Search results for " Coating."
showing 10 items of 2558 documents
Theory-based improvements of continuous polymer fractionation demonstrated for poly(carbonate)
1992
For the first time, a quantitative theoretical analysis (liquid/liquid phase equilibria treated by means of the continuous thermodynamics) of the operating characteristics of continuous polymer fractionation (CPF) was performed. The results of these calculations were compared with data published for CPF of polyethylene. It turned out that the efficiency of the conventional CPF corresponds to approximately two theoretical plates only. For this reason, several improvements, suggested by theoretical considerations, were realized experimentally, for which purpose the system dichloromethane/diethylene glycol/bisphenol-A polycarbonate was chosen. The pulsating sieve-bottom column was replaced by …
Polymer-coated reversed-phase packings in high-performance liquid chromatography
1993
The synthesis and properties of polymer-coated RP stationary phases are reviewed. The sorbents are classified according to the method of synthesis. More flexibility in the tailoring of polymer-coated packings is noted. The impact of the polymer coating on the porosity of the oxides to be modified and their chromatographic properties is discussed.
Continuous fractionation and solution properties of PIB. II. CPF optimization
1987
The quality of polymer fractionation depends on the choice of the mixed solvent as well as on the particular conditions of operating the continuous countercurrent extraction. With a polyisobutylene (PIB) sample of medium molecular weight Mw = 98,400 g/mol and U = (Mw/Mn) − 1 = 1.4 plus the mixed solvents toluene/2-butanone (TOL/MEK) and n-heptane/2-butanone (HEP/MEK) (both giving comparably good fractionation in equilibrium experiments), possible ways to optimize the CPF were tested. The mixed solvent HEP/MEK turns out to be superior to TOL/MEK for kinetic reasons. Due to the larger gap between its density and that of the pure polymer, the coexisting phases can still move through the column…
α,ω-Functionalized poly-N-isopropylacrylamides: controlling the surface activity for vesicle adsorption by temperature
2003
The synthesis of alpha,omega-end-functionalized copolymers of N-isopropylacrylamide and N-(3-dimethylaminopropyl)acrylamide was performed. Monomer ratios of 100:0, 96:4, and 81:19 were investigated. The lower critical solution temperature (LCST) of these polymers was determined by cloud-point measurements and by microcalorimetric measurements. The LCST increased from 32 over 37 to 47 degrees C as the hydrophobicity increased with increasing amount of comonomer N-(3-dimethylaminopropyl)acrylamide. The polymers could successfully be adsorbed onto gold surfaces. Finally, vesicle adsorption onto these self-assembled polymer films on flat gold surfaces was investigated as the vesicle solution te…
Recycling of dry and wet polyamide 6
2002
Recycling of polycondensation polymers can give rise to secondary materials with good mechanical properties only if a careful drying is carried out before the melt reprocessing operations. The presence of humidity provokes the hydrolytic chain scission of the macromolecules and the consequent decrease of molecular weight and properties. In this work, the drying step was substituted by the addition of an antioxidant that is able to protect the macromolecules because it is the autioxidant is more prone to hydrolysis, thus removing the water from the melt. The mechanical properties of polyamide 6 reprocessed more times in wet conditions and in the presence of this stabilizer are even better th…
Adsorption of water vapor by poly(styrenesulfonic acid), sodium salt: isothermal and isobaric adsorption equilibria
2004
Abstract Air conditioning and dehumidifying systems based on sorption on solids are of great interest, especially in humid climates, because they allow reduction of thermal loads and use of chlorofluorocarbons. Previous studies have shown that hydrophilic polymers such as sulfonic polymers can have very high performance in water adsorption from air. The aim of this study was to characterize the water vapor adsorption properties of fully sulfonated and monosulfonated poly(styrenesulfonic acid), sodium salt, and to elucidate the mechanism of adsorption on these materials. Adsorption isotherms have been determined by TGA between 298 and 317 K for pressures ranging from 0.1 to 45 hPa. They have…
Effective conductivity in association with model structure and spatial inhomogeneity of polymer/carbon black composites
1996
The relationship between effective conductivity and cell structure of polyethylene/carbon composites as well as between effective conductivity and spatial distribution of carbon black are discussed. Following Yoshida's model both structures can, in a way, be said to be intermediate between the well known Maxwell-Garnett (MG) and Bruggeman (BR) limiting structures. Using TEM photographs on composites with various carbon blacks we have observed that the larger is Garncarek's inhomogeneity measure H of two-dimensional (2D) representative distribution of the carbon black, the smaller is the effective conductivity of the composite.
Patterning of Conducting Polymers Using UV Lithography: The in-Situ Polymerization Approach
2012
We report on the in-situ polymerization of 3T with Cu(ClO4)2 inside several host polymers such as Novolak-based negative-tone photoresist, polystyrene (PS), poly(4-vinylphenol) (P4VP), poly(methyl methacrylate) (PMMA), and poly(4-vinylphenol)-co-(methyl methacrylate) (P4VP-co-MMA) to form an interpenetrating polymer network (IPN). Conducting IPN films in the order of 10–4–150 S/cm are obtained depending on the specific IPN composition. Moreover, the convenience of this synthetic approach has been demonstrated using a commercially available negative-tone photoresist based on Novolak as a host polymer. Novolak photoresist was properly formulated with 3T and Cu(ClO4)2 to preserve as far as pos…
Electrochromic Performances of Poly(Azure A) Films from Digital Video-Electrochemistry (DVEC)
2020
Poly(Azure A) (PAA) films doped with sodium dodecyl sulfate (SDS) were grown on transparent indium tin oxide (ITO) glass substrates by cyclic voltammetry. The electrochromism of PAA was investigated by digital video-electrochemistry (DVEC). DVEC consists of the acquisition of sequential digital images during the electro-stimulated changes of PAA color. The evolution of red, green, and blue (R, G, B) colors intensity (I) of analyzed pixels provides enough sensitivity to detect changes of some nmol cm−2 of electroactive centers. Besides, the different time evolution of these color intensities can serve to discern among different electroactive centers activated in the polymer. For the first ti…
Optical planar Bragg grating sensor for real-time detection of benzene, toluene and xylene in solvent vapour
2012
Abstract We report on an optical planar Bragg grating sensor functionalized by a comparatively simple method to detect substances such as benzene, toluene and xylene (BTX). The functionalization is performed by allyl substituted γ -cyclodextrin derivatives which are immobilized on the sensor surface by dip coating. Our results prove the capability of this functionalized sensor system to detect lowest concentrations of BTX in solvent vapour in real-time with a sensitivity of 3±0.4 pm/100 ppm for benzene, 8±1 pm/100 ppm for toluene and 32±1 pm/100 ppm for m-xylene. Taking into account the spectral resolution and repeatability of the interrogation system this corresponds to a minimum concentra…