Study of Inductive Coupled Hydrogen and Argon Plasma Interaction with SiO2 Glass
This work is devoted to the diagnostics of interaction between hydrogen and argon with the surface of SiO2 glass walls. For diagnostics of the interaction, special high-frequency electrodeless light sources were prepared, filled with pure argon of 1 Torr or argon-hydrogen of total pressure of 1 Torr (Ar/H2 mixing ratio is 9:1). Besides the mostly used spherical and cylindrical lamps, dumbbell type lamps have also been investigated. The spectroscopic and AFM measurements showed that in comparison with pure argon plasma, the argon-hydrogen plasma causes non-uniform changes of the SiO2 surface. For these modifications active OH are primarily responsible molecules, created in the reactions of h…
A study of capillary discharge lamps in Ar–Hg and Xe–Hg mixtures
Low-pressure capillary discharge lamps in Ar–Hg and Xe–Hg mixtures are studied. The discharge size is 0.5 mm (500 µm) in radius. According to the literature, such types of plasma sources are classified as microplasmas. The studies include spectrally resolved optical measurements, tomographic reconstructions and numerical simulations using the collisional–radiative model for an Ar–Hg plasma. We discuss the problems of theoretical modelling and experimental diagnostics of microplasma sources. It is shown that the conventional collisional–radiative model, based on the assumption that transportation of atoms in the highly excited states can be neglected, has limitations in modelling a capillary…
High-frequency electrodeless discharge lamps for atomic absorption analysis
Abstract In this paper we present the results of an investigation of high-frequency electrodeless discharge lamps (HFEDLs), containing Cd, Zn, Hg, As, Te, Se, Pb, Sn, Tl and Bi, developed in our laboratories as light sources for atomic absorption spectrometry (AAS). Important physical processes in the lamps are discussed. Essential characteristics of HFEDLs for AAS, such as intensity, stability and operating life are considered. The intensities and detection limits are compared with the corresponding characteristics of hollow cathode lamps. The temporal behavior of an As HFEDL is compared with that of a commercially available electrodeless discharge lamp. Detection limits in graphite furnac…
Study of the High-Frequency Inductive Coupled Discharge Plasma Interaction with Walls
The high-frequency electrodeless light sources (HFELS) are widely used as bright radiators of narrow and intense spectral lines covering the region from VUV to IR. Special HFELS filled with pure helium at pressures from 0.2 to 5 Torr were prepared for diagnostics of interaction between the filling element and the wall material (glass). Pollution of the discharge plasma with the oxygen admixture was studied by spectroscopy. Atomic force microscopy experiments were performed to find modification of the wall surface at the nanoscale level. Release of oxygen by the walls is found to depend strongly on the discharge conditions and significant changes of the surface structure are detected after p…
Zemtemperatūras gāzu izlādes plazmas spektroskopiskā diagnostika
Elektroniskā versija nesatur pielikumus
Analysis of Mercury Pollution in Air in Urban Area of Riga Using Atomic Absorption Spectrometry
Toxicity of mercury and its compounds is well known, and they are considered as substances of heightened concern. Though mercury is to some extent released into the environment by natural processes such as volcanic eruptions, additional releases from anthropogenic sources have increased the environmental exposure and deposition significantly. There are many commonly used items containing mercury, for instance, mercury light bulbs, switches, and mercury thermometers, the disposal of which into trashcans can cause an increase of mercury concentration in the air of the local area. The paper reports mercury pollution surveys performed in several districts of Riga (the capital of Latvia). Using …
Determination of gas temperature of high-frequency low-temperature electrodeless plasma using molecular spectra of hydrogen and hydroxyl-radical
Abstract In this study we determine gas temperature of He+H 2 , Ar+H 2 and Ne+H 2 high frequency electrodeless lamps using intensity distribution in rotational spectra of hydrogen molecule and hydroxyl radical. The measurement results show that OH rotational spectra can be successfully used for estimation of gas temperature of the high-frequency electrodeless lamps at very small amounts of hydrogen present in plasma. The analysis of the measurement results leads to the conclusion that in “pure” plasma the applied energy is used to heat plasma, while for the plasma with hydrogen addition the energy is used in chemical reactions.
