0000000000241473
AUTHOR
Sami Bayoudh
Application of molecularly imprinted polymers in supercritical fluid chromatography
Molecularly imprinted polymers (MIPs), for the templates free base racemic propranolol and the L-enantiomer of phenylalanine anilide (L-PA), were investigated as stationary phases in supercritical fluid chromatography (SFC). Large retention differences were observed on the propranolol MIP for both the template molecule and the structural analogue metoprolol compared to that observed on the corresponding blank polymer. Mobile phase composition and solute concentration were found to affect this retention behaviour. The phenylalanine anilide MIP (L-PA MIP) was found to be enantioselective in SFC with stronger retention observed for the template enantiomer. Throughout the study, characteristic …
Development of a semiautomated procedure for the synthesis and evaluation of molecularly imprinted polymers applied to the search for functional monomers for phenytoin and nifedipine
Abstract A previously described scaled-down version of the established monolith procedure, where molecularly imprinted polymers (MIPs) are prepared on the bottom surface of chromatographic vials [Anal. Chem. 71 (1999) 2092] has been here further optimised with respect to its full automation. The protocol results in savings of time and reagents compared to the monolith procedure, allowing ca. 60 polymers (∼50 mg each) to be synthesised in parallel. Both blank and imprinted polymers are then evaluated in situ by equilibrium batch rebinding tests. Each step in the synthesis and evaluation was considered with the aim of achieving an automated method with wide applicability with regards to templ…
Evaluation of methods aimed at complete removal of template from molecularly imprinted polymers
Polymers imprinted with clenbuterol were used to study the influence of various post-polymerization treatments [e.g., thermal annealing, microwave assisted extraction (MAE), Soxhlet extraction and supercritical fluid template desorption] on the bleeding of residual template. The aim of the study was to reduce the bleeding to levels that would allow the use of the materials as affinity phases for extraction of clenbuterol from bovine urine at concentrations below 1 ng ml−1. After treatment, the clenbuterol imprinted polymers were packed into solid-phase extraction columns and the bleeding was estimated by quantifying the amount of template released in 10 ml of methanol–acetic acid (9 + 1 v/v…