0000000000295038
AUTHOR
I. Sacco
Electromagnetic shielding efficiency in Ka-band: carbon foam versus epoxy/carbon nanotube composites
The wide application of microwaves stimulates searching for new materials with high electrical conductivity and electromagnetic (EM) interference shielding effectiveness (SE). We conducted a comparative study of EM SE in K a -band demonstrated by ultra-light micro-structural porous carbon solids (carbon foams) of different bulk densities, 0.042 to 0.150 g/cm 3 , and conventional flexible epoxy resin filled with carbon nanotubes (CNTs) in small concentrations, 1.5 wt.%. Microwave probing of carbon foams showed that the transmission through a 2 mm-thick layer strongly decreases with decreasing the pore size up to the level of 0.6%, due to a rise of reflectance ability. At the same time, 1 mm…
Preliminary studies on nanocomposite based on high quality Silicon Carbide nanofibers
Nanocomposites are nowadays the most promising new materials due to their unique properties (such as high mechanical strength, chemical and thermal resistance). The nanocomposite matrix is blended with a nanostructured filler. In this study, Silicon Carbide nanofibers (NFSiC) and their bundles were tested as a reinforcement of two epoxy resins: EPIKOTE 828 and EL 20. PAP-4 (33 phr) and P-900 (40 phr) were used as hardeners in the two cases, respectively. Several samples were prepared in the range between 0.1 and 5 % wt for both types of resins and fillers (NFSiC and NFSiC bundles). Mechanical and electrical properties were tested. The fillers were obtained using a new simple, fast, low-cost…