0000000000391858
AUTHOR
Sara Busi
Synthesis, characterization and thermal properties of small R2R′2N+X−-type quaternary ammonium halides
Twenty-one R {sub 2} R {sup '} {sub 2}N{sup +} X {sup -} -type (R=methyl or ethyl, R {sup '}=alkyl, X=Br or I) quaternary ammonium (QA) halides have been prepared by using a novel one-pot synthetic route in which a formamide (dimethyl-, diethylformamide, etc.) is treated with alkyl halide in the presence of sodium or potassium carbonate. The formation of QA halides was verified with {sup 1}H-NMR, {sup 13}C-NMR, MS and elemental analysis. The crystal structures of four QA halides (two bromide and two iodide) were determined using X-ray single crystal diffraction, and the powder diffraction method was used to study the structural similarities between the single crystal and microcrystalline bu…
Crystal Structures and Thermal Behavior of Bis(dibenzyldimethylammonium) Tetrabromometallates(II) [M = Mn(II), Co(II) and Zn(II)] and Their Solvates
Six new A2MBr4 structures [A = dibenzyldimethylammonium cation,M = Mn(II), Co(II) or Zn(II)] were crystallized with or without solvent molecules from acetonitrile, methanol and/or aqueous solutions. The isomorphous compounds [(Bz2Me2N)2][MnBr4]·CH3CN·H2O (1) and [(Bz2Me2N)2]-[ZnBr4]·CH3CN·H2O (4) crystallize in the triclinic space group P1̄ from acetonitrile solutions. The solvent molecules participate in the hydrogen bonding network inside the crystal structure. [(Bz2Me2N)2][CoBr4]·0.5CH3CN (2) crystallizes from an acetonitrile solution in the monoclinic space group P21/c. The solvent molecules fill the voids of the crystal structure. Compound 2 is isostructural with the previously reporte…
A new ionic liquid dimethyldinonylammonium bromide as a flow modifier for the simultaneous determination of eight carboxylates by capillary electrophoresis.
Two new methods of capillary zone electrophoresis based on aqueous phosphate running buffers with UV spectrophotometric detection were developed and optimized for the determination of eight carboxylates as copper complexes. Metalcomplexes are negatively charged, so measurements were made as anion analyses with flow reversal in the capillary. Two flow modifiers were used: a common tetradecyltrimethylammonium bromide (TTAB) and a new ionic liquid dimethyldinonylammonium bromide (DMDNAB). The methods were compared to each other. Better separation was achieved with DMDNAB as the flow modifier. Method development was done using a fused silica capillary (61 cm x 50 microm i.d.). Optimization was …
The role of cation⋯π interactions in capsule formation: co-crystals of resorcinarenes and alkyl ammonium salts
An unprecented dimeric capsular assembly of a tetramethylated C-hexyl resorcinarene and an expected one from unsubstituted C-butyl resorcinarene with tetramethylammonium cation are described. Surprisingly tetramethylated C-hexyl resorcinarene, with no apparent possibility for intra-capsular hydrogen bonds, forms a capsule which is held together solely by the cation⋯π interactions and the complementary geometry of the spherical guest cation and the concave resorcinarene host. The C-butyl resorcinarene capsule, as in the case of dimeric resorcinarene capsules reported earlier, is mediated viasolvent molecules and intra-capsular hydrogen bonds. We also report here two co-crystals of C-methyl r…
A linear Fe-O-Fe unit in bis(dibenzyldimethylammonium)-oxo-di[tribromoferrate(III)]
The title compound, (C16H20N)2[Fe2Br6O], crystallizes with one dibenzyldimethylammonium cation and one half of a [mu]-oxo-bis[tribromoferrate(III)] anion in the asymmetric unit. The bridging oxo group is situated on an inversion centre, resulting in a linear conformation for the Fe-O-Fe unit. The iron(III) cations have tetrahedral geometry, with bond angles in the range 106.8 (1)-112.2 (1)°. The ion pairs are held together by Coulombic forces and C-H...Br hydrogen bonds. Each Br- anion forms one hydrogen bond. No C-H...O hydrogen bonds are found between the O atom in the Fe-O-Fe unit and surrounding counter-cations, consistent with the linear configuration of the Fe-O-Fe unit. peerRevie…
Quaternary ammonium polyiodides as ionic liquid/soft solid electrolytes in dye-sensitized solar cells