Determination of helium number densities in high-frequency electrodeless plasma
Abstract The number densities of He first excited states 2 3 S 1 , 2 1 S 0 , 2 3 P 0,1,2 , and 2 1 P 0 were measured by absorption and self-absorption methods. The emission lines in the range 290–730 nm were used to determine the number densities of He metastable and resonant states of inductively coupled high-frequency electrodeless lamps filled with helium at pressure 0.1 Torr. The obtained number densities of helium metastable levels 2 3 S 1 and 2 1 S 0 are 2×10 12 and 3×10 11 cm −3 , respectively. For the 2 3 P 0,1,2 and 2 1 P 0 levels the determined number densities are ten times smaller than that of the metastable levels. Values of number densities from measurements using both method…
Light source inner surface changes depending on treatment
Our work is connected with the preparation of different type of electrodeless discharge lamps. In this work we investigate the influence of the SiO2 glass wall treatment procedures on the inner surface of the electrodeless lamps. Three different treatment procedures were applied: vacuum cleaning, vacuum-thermal cleaning and training in the high frequency discharge. The surface modification has been investigated by means of atomic force microscopy. Substantial changes of the SiO2 glass surface have been observed. (© 2008 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim)
ASSESSING MERCURY POLLUTION USING BLACK STORK EGGSHELLS
Female birds whose bodies contain environmental contaminants produce eggs with shells that are likewise contaminated, making bird eggshells appropriate indicators for monitoring environmental toxins. Common contaminants include organic mercury compounds, especially methylmercury, which are known to bioaccumulate and biomagnify in the food chain. Black storks (Ciconia nigra) predominantly consume fish and are thus at risk for high mercury intake. In this study, we used eggshells of black storks as a proxy to reconstruct the concentration levels and distribution of mercury, a well-known toxic element, in various parts of Latvia. Preliminary analyses have shown that deposition levels of mercur…
Optical diagnostic method for benzene detection in air
In this paper we show our first results of research for creation a detector for benzene vapor and possibly other volatile organic compounds detection in air based on Zeeman atomic absorption technique. First the detailed study of benzene absorption spectra with high resolution spectrometer Jobin-Yvon 1000M was done. The absorption spectra of benzene were registered in the spectral range from 200-900 nm. More detailed analysis was done for the 240 – 260 nm spectral range to test a possibility to detect benzene by means of emission line of 254 nm of mercury.
<title>Advanced light sources for atomic absorption analysis</title>
High-frequency electrodeless light sources (HF EDLS) are widely used as bright radiators of narrow and intensive atomic and ionic spectral lines, covering the spectrum from VUV to IR. Main characteristics of HF EDLS are high emitted spectral line intensity, long service life, and in general, narrow spectral line shapes because of low-pressure of filling elements. In this work we give a short overview of the use of HF EDLS, containing Hg, Te, Se, Zn, Pb, As, Sb, Bi, Tl, In, Cd, Sn, in Zeeman Atomic absorption devices for assaying natural, drinking, waste and technical water as well as air, soil, food products and biological samples. The first steps are made for optimization of Ge, Ga, P, S, …
Diagnostics of capillary mercury–argon high-frequency electrodeless discharge using line shapes
Abstract The profiles of the 253.7 nm spectral line, emitted from the capillary argon–mercury isotope high-frequency electrodeless discharge, are measured by means of a pressure-scanned Fabry–Perot spectrometer. Spectral line profiles are collected from two lamps at the argon pressure of 2 and 10 Torr, in dependence on the discharge current and Hg vapor densities corresponding to the cold spot temperatures of 25–80 °C. By means of a multi-parameter non-linear line profile fitting procedure of multiple overlapping self-reversed Voigt profiles, the temperature of the radiating atoms and the optical density were estimated. The capillary and spherical discharge conditions were compared. The opt…