0000000001005375
AUTHOR
Guido Di Bella
showing 12 related works from this author
Methodological approach for evaluating the geo-exchange potential: VIGOR Project
2012
In the framework of VIGOR Project, a national project coordinated by the Institute of Geosciences and Earth Resources (CNR-IGG) and sponsored by the Ministry of Economic Development (MiSE), dedicated to the evaluation of geothermal potential in the regions of the Convergence Objective in Italy (Puglia, Calabria, Campania and Sicily), is expected to evaluate the ability of the territory to heat exchange with the ground for air conditioning of buildings. To identify the conditions for the development of low enthalpy geothermal systems collected and organized on a regional scale geological and stratigraphic data useful for the preparation of a specific thematic mapping, able to represent in a …
Specific Mechanical Properties of Glass/Carbon Epoxy Composites for Marine Applications
2009
Load-deflection characteristics of superelastic and thermal nickel-titanium wires
2011
SUMMARY The aim of this study was to investigate the mechanical properties of superelastic and thermal nickel–titanium (NiTi) archwires for correct selection of orthodontic wires. Seven different NiTi wires of two different sizes (0.014 and 0.016 inches), commonly used during the alignment phase, were tested. A three-point bending test was carried out to evaluate the load–deflection characteristics. The archwires were subjected to bending at a constant temperature of 37°C and deflections of 2 and 4 mm. Analysis of variance showed that thermal NiTi wires exerted significantly lower working forces than superelastic wires of the same size in all experimental tests (P < 0.05). Wire size had a s…
Geometry and stacking sequence effect on composite spinnaker pole’s stiffness: experimental and numerical analysis
2006
Composite materials are widely employed in sailing sports, a possible application is for the mast pole or other sail poles. In the paper the attention is focused on the spinnaker poles mechanical performances; in particular the focus is on axial and ring compressive properties of three different carbon fibre/epoxy resin spinnaker poles, to investigate both the diameter and stacking sequence effect on the mechanical performance of the structure. Starting from the stacking sequence used in the production of a particular spinnaker pole, the effect of a lamina at 0- in the middle of wall thickness is investigated with the purpose to obtain a more stiff structure. Moreover to test the proposed s…