0000000000775155
AUTHOR
Tommy Ahlgren
showing 7 related works from this author
Annealing behaviour of aluminium-implanted InP
2000
The annealing behaviour of aluminium has been studied in single-crystal InP implanted with 40 and 120 keV 27Al+ ions. The implantation doses were 1 x 1015 and 1 x 1016 cm-2. The aluminium concentration profiles were determined by two techniques, Secondary ion mass spectrometry (SIMS) and the nuclear resonance broadening technique (NRB) which was used for checking purposes. The usability of the SIMS technique for profiling Al rich layers was studied. Significant inconsistencies were observed in the SIMS profiles with the high dose implanted samples. The 120 keV, 1 x 1016 cm-2 implanted samples were subject to annealing in argon atmosphere in the temperature range 380–600°C. Redistribution an…
Influence of surface topography on depth profiles obtained by Rutherford backscattering spectrometry
2000
A method for determining correct depth profiles from samples with rough surfaces is presented. The method combines Rutherford backscattering spectrometry with atomic force microscopy. The topographical information obtained by atomic force microscopy is used to calculate the effect of the surface roughness on the backscattering spectrum. As an example, annealed Au/ZnSe heterostructures are studied. Gold grains were observed on the surfaces of the annealed samples. The annealing also caused diffusion of gold into the ZnSe. Backscattering spectra of the samples were measured with a 2 MeV 4He+ ion beam. A scanning nuclear microprobe was used to verify the results by measuring backscattering fro…
Plastic Deformation of Single Nanometer-Sized Crystals
2008
We report in situ electron microscopy observations of the plastic deformation of individual nanometer-sized Au, Pt, W, and Mo crystals. Specifically designed graphitic cages that contract under electron irradiation are used as nanoscopic deformation cells. The correlation with atomistic simulations shows that the observed slow plastic deformation is due to dislocation activity. Our results also provide evidence that the vacancy concentration in a nanoscale system can be smaller than in the bulk material, an effect which has not been studied experimentally before.
Plasma-wall interaction studies within the EUROfusion consortium: Progress on plasma-facing components development and qualification
2017
This work has been carried out within the framework of the EUROfusion Consortium and has received funding from the Euratom research and training programme 2014-2018 under grant agreement No 633053. The views and opinions expressed herein do not necessarily reflect those of the European Commission.
Overview of the JET results in support to ITER
2017
The 2014–2016 JET results are reviewed in the light of their significance for optimising the ITER research plan for the active and non-active operation. More than 60 h of plasma operation with ITER first wall materials successfully took place since its installation in 2011. New multi-machine scaling of the type I-ELM divertor energy flux density to ITER is supported by first principle modelling. ITER relevant disruption experiments and first principle modelling are reported with a set of three disruption mitigation valves mimicking the ITER setup. Insights of the L–H power threshold in Deuterium and Hydrogen are given, stressing the importance of the magnetic configurations and the recent m…
Lattice sites of diffused gold and platinum in epitaxial ZnSe layers
2000
Abstract The lattice location of diffused gold and platinum in zinc selenide (ZnSe) epitaxial layers was studied using the Rutherford backscattering (RBS) channeling technique. Thin Au and Pt films were evaporated onto ZnSe samples. The Au/ZnSe samples were annealed at 525°C and the residual Au film was removed by etching. Channeling angular scan measurements showed that about 30% of Au atoms were close to substitutional site (displaced about 0.2 A). In the case of the Pt/ZnSe samples the annealing temperatures ranged from 600°C to 800°C. The Pt minimum yields along 〈1 0 0〉 direction were close to the random value, varying from 80% to 90%. The measured Pt angular scans along 〈1 0 0〉 and 〈1 …
Vacuum electrical breakdown conditioning study in a parallel plate electrode pulsed dc system
2019
Conditioning of a metal structure in a high-voltage system is the progressive development of resistance to vacuum arcing over the operational life of the system. This is, for instance, seen during the initial operation of radio frequency (rf) cavities in particle accelerators. It is a relevant topic for any technology where breakdown limits performance and where conditioning continues for a significant duration of system run time. Projected future linear accelerators require structures with accelerating gradients of up to 100 MV/m. Currently, this performance level is achievable only after a multimonth conditioning period. In this work, a pulsed dc system applying voltage pulses over paral…