Search results for " Coatings and Film"
showing 10 items of 2323 documents
Effect of air on oxygen p-doped graphene on SiO2
2016
Stability in ambient air or in vacuum-controlled atmosphere of molecular oxygen-induced p-type doping of graphene monolayer on SiO2 substrate on Si is investigated by micro-Raman spectroscopy and atomic force microscopy (AFM). The Raman 2D and G bands spectral positions and amplitude ratio are affected by the permanence in air atmosphere in a time scale of months whereas the vacuum safely maintains the doping effects determined through Raman bands. No morphological effects are induced by the doping and post-doping treatments. A reactivity of ambient molecular gas with stably trapped oxygen is suggested to induce the doping modification. (C) 2016 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim
Production of Phosphorescent Coatings on 6082 Aluminum Using Sr0.95Eu0.02Dy0.03Al2O4-δ Powder and Plasma Electrolytic Oxidation
2019
In this study, a new approach for producing phosphorescent aluminum coatings was studied. Using the plasma electrolytic oxidation (PEO) process, a porous oxide coating was produced on the Al6082 aluminum alloy substrate. Afterwards, activated strontium aluminate (SrAl2O4: Eu2+, Dy3+) powder was filled into the cavities and pores of the PEO coating, which resulted in a surface that exhibits long-lasting luminescence. The structural and optical properties were studied using XRD, SEM, and photoluminescence measurements. It was found that the treatment time affects the morphology of the coating, which influences the amount of strontium aluminate powder that can be incorporated into the coating …
Optimized bath for electroless deposition of palladium on amorphous alumina membranes
2006
A new bath for the electroless deposition of palladium on anodic alumina (AA) membranes is proposed. It was found that the optimal conditions for the uniform deposition of palladium, with minimal damage to the AA membranes, were under conditions of pH 8.4 and plating times shorter than 30 min. The deposited Pd layer was detected by X-ray diffraction (XRD) and energy dispersive X-ray (EDX) analysis. The morphology of the AA membrane before and after plating was examined by scanning electron microscopy (SEM). EDX analysis revealed that palladium was deposited only on the surfaces of the membrane and Sn ions, coming from the sensitizing bath, were incorporated into the palladium layer. EDTA in…
Acetylcholine-responsive cargo release using acetylcholinesterase-capped nanomaterials
2019
[EN] Mesoporous silica nanoparticles capped with acetylcholinesterase, through boronic ester linkages, selectively release an entrapped cargo in the presence of acetylcholine.
Effect of hydrogen on the ethylene polymerization process over Ziegler-Natta catalysts supported on MgCl2(THF)2. I. Studies of the chain-transfer rea…
2000
The effect of hydrogen on the molecular weight of polyethylene obtained over vanadium catalysts (based on VCl4 and VOCl3) supported on MgCl2(THF)2 was studied and the results were compared to those obtained for similar titanium catalysts. It was confirmed that the dependencies of the transfer reaction on the hydrogen concentration are a half-order in all investigated systems. However, the transition metal of the catalytic site affects the ratio of the transfer rate with hydrogen to the propagation rate (ktr,H/kp) and the results showed that hydrogen is a more effective agent of polyethylene molecular weight control in vanadium-based systems as compared to the titanium catalyst. © 2000 John …
Nature of activating effect of two-step polymerization of propylene
1999
The prepolymerization effect on propylene polymerization in the presence of a TiCl 3 -based catalyst, modified by di-n-buthyl ether, was studied. The influence of prepolymerization on the electron spin resonance spectra and morphology of the catalyst, as well as the properties and the morphology of both prepolymer and regular polymerization products, was investigated. The polymer morphology was evaluated through scanning electron microscopy, polymer bulk density, and particle size distribution. Some evidence of the enhancement effect of prepolymerization on the catalyst activity and stereospecificity was obtained. No influence from prepolymerization was observed on molecular weight and its …
X-ray Photoelectron-spectroscopy Investigation of Pumice-supported Nickel-catalysts
1995
Pumice-supported nickel catalysts, prepared by the method of slow homogeneous precipitation with urea, were analysed by x-ray photoelectron spectroscopy (XPS). By comparison with similarly prepared silica- and alumina-supported nickel catalysts, a preferential interaction of Ni2+ with Al3+ of the support has been determined. A quantitative XPS analysis indicated large segregation of nickel to the surface. The treatment with H2 at 673 K and 1073 K produced a partial reduction of Ni+2 to Ni0. The extent of the reduction was largest at 1073 K and in this case the reduced Ni in the metallic phase was detectable by x-ray diffraction. A decrease of the Ni 2p/Si 2p intensity ratio occurring in the…
Understanding the Stability and Recrystallization Behavior of Amorphous Zinc Phosphate
2021
Zinc phosphate, an important pigment in phosphate conversion coatings, forms protective films on rubbing surfaces. We have simulated the underlying reactions under shear by ball-milling zinc phosphate and monitored the reaction of hopeite (Zn3(PO4)2·4H2O) and the retarded recrystallization of the amorphous reaction product by powder X-ray diffraction (PXRD) and quantitative infrared (IR) spectroscopy. Abrasion of stainless steel was simulated by addition of pure 57Fe. The results provide insight into the chemistry of phosphate conversion coatings or during battery cycling of metal phosphates and give theoretical guidance for the preparation of amorphous phosphates. Thermal analysis revealed…
Study by static SIMS, XPS and UPS of the adsorption of cyanogen on (100) Ni surfaces
2000
Abstract The interaction of cyanogen with (100) Ni surfaces at room temperature was studied using secondary ion mass spectrometry in a static mode, and photoemission spectroscopies (XPS and UPS). It has been shown that cyanogen is adsorbed on this nickel surface in a dissociative mode: atomic carbon and nitrogen are present on the surface as well as CN fragments. These adsorbed species have been characterized by XPS and UPS. Increasing the temperature in the 400 K range increases the rate of the dissociation reaction of CN into atomic carbon and nitrogen. Moreover carbon is found to dissolved into the bulk for temperatures as low as 475 K. No evidence has been found of a polymerized form of…
A surface EXAFS study of thin nickel deposits on (110) TiO2 surfaces
1997
Abstract The first stages of nickel deposition on a clean (110) TiO 2 surface were studied using surface extended X-ray absorption fine structure (EXAFS). Experiments were performed on two kinds of nickel deposits, one of 0.8 equivalent monolayers and another of 1.6 equivalent monolayers. Depositions were performed on well characterized TiO 2 (110)-p(1 × 1) surfaces. The correlation of Auger experiments with EXAFS results showed that no islands were present on the surface; only two-dimensional growth of nickel was observed. Moreover, it was shown, in the case of the thinner deposit, that a model with nickel atoms forming chains in the channels determined by oxygen atoms on the surface is co…