Abstract Four new quaternary ammonium iodides, (Me 2 Pe 2 N)I, (Me 2 Hex 2 N)I, (Et 2 Pe 2 N)I and (Et 2 Hex 2 N)I, were synthesized and studied as electrolytes in dye-sensitized solar cells. All compounds were solids at room temperature. Influence of varying amounts of elemental iodine and the effect of tert -butylpyridine (TBP) on the performance of the cell was also studied. Addition of iodine lowered the melting points of the resulting polyiodides. From the ammonium iodides only (Me 2 Hex 2 N)I:I 2 (10:1) was liquid at the room temperature and the others were soft solids. Under illumination from a halogen lamp source at 10 mW cm −2 intensity, the highest power conversion efficiency of 2…
Synthesis, characterization and thermal behavior of nine new -type quaternary ammonium tetrafluoroborate or hexafluorophosphate salts prepared by metathesis from analogous halide salts
Abstract Nine new quaternary ammonium tetrafluoroborate or hexafluoroborate salts were prepared from analogous bromide or chloride salts using anion exchange reaction in which the corresponding bromide or chloride salt was treated with HBF4 or HPF6 acid in aqueous solutions. The characterizations were performed by 1H NMR and 13C NMR spectroscopy as well as by elemental analysis. The single crystals of three tetrafluoroborate and two hexafluorophosphate salts were obtained by slow evaporation from a methanol/ethyl acetate solution and the crystal structures were determined by X-ray single crystal diffraction. Four of the compounds crystallized in the orthorhombic and one in the monoclinic cr…
Solvent Exchange in Thermally Stable Resorcinarene Nanotubes
The assembly of C-methyl resorcinarene into a tubular supramolecular solid-state structure, its thermal stability, and its hosting properties are reported. Careful control of the crystallisation conditions of C-methyl resorcinarene and 1,4-dimethyl-1,4-diazoniabicyclo[2.2.2]octane (1,4-dimethyl DABCO) dibromide leads to a formation of two crystallographically different, but structurally very similar, solid-state nanotube structures. These structures undergo a remarkable variety of supramolecular interactions, which lead to the formation of 0.5 nm diameter nonpolar tubes through the crystal lattice. The formation of these tubes is templated by suitably sized small alcohols, namely, n-propano…
Separation of chelating agents as copper complexes by capillary zone electrophoresis using quaternary ammonium bromides as additives in N-methylformamide
This study presents the use of quaternary ammonium bromides as additives in N-methylformamide (NMF) for the separation and quantification of chelating agents as copper complexes by capillary zone electrophoresis (CZE). The new quaternary ammonium bromides were synthesized in our laboratory and used for the first time for CZE applications performed in NMF media. The methods were developed and optimized for determination of six chelating agents (trans-1,2-diaminocyclohexane-N,N,N',N'-tetraacetic acid (CDTA), diethylenetriaminepentaacetic acid (DTPA), ethylenediaminetetraacetic acid (EDTA), N-(2-hydroxyethyl)ethylenediamine-N,N',N'-triacetic acid (HEDTA), nitrilotriacetic acid (NTA) and trieth…
Synthesis, characterization and thermal properties of new aromatic quaternary ammonium bromides
Series of new aromatic R 2R′ 2N +Br - (R=benzyl, 4-methylbenzyl, 2-phenylethyl, 3-phenylpropyl; R′=ethyl, methyl, isopropyl) or RR′ 2NH +Br --type (R=benzyl, R′=isopropyl) quaternary ammonium bromides were prepared by using novel synthetic route in which a formamide (N,N-diethylformamide, N,N-dimethylformamide, N,N-diisopropylformamide) is treated with aralkyl halide in presence of a weak base. The compounds were characterized by 1H-NMR and 13C-NMR spectroscopy and mass spectrometry. Structures of the crystalline compounds were determined by X-ray single crystal diffraction, and in addition the powder diffraction method was used to study the structural similarities between the single crysta…
Synthesis, characterization and thermal properties of nine quaternary dialkyldiaralkylammonium chlorides
Abstract Nine R 2 R 2 ′ N + Cl − (R=benzyl, 2-methylbenzyl, 3-methylbenzyl, 4-methylbenzyl, 2-phenylethyl or 3-phenylpropyl; R′=ethyl or methyl) quaternary dialkyldiaralkylammonium chlorides were synthesized by treating dimethylformamide or diethylformamide with non-substituted or substituted arylalkyl (aralkyl) halide in the presence of sodium carbonate. The 1H NMR, 13C NMR spectroscopy, mass spectroscopy and elemental analysis were used to characterize the synthesized products. The crystal structures of six compounds were determined by X-ray single crystal diffraction. Four of the compounds crystallized in monoclinic space groups C2/c and P21/c (or P21/n), one in triclinic space group P−1…
A linear Fe-O-Fe unit in bis(dibenzyldimethylammonium) mu-oxo-bis[tribromoferrate(III)].
