0000000000309041
AUTHOR
Na Liu
Novel plasmonic sensor design using plasmon-induced transparency
We introduce a novel sensor concept in the field of plasmonics, namely plasmon-induced transparency sensors. These sensors combine localized particle plasmon resonances with extremely small sensing volume with excellent sharp spectral resonances that show a good respose to refractive index changes of the surrounding environment. The principle is based on the plasmonic analog of electromagnetically induced transparency (EIT) between a radiative dipole and a nonradiative quadrupole antenna. This effect yields a spectrally narrow resonance within a broad localized particle plasmon resonance in the near-infrared spectral region [1, 2]. Using deposition of biotin and streptavidin, we demonstrate…
Planar metamaterial analogue of electromagnetically induced transparency for plasmonic sensing.
We experimentally demonstrate a planar metamaterial analogue of electromagnetically induced transparency at optical frequencies. The structure consists of an optically bright dipole antenna and an optically dark quadrupole antenna, which are cut-out structures in a thin gold film. A pronounced coupling-induced reflectance peak is observed within a broad resonance spectrum. A metamaterial sensor based on these coupling effects is experimentally demonstrated and yields a sensitivity of 588 nm/RIU and a figure of merit of 3.8.
Sampling procedure in a willow plantation for chemical elements important for biomass combustion quality
Willow (Salix spp.) is expected to contribute significantly to the woody bioenergy system in the future, so more information on how to sample the quality of the willow biomass is needed. The objectives of this study were to investigate the spatial variation of elements within shoots of a willow clone ‘Tordis’, and to reveal the relationship between sampling position, shoot diameters, and distribution of elements. Five Tordis willow shoots were cut into 10–50 cm sections from base to top. The ash content and concentration of twelve elements (Al, Ca, Cd, Cu, Fe, K, Mg, Mn, Na, P, Si, and Zn) in each section were determined. The results showed large spatial variation in the distribution of mos…
Sampling procedure in a willow plantation for estimation of moisture content
Abstract Heating value and fuel quality of wood is closely connected to moisture content. In this work the variation of moisture content (MC) of short rotation coppice (SRC) willow shoots is described for five clones during one harvesting season. Subsequently an appropriate sampling procedure minimising labour costs and sampling uncertainty is proposed, where the MC of a single stem section with the length of 10–50 cm corresponds to the mean shoot moisture content (MSMC) with a bias of maximum 11 g kg −1 . This bias can be reduced by selecting the stem section according to the particular clone. The average difference in MSMC between the largest and smallest shoot in a stump was 31 g kg −1 .…