (AGS) for the treatment of industrial recalcitrant wastewater (slop wastewater) characterized by high salinity and hydrocarbons. AGS were reactivated in two reactors, R1 and R2, to treat industrial slop wastewater after a long-term storage for 12-months at 4 °C. In R1, salt-adapted mature aerobic granules were previously subjected to a step-wise increase of hydrocarbons, whereas in R2 aerobic granules were previously cultivated in presence of salinity and hydrocarbons. After a short-term reactivation period, the slop dosage caused a simultaneous decrease of granules dimensions and proteins/polysaccharides (PN/PS) ratio do…

research product

The role of extracellular polymeric substances on aerobic granulation with stepwise increase of salinity

Abstract A granular sequencing batch reactor (GSBR) worked for 164 days to study the effect of salinity on aerobic granulation. The feeding had an organic loading rate (OLR) of 1.6 kg COD⋅m −3 ⋅d −1 and a gradual increase of salinity (from 0.30 to 38 g NaCl − ⋅L −1 ) to promote a biological salt-adaptation. First aggregates (average diameter ≈ 0.4 mm) appeared after 14 days. Extracellular polymeric substances (EPSs) analyses revealed that proteins were mainly higher than polysaccharides, and microorganisms metabolized EPSs as additional carbon source, mostly in feast phase, to face the energy demand for salinity adaptation. No significant worsening of organic matter removal was observed. Th…

research product

Cultivation of granular sludge with hypersaline oily wastewater

The time required to stabilise mature aerobic granules is rather variable. In addition, cultivation time and the structural characteristics of granules seem to be related to the nature of wastewater influent. Granular sludge has been used for the treatment of several industrial wastewaters, but nothing has been reported about wastewater characterized by the simultaneous presence of hydrocarbons and high chloride concentration. In this work, the authors analysed the granulation process and performance as well as the physical characteristics of aerobic granules in two Granular Sequencing Batch Airlift Reactors (GSBARs), fed with acetate-based synthetic wastewater in reactor 1 (R1) and with a …

research product

Membrane bioreactors sludge: From production to disposal

Abstract This chapter reviews the MBR activated sludge from production to disposal. Starting from sludge characterization, the chapter first presents the features of MBR sludge (morphology and EPS chemical composition), also in terms of differences with the activated sludge from conventional activated sludge plants. Sludge dewaterability is then discussed, focusing on the differences between aerobically and anaerobically digested sludge. An analysis of the costs related to MBR sludge treatment and disposal also is presented in order to provide a framework for a sustainable MBR sludge management.

research product

The role of EPS in the foaming and fouling for a MBR operated in intermittent aeration conditions

Abstract This work investigates the causes of foaming and fouling in an Intermittent Aerated – Membrane BioReactor (IA-MBR) used for wastewater treatment. The experiment was divided into three periods with different aerated regimes expressed with different t aeration /t cycle ratio (Period I: 60 min/180 min, Period II: 80 min/180 min, Period III: 30 min/90 min). The advanced foaming tests used allow the study of the role of extracellular polymeric substances (EPSs) on foaming and fouling. In general, in the Periods I and II, good correlations between the EPSs and the Modified Scum Index without purification (MSI 0 ) and the Foam Power were observed. The results shown that the filamentous mi…

research product