The title compound, (C 16 H 20 )N) 2 [Fe 2 Br 6 O], crystallizes with one dibenzyldimethylammonium cation and one half of a μ-oxo-bis[tribromoferrate(III)] anion in the asymmetric unit. The bridging oxo group is situated on an inversion centre, resulting in a linear conformation for the Fe-O-Fe unit. The iron(III) cations have tetrahedral geometry, with bond angles in the range 106.8 (1)-112.2 (1)°. The ion pairs are held together by Coulombic forces and C-H···Br hydrogen bonds. Each Br - anion forms one hydrogen bond. No C-H···O hydrogen bonds are found between the O atom in the Fe-O-Fe unit and surrounding counter-cations, consistent with the linear configuration of the Fe-O-Fe unit.
Crystal Structures and Thermal Behavior of Isostructural Bis(dibenzyldimethylammonium) Tetrachlorometallate [M = Mn(II), Co(II), Ni(II) and Zn(II)] Solvates Crystallized from Acetonitrile and/or Methanol Solutions
Five isostructural bis(dibenzyldimethylammonium) tetrachlorometallate solvate complexes [M = Mn(II), Co(II), Ni(II) or Zn(II)] were crystallized from acetonitrile and/or methanol solutions. The crystal structures are compared to those of the analogous, isostructural copper compounds (X = Cl or Br) reported earlier. The complexes crystallize in the monoclinic space group P21/n with Z = 4, and unit cell dimensions of a ≈ 14.1, b ≈ 16.1, c ≈ 15.7 °A and β ≈ 108 - 109°. The asymmetric unit of these compounds contains one MCl4 2− anion, two Bz2Me2N+ cations in theW-conformation and one half of a disordered solvent molecule (acetonitrile or methanol). The geometry of the MCl4 2− anion is close to…
Novel one-pot synthesis of quaternary ammonium halides: new route to ionic liquids
Treatment of an amide with an alkyl or substituted alkyl halide in the presence of a weak base in a one-pot reaction leads to crystalline quaternary ammonium halides with reasonable chemical yields; some of the compounds show low melting points and a liquid range of over 50–100 °C before decomposition.
Crystal structures and thermal behavior of bis[dibenzyldimethylammonium]CuBr4, bis[dibenzyldimethylammonium]CuCl4 and bis[dimethyldi(2-phenylethyl)ammonium]CuBr4 crystallized from acetonitrile and dilute HX (X=Cl or Br) solutions
Abstract Bis[dibenzyldimethylammonium]CuBr4, bis[dibenzyldimethylammonium]CuCl4 and bis[dimethyldi(2-phenylethyl)ammonium]CuBr4 were crystallized from acetonitrile and/or dilute HX solutions. Five different kinds of single crystals were obtained. In the case of bis[dibenzyldimethylammonium]CuX4 (X=Br or Cl), the acetonitrile molecules cocrystallized into the crystal structure when acetonitrile solution was used. As a result, the isomorphic structures of Bis[dibenzyldimethylammonium]CuX4·0.5 CH3CN (X=Br or Cl) in monoclinic space group P21/n were obtained. When a dilute HX solution was used, the bis[dibenzyldimethylammonium]CuX4 (X=Br or Cl) crystallized without solvent molecules. The formed…