Characterization of the defect density states in MoOx for c-Si solar cell applications

2021

Thin layers of MoOx have been deposited by thermal evaporation followed by post-deposition annealing. The density of states distributions of the MoOx films were extracted deconvoluting the absorption spectra, measured by a photothermal deflection spectroscopy setup, including the small polaron contribution. Results revealed a sub-band defect distribution centered 1.1 eV below the conduction band; the amplitude of this distribution was found to increase with post-deposition annealing temperature and film thickness.

Analysis of Transition Metal Oxides based Heterojunction Solar Cells with S-shaped J-V curves

2020

The use of transition metal oxides for the selective carrier contact in the crystalline silicon solar cells technology is rising to interest for the excellent optoelectrical properties of these materials whose implementation, however, can result in lousy performing cells due to an S-shaped electrical characteristic. In this paper, we fabricated solar cells showing S-shaped J-V curve and carried out an analysis of the reasons of such behavior using a model involving the series of a standard cell equivalent circuit with a Schottky junction in order to explain these atypical performances. A good matching between the experimental measurements and the adopted theoretical model was obtained. The …

Density of States evaluation of Molybdenum Oxide for c-Si solar cell

Silicon-based heterojunction technology (HJT) is one of the most promising candidates for high performance and low cost solar cells with world-record efficiency close to 27% in IBC architecture. The HJT exploits the excellent passivation properties of hydrogenated amorphous silicon (a-Si:H); although, the use of doped a-Si:H has drawbacks such as parasitic absorption and low-thermal budget to cope with back-end metallization. Replacing the p-type a-Si:H with molybdenum oxide (MoOx) is a viable alternative. Optimizing this hole-selective layer is needed; however information on the defect density of states (DOS), linked to oxygen vacancies is still lacking.

Density of States characterization of TiO2 films deposited by Pulsed Laser Deposition for Heterojunction solar cells

2021

The application of titanium dioxide (TiO2) in the photovoltaic field is gaining traction as this material can be deployed in doping-free heterojunction solar cells with the role of electron selective contact. For modeling-based optimization of such contact, knowledge of the titanium oxide defect density of states is crucial. In this paper, we report a method to extract the defect density through nondestructive optical measures, including the contribution given by small polaron optical transitions. The presence of both related to oxygen-vacancy defects and polarons is supported by the results of optical characterizations and the evaluation of previous observations resulting in a defect band …

Erratum to: Sub-gap defect density characterization of molybdenum oxide: An annealing study for solar cell applications

2022

Sub-gap defect density characterization of molybdenum oxide: An annealing study for solar cell applications

2020

AbstractThe application of molybdenum oxide in the photovoltaic field is gaining traction as this material can be deployed in doping-free heterojunction solar cells in the role of hole selective contact. For modeling-based optimization of such contact, knowledge of the molybdenum oxide defect density of states (DOS) is crucial. In this paper, we report a method to extract the defect density through nondestructive optical measures, including the contribution given by small polaron optical transitions. The presence of defects related to oxygen-vacancy and of polaron is supported by the results of our opto-electrical characterizations along with the evaluation of previous observations. As part…