0000000000379278
AUTHOR
Adriana Soveja
The application of the random balance method in laser machining of metals
International audience; Features peculiar to laser technology offer some advantages over more traditional processes, but, like all processes, it has its limitations. This article studies the limitations of laser machining of metals, and quantifies, through an experimental design method, the influence of operating parameters on productivity and on the quality of the machined surface. Three study materials were used: an aluminium alloy, stainless steel and a titanium alloy. An initial reading of the results indicates that productivity depends mainly on the frequency of the laser pulse and that the aluminium alloy behaves differently from the other two. The quality of the machined surface, jud…
Traitement de surface métallique induit par faisceau laser Nd:YAG Q-switch de marquage : modélisation d'un impact laser
International audience; Nous nous intéressons à la modélisation des phénomènes physiques intervenant lors du traitement des matériaux par un faisceau laser Nd:YAG impulsionnel. Deux applications industrielles sont étudiées : le procédé de la texturation par laser et le procédé de coloration de surface par laser.
Modelling of laser beam texturing process: experimental and numerical approaches
The aim of this work is to reache a better control of the laser beam surface texturing process on three materials: 304L, TA6V and AA6056 alloys. For this purpose, two complementary methods, experimental and numerical modelling, have been used. As a result of the experimental design approach, it was observed that the laser surface texturing process of 304L and TA6V alloys is strongly influenced by the pulse energy and frequency. In order to obtain a surface roughness Sa < 5 µm for the highest possible productivity it is necessary to work with an energy of 5 mJ and a frequency ranging between 10 and 12 kHz. Unfortunately, for aluminium alloy AA6056, it is necessary to make a choice between ha…
Optimisation of TA6V alloy surface laser texturing using an experimental design approach
International audience; Active surfaces of plastic injection moulds are nowadays textured using classical techniques (chemical etching or EDM). Replacement of these technologies by a laser technology introduces a big flexibility: absence of mechanical contact with the tool, decrease of the effluent's volume and a big machining precision, even in the case of the complex forms as injection moulds for example. This paper reports the experimental study of the surface laser texturing of TA6V alloy. The influence of the operating factors on the laser texturing process has been studied using two experimental approaches: Taguchi methodology and response surface methodology (RSM). Empirical models h…
Laser densification of organic coating: Effects of laser wavelength, operating parameters and substrate properties
International audience; Mechanical bonding and interface behaviour play a key role for any materials deposited on different substrates. Usually, a post-spray heat treatment is required to improve the coating morphology and to enhance mechanical properties of thermal-sprayed polymeric coating. The effects of YAG, CO2 and diode laser radiations on as-sprayed PEEK coating deposited on stainless steel and aluminum substrates were investigated. The results revealed a good coating densification and interface behavior. A correlation between coating and substrate absorption coefficients, their thermophysical properties and laser operating parameters was shown. Besides, the finite element modeling b…
Improvement of flame spraying PEEK coating characteristics using lasers
Flame spraying is frequently used for PEEK coatings elaboration on metallic surfaces. However, this process has a certain number of limitations particularly considering the quality of the coatings like high porosity or low interfacial adherence. For that reason a thermal post-processing is often necessary. From all of the processes which can be used (flame, oven, etc.), laser can be an interesting technology. Then, the aim of this study is to analyse the dependence of the morphological structure (compactness) and the adherence of the flame sprayed PEEK coatings to the stainless steel (304L) and aluminium alloy (AA2017) substrates on laser parameters. Moreover, the influence of the laser bea…