Bi-Layer GaOHPc:PCBM/P3HT:PCBM Organic Solar Cell

Electrodes for GaOHPc:PCBM/P3HT:PCBM bulk heterojunction solar cell

Abstract The bulk heterojunction approach appears to be one of the most promising concepts of creating efficient, low cost and easily producible organic solar cells. For this purpose one of the best materials was regioregular poly-3-hexylthiophene (P3HT), which is widely used as a donor molecule and a hole transporter, with soluble fullerene derivative (PCBM) as an acceptor and electron transporter. The main drawback of this highly efficient blend is its limited spectral range, covering only a 350–650 nm spectral interval. So the main aim of the present work was to extend the spectral range of the cell up to 850 nm by adding a second bulk heterojunction layer of complementary absorption spe…

Influence of the Preparation Method on Planar Perovskite CH 3 NH 3 PbI 3-x Cl x Solar Cell Performance and Hysteresis

The present research has been supported by the State Research Programme “LATENERGI” and National Research Programme “Multifunctional Materials and Composites, Photonics and Nanotechnology (IMIS2)”.

Perovskite CH3NH3PbI3–XClx Solar Cells. Experimental Study of Initial Degradation Kinetics and Fill Factor Spectral Dependence

The main drawback of the methylammonium lead halide perovskite solar cells is their degradation in ambient atmosphere. To investigate ambient-air-induced cell degradation, spec-tral dependencies of open-circuit voltage (VOC), fill factor (FF) and the power conversion effi-ciency (PCE) have been acquired (for the first time reported in literature). Our custom-made measurement system allowed us to perform measurements of the above-mentioned entities in situ directly in vacuum during and after thermal deposition of the elec-trode. We also studied how these parameters in vacuum changed after cell exposure to ambient air for 85 min (50 nm top electrode) and for 180 min (100 nm top Ag electrode).…

PV effect of fullerene/poly(3-hexylthiophene) blend sensitized by phthalocyanine having infrared absorption CT band

An attempt was made to extend the photosensitivity spectral range of fullerene/poly(3-hexylthiophene) blend to NIR region by adding extra electron donor — hydroxygallium phthalocyanine (GaOHPc) with a strong and wide intermolecular charge transfer (CT) band around 830 nm. Multilayer cells of ITO/PEDOT: PSS/6 GaOHPc/P3HT: C61(CO2Et)2 have been prepared by spin coating with vacuum evaporated Al or In top electrodes. Significant photosensitivity of the cells was in 370–900 nm spectral range. However charge carrier photogeneration efficiency was 3 times higher for illumination in P3HT absorption band as compared with the GaOHPc CT band at 830 nm. But when GaOHPc was mixed in the blend forming P…

Perovskite CH3NH3PbI3–XClx Solar Cells and their Degradation (Part 1: A Short Review)

Development of hybrid organic-inorganic perovskite solar cells (PSC) has been one of the hottest research topics since 2013. Within brief literature review, we would like to achieve two objectives. Firstly, we would like to indicate that a whole set of physical properties, such as high change carrier mobility, very low recombination rates, large carrier life time and diffu-sion length, large absorption coefficients and very weak exciton binding energies, are defining high power conversion efficiency (PCE) of methyl ammonium lead trihalide SC. The second objective is to draw attention to some, in our opinion, important aspects that previously have not been satisfactory addressed in literatur…