Search results for " Adsorption"
showing 10 items of 222 documents
Polymer solutions confined in slit-like pores with attractive walls: An off-lattice Monte Carlo study of static properties and chain dynamics
1996
Using a bead spring model of flexible polymer chains, the density profiles and chain configurational properties of polymer solutions confined between parallel plates were studied. A wide range of density ϕ, chain length N, and strength e of a short-range attractive wall potential was investigated. Both a temperature T in the good solvent regime (T > θ, θ being the Theta temperature where a chain in unconfined bulk three-dimensional solution would behave ideally) and a temperature in the bad solvent regime (T θ) show a crossover from two-dimensional excluded volume behavior (Rg ∝ N2ν with ν = 3/4) to ideal random walk behavior (ν = 1/2), the relaxation times show effective exponents Zeff (τ …
Affinity Distributions of a Molecularly Imprinted Polymer Calculated Numerically by the Expectation-Maximization Method
2003
Affinity distributions are calculated from adsorption isotherm data obtained for the enantiomers of L- and D-phenylalanine anilide (PA) on native and thermally annealed polymers molecularly imprinted with L-PA. The calculation is obtained with an iterative algorithm called expectation-maximization that does not require prior fit of the data to an isotherm model before inversion and thus yields a distribution indicative of the data only. The results show bimodal distributions, suggestive of a two-site model describing relatively selective and nonselective adsorption modes of the L-enantiomer and a corresponding unimodal/nonselective adsorption mode for the D-enantiomer. The nonselective adso…
Critical adsorption of a single macromolecule in polymer brushes.
2014
The adsorption of long flexible macromolecules by polymer brush-coated surfaces is studied by molecular dynamics simulations and by calculations using density functional and self-consistent field theories. The case of repulsive interactions between the substrate surface and the monomers of both the brush polymers and the extra chains that can get absorbed into the brush is considered. Under good solvent conditions, critical absorption can occur, if the interaction between the monomers of the brush polymers and the extra chain is (weakly) attractive. It is shown that it is possible to map out the details of the critical absorption transition, if the chain length and/or the grafting density o…
Polyethylene glycol/clay nanotubes composites
2012
Nanocomposites of poly(ethylene) glycol (PEG) 20000 filled with clay nanotubes (HNTs) were prepared. The thermal properties obtained from thermogravimetry and differential scanning calorimetry were correlated to the morphology imaged by scanning electron microscopy. Low amounts of HNTs generate compact structure while large amounts of HNTs create craters and voids. The decrease of polymer degradation temperature in the presence of large amount of nanoclay (ca. 80 wt%) is a consequence of the morphology at the mesoscale range. The thermal opposite effect observed in the HNTs low regime (up to ca. 20 wt%) is due to the gas entrapment into the nanoparticles lumen. The quantitative analysis of …
Multivalent ion-exchange model of biopolymer chromatography for mass overload conditions
1991
Abstract The simple model of multivalent ion-exchange biopolymer chromatography is analyzed on the basis of classical quasi-chemical temperature. The rigorous isotherm equation deduced from the stoichiometric displacement model (SDM) was used to stimulate the migration of a solute through the chromatographic column in the isocratic and gradient elution modes. The peak profiles generated for various sample sizes were compared with those obtained on the basis of a Langmuir isotherm. Peak tailing increases with the value of the exponent Z, defined as the ratio of the protein valency to the displacing counter-ion valency. For large Z the asymmetries due to the non-linearity of the isotherm are …
Mechanical Properties of Single Molecules and Polymer Aggregates
2013
This chapter deals with the mechanical properties of single polymer chains, aggregates, and supramolecular complexes. The topics discussed cover a broad range from fundamental statistical mechanics of the equilibrium elastic properties of single polymer chains to details of the behavior of binding pockets in biomolecular assemblies as observed by force spectroscopy. The first section treats the equilibrium mechanical properties of single polymer chains in various environments, investigated via extensive simulations employing coarse-grained models that have proven extremely successful in many branches of polymer physics, namely the bond-fluctuation model and the self-avoiding walk model. Apa…
Polymer absorption in dense polymer brushes vs. polymer adsorption on the brush-solvent interface
2014
Molecular-dynamics simulations of a coarse-grained model of a dense brush of flexible polymers (of type A) interacting with a long flexible macromolecule (of type B) are presented, considering the case of an attractive AB interaction, while effective interactions between AA and BB pairs of monomers are repulsive. Varying the strength of the attraction between unlike monomers, an adsorption transition at some critical value is found, where the B-chain is bound to the brush-solvent interface, similar to the adsorption on a planar solid substrate. However, when is much higher than , the long macromolecule is gradually “sucked in” the brush, developing many pieces that are locally stretched in …
Pattern-recognising Polymer Adsorption on Structured Surfaces: Gaussian Polymers vs. Freely Jointed Chains
2014
Abstract Selective adsorption of homopolymers is exploited as a model for pattern recognition. To this end the strong adsorption regime of Gaussian polymers adsorbed on a regularly structured surface is investigated for square and triangular lattices within a discrete Edwards model. The equilibrium behaviour of the specific heat, the gyration tensor and the (nematic) bond order tensor are analysed and compared to the properties for adsorbed freely jointed polymer chains.
Cylindrical Brush Polymers with Polysarcosine Side Chains: A Novel Biocompatible Carrier for Biomedical Applications
2015
Cylindrical brush polymers constitute promising polymeric drug delivery systems (nanoDDS). Because of the densely grafted side chains such structures may intrinsically exhibit little protein adsorption (“stealth” effect) while providing a large number of functional groups accessible for bioconjugation reactions. Polysarcosine (PSar) is a highly water-soluble, nonionic and nonimmunogenic polypeptoid based on the endogenous amino acid sarcosine (N-methyl glycine). Here we report on the synthesis, characterization and biocompatibility of cylindrical brush polymers with either polysarcosine side chains or poly-l-lysine-b-polysarcosine side chains. The latter leads to block copolypept(o)id based…
Consecutive Selective Adsorption of Pentamidine and Phosphate Biomolecules on a Self-Assembled Layer: Reversible Formation of a Chemically Selective…
1996
In situ ellipsometric film thickness measurements, FT-IR external reflectance spectroscopy, and potentiometric measurements indicated that the amphiphile pentamidine (PAM), a bisbenzamidine, associated by self-assembly with a preformed self-assembled monolayer of a mercaptoalkanoic acid on gold. The structural properties of PAM and the nature of the substrate were ideal for the formation of a densely packed monolayer. This process was fully reversible, as demonstrated by changing the pH of the surrounding medium. Thus, disassembly−reassembly occurred when the pH was cycled between 8.7 and 3. The bilayer structure, featuring a positively charged amidinium surface, was subsequently used for s…