Screening of subtelomeric rearrangements in autism spectrum disorder. Identification of a partial trisomy of 13q in a patient

Screening of subtelomeric rearrangements in autism spectrum disorder. Identification of a partial trisomy of 13q in a patient.

EMI Analysis in a Power Drive System when the Grounding System is Exited by a Lightning Strike Using a Suitable Circuital Model

High-Frequency Experimental Characterization and Modeling of Six Pack IGBTs Power Modules

In this paper, a method to characterize the high-frequency (HF) behavior of six pack insulated gate bipolar transistors (IGBTs) power module (PM) is presented. The method is based on experimental measurements at the external pins of the device and it allows one to extract internal inductive and capacitive parasitic coupling without the knowledge of structural and physical parameters of the PM. The HF model of a six pack IGBTs PM has been developed, in the frequency range of 150 kHz-30 MHz, and it has been implemented in MATLAB environment. The method has been experimentally validated by comparing the frequency behavior of the PM with the simulated response. Moreover, the HF conducted distur…

An Improved Load Flow Method for MV Networks Based on LV Load Measurements and Estimations

A novel measurement approach for power-flow analysis in medium-voltage (MV) networks, based on load power measurements at low-voltage level in each secondary substation (SS) and only one voltage measurement at the MV level at primary substation busbars, was proposed by the authors in previous works. In this paper, the method is improved to cover the case of temporary unavailability of load power measurements in some SSs. In particular, a new load power estimation method based on artificial neural networks (ANNs) is proposed. The method uses historical data to train the ANNs and the real-time available measurements to obtain the load estimations. The load-flow algorithm is applied with the e…

New circuital models of grounding systems and PDS for EMI analysis during a lightning strike

In this paper circuital models of a Power Drive System (PDS) and of grounding systems are proposed in order to analyse Electromagnetic Interferences (EMI) induced in a PDS when a lightning current flows in the grounding system. The models have been developed adopting the network approach with lumped parameters and have been implemented using the software MATLAB. A High Frequency (HF) model suitable to simulate the impulse response of a PDS is described and a generalized method in order to calculate the lumped parameters values of grounding system models is presented. The new method takes into account the burial depth of electrodes as regards their length. The validation results of this new …

High frequency modeling technique for three phase power electronics module

Nowadays, the high integrated power electronics modules (PMs), characterized by high speed, low loss and hard ware miniaturization, represent a new technology that meets the emerging demands of many applications, such us vehicle and home appliance, renewable energy sources in smart grid. The integration process and the high switching speeds increase the PM electromagnetic emissions that can create electromagnetic interference (EMI) with electric/electronic devices near the PMs. For this reason, electromagnetic compatibility (EMC) have to be carefully considered, yet in the design phase, to guarantee the reliability of PM systems. In this paper a method to develop a high frequency (HF) model…

Environmental Data Processing by Clustering Methods for Energy Forecast and Planning

This paper presents a statistical approach based on the k-means clustering technique to manage environmental sampled data to evaluate and to forecast of the energy deliverable by different renewable sources in a given site. In particular, wind speed and solar irradiance sampled data are studied in association to the energy capability of a wind generator and a photovoltaic (PV) plant, respectively. The proposed method allows the sub-sets of useful data, describing the energy capability of a site, to be extracted from a set of experimental observations belonging the considered site. The data collection is performed in Sicily, in the south of Italy, as case study. As far as the wind generation…

Electromagnetic immunity analysis of a new interface device with power line communication for smart grid and energy storage applications

An analysis of EMC standards related to smart grid devices with PLC port has been carried out and the standardization lacks have been pointed out with reference to the evaluation of electromagnetic immunity to narrowband, coming from other communication systems connected to the grid, and RF disturbances conducted disturbances, usually present in a power grid. In particular, the paper analyses the electromagnetic conducted immunity of a new interface protection device (ID) for smart grid and energy storage applications. The new ID is equipped with a measuring board, a STM32 microcontroller, for data elaboration and memorization, and a ST7580 N-PSK powerline transceiver. An experimental test …

Electric and magnetic emission in near field region and thermal behaviour of power module for photovoltaic application

The new power module, characterized by high power density, miniaturization of packages and layout and high frequency switching, are increasingly used in the field of in automotive, aircraft industry and for Distributed Generation (DG) connected to smart grid. To guarantee the reliability and safety of these systems, the electromagnetic compatibility (EMC) and thermal behavior, have to be carefully considered for these appliances. This paper describes a measurement methodology to characterize the electromagnetic emissions in near field zone produced by a PM prototype and its thermal behavior. In particular, the electric and magnetic fields, in the near field region in the frequency range 9kH…

EMI Analysis in Electrical Drives under Lightning Surge Conditions

In this paper, a complete model of a power drive system including the earth electrodes is proposed to evaluate electromagnetic conducted interference due to lightning pulses. Circuit model of a power drive system is joined with a full-wave approach for the simulation of the time behavior of the grounding system. The proposed model enables to predict the electromagnetic conducted interference generated in the power drive system when lightning conditions involve the earth electrodes.

New circuital models of grounding systems and PDS for EMI analysis during a lightning stike

Measurements methodology for the reliability evaluation of intelligent power modules

The paper describes a measurement methodology for the reliability evaluation of new intelligent power electronics modules (IPMs). In particular, the evaluation of the IPMs immunity to radio frequency conducted disturbances has been performed, at different operating thermal conditions, designing a suitable measurement set up in a shielded room. Moreover, the thermal performances of the devices have been analyzed, setting up a proper experimental test bench. The measurements procedures are detailed described. © 2014 IEEE.