0000000000254970
AUTHOR
M. A. Rebolledo
Erbium-Doped-Silica Photonic Crystal Fiber Characterization Method: Description and Experimental Check
The present paper reports and discusses a characterization method for erbium-doped-silica photonic crystal fibers based on the measurement of pump power attenuation and gain together with the McCumber theory. The absorption and emission cross sections and the passive losses of the fiber were obtained from a fitting procedure of theoretical to experimental values. The method was checked by means of a home-made photonic crystal fiber to verify its reliability. Finally, it was found that the characteristic parameters obtained by this method can be used to accurately simulate the performance of the fiber and therefore to design devices based on it.
Study of upconversion in highly Er-doped photonic crystal fibers through laser-transient dynamics
The dynamic response after pump switch-on of a 980 nm pumped-ring laser based on an active photonic crystal fiber with an Er3+ ion concentration of ≈1020 ions cm−3 was registered. Then a numerical fitting procedure of a theoretical model was followed to the experimental values of the relaxation oscillation parameters as a function of the input pump power. Non-radiative energy-transfer mechanisms’ coefficients: homogeneous upconversion coefficient (Cup) and critical radii for upconversion (Ru) and migration (Rm) were determined. The calculated best-fit coefficients (Cup = 1.3 × 10−24 m3 s−1, Ru = 9 × 10−10 m, Rm = 13 × 10−10 m) were compared to those obtained with other steady-state an…
Tecnologías fotónicas y comunicaciones ópticas
El presente trabajo tiene por objeto presentar una visión de las tecnologías fotónicas orientada fundamentalmente a su aplicación en telecomunicaciones.
Er-doped photonic crystal fibre characterization method based on McCumber theory
Characterization and modeling of Er-doped fibres [1] allowed in the past years fruitful developments of amplifiers and lasers. Since in a conventional fibre monomodal propagation of light is achieved in a very short length (once energy of other modes has been radiated) the cutback technique has been successfully used to determine absorption cross sections at the pump and gain band wavelengths. Emission cross sections have been usually determined instead from the measurement of gain or amplified spontaneous emission (ASE) spectrum together with the use of theoretical models. In a photonic crystal fibre (PCF) the limited size of the air-holes lattice originates energy radiation from the highe…
Dynamic Characterization of Upconversion in Highly Er-Doped Silica Photonic Crystal Fibers
Measurements of time evolution of amplified spontaneous emission for square-wave modulated pump were made on a highly erbium-doped silica photonic crystal fiber and fitted to theoretical results calculated using different formalisms to describe the ${\rm Er}^{3+}$ -ion migration-assisted co-operative upconversion mechanism in the population densities rate equations. The determined characterization parameters are the constant homogeneous upconversion coefficient, 3.0 $\times 10^{-24}~{\rm m}^{3}/{\rm s}$ , the critical radii for upconversion and migration, 10.5 and 14A, respectively, and the rate of clustered ions, 14%. These parameters are analysed and compared to those obtained with contin…