Reduction of the uncertainty in the measurements of magnetic fields
The paper deals with magnetic field measurement, carried out by using a broadband and isotropic instrument. These measurements are characterized by a very high uncertainty values if compared with the ones usually related to other electrical measurements. For these reasons, if the measurements are performed to assess the exposure of human beings, these large uncertainty values imply a high risk of wrong decision when there is the need to establish if a site complies or does not comply with a specified emission limits. A reduction of the uncertainty values implies a reduction of the risk. With this aim, we propose an approach which, in particular but very typical cases, allows an effective re…
New approach for harmonic mitigation in single-phase five-level CHBMI with fundamental frequency switching
The main objective of this paper is to study and analyse the voltage output waveform of a multilevel inverter, to suggest a new approach for harmonic mitigation improving the converter performance. These last type of converters represent a new technology in the field of DC/AC electrical energy conversion, presenting advantages respect to the traditional converters. In fact, the multilevel power converters present a low harmonic content and a high voltage level. The paper considers a five-level single-phase cascaded H-bridge inverter and fundamental frequency modulation techniques. The voltage waveform analysis has allowed to identify a working area of the converter where there are lowest va…
Design issues for wind farms grid tied Inverter
In this paper the Authors give indications for the design of a grid tied Voltage Source Inverters (VSI) aimed to optimal use in energy conversion from wind source. In particular, the design of the inverter is more focused on the control system planning, with a particular glance on the grid synchronization problem. After the exposition of general issues concerning renewable energies and associated topics, the case of a grid tied inverter is considered and a methodology of design is sketched starting from the consideration of the DC side and also considering the power device losses, the protection issue against over voltages and over-currents, snubber circuits, heat sinks and, finally the con…
Electrical characterization of CIGSSe photovoltaic modules
This work describes the electrical characterization of CIG(S,Se) 2 sub-modules in order to compare the related performances with those obtained from traditional silicon photovoltaic modules. This characterization has been performed through means of a test bench, mainly composed by a solar simulator equipment, allowing the determination of the parameters of the prototypes under test at different irradiances and temperatures.