Search results for " Elettroni"
showing 10 items of 1073 documents
A New Low Cost Coupling System for Power Line Communication on Medium Voltage Smart Grids
2018
This paper proposes and verifies the performance of an innovative and low cost coupling system for power line communication (PLC) on medium voltage (MV) smart grids. The coupling system makes use of the capacitive divider of the voltage detecting systems (VDSs) to inject and receive the PLC signal. VDS are usually already installed in the MV switchboards of the major electrical manufacturer all over the world according to IEC 61243-5. VDS are used to detect the presence of the mains voltage to guarantee personnel safety. An interface circuit has been developed to be connected between the PLC transceiver and the VDS socket. In this way, the PLC signal can be coupled to the MV network without…
Decoupled control scheme of the grid-connected split-source inverter for renewable energy sources
2016
Grid-connected power conversion systems for renewable energy sources must fulfill several requirements, including high efficiency, reduced cost and complexity, and, quite often, also boost capabilities from the dc sources to the ac power grid. For such applications, single-stage power converters with boost capabilities offer some potential advantages. Among several proposed options, split-source inverter (SSI) has been recently investigated. This paper proposes a decoupled control scheme for the SSIs, where the common mode term of the ac modulation signals is used to control the dc input current. Thus, the dc input current and ac output current can be controlled independently. The proposed …
Synchronization techniques for power quality instruments
2004
The measurement of voltage characteristics in power systems requires the accurate estimation of the power supply frequency and signal synchronization, even in the presence of disturbances. The authors developed and tested two innovative techniques for instrument synchronization. The first is based on signal spectral analysis techniques performed by means of the Chirp-Z transform analysis. The second is a phase-locked loop (PLL) software based on a time-domain coordinate transformation and an innovative phase-detection technique. To evaluate how synchronization techniques are adversely affected by the application of a disturbing influence, experimental tests were carried out, taking into acc…
New Measurement Procedure for Load Flow Evaluation in Medium Voltage Smart Grids
2013
The aim of this paper is to present a new approach for the medium voltage (MV) distribution network load flow analysis, mainly based on power measurement at the low voltage (LV) level of MV/LV distribution substations. This allows to use measurement instruments, usually already installed in the secondary substations, thus achieving an equally reliable measurement system with a lower cost compared to measurements at the MV side. The new approach can be applied using a proper communication system to collect the nodal measurements and an iterative algorithm based on ladder iterative technique (LIT) to compute the load flow. The validity of this method is presented and discussed on the basis of…
Economic evaluation of PV system for EV charging stations: Comparison between matching maximum orientation and storage system employment
2016
This article addresses the problem of the choice of a generation system to be implemented to reduce the impact of charging electric vehicles at University. Based on the behaviour of the student population, it is identified the electrical load. Two possible solutions are evaluated in order to manage the peak load: an orientation of the panels in order to increase the power at defined time and the use of storage system. The main strength and weakness points of two systems are investigated by taking into account the Levelized Cost of Energy.
Measurement Issues for the Characterization of Medium Voltage Grids Communications
2013
This paper is focused on the measurement issues and procedures for the characterization of medium voltage grids for narrowband power line communications (NB-PLCs), in the perspective of the use and integration of such technology into smart grids communication networks. The fundamentals are given for the characterization of the PLC channel, by means of noise and attenuation measurements. Suitable procedures are also developed for the characterization and modeling of the power system components in the frequency range of interest. Furthermore, the complete model of the PLC system is experimentally validated in a real case study.
CIGS PV Module Characteristic Curves Under Chemical Composition and Thickness Variations
2014
This paper analyzes how the electrical characteristics of a CIGS photovoltaic module are affected by the chemical composition and by the thickness variations of the CIGS absorber. The electrical characteristics here considered are the short circuit current, the open circuit voltage, the efficiency and the power peak. The chemical composition is varied by tuning the ratio between gallium and indium. This analysis has been performed by means of the wxAMPS software, developed by the University of Illinois. The above variations have been taken into account on a PV module made of 72 cells. This analysis has been carried out employing a PV module mathematical model developed and implemented by th…
A DAQ-based sampling wattmeter for IEEE Std. 1459-2010 powers measurements. Uncertainty evaluation in nonsinusoidal conditions
2015
Abstract This paper presents the evaluation of the metrological performances of a DAQ-based sampling wattmeter (DAQ-SW) for the measurement of IEEE Std. 1459-2010 power quantities in non-sinusoidal conditions. The instrument makes use of two commercial data acquisition (DAQ) boards, a non-inductive current shunt, a personal computer and a commercial software for data processing. Starting from the results of an experimental characterization of the two instrument channels with non-sinusoidal voltages and currents and a correlation analysis, the combined standard uncertainties of IEEE Std. 1459-2010 quantities are evaluated, following the approach of the ISO Guide to the Expression of Uncertai…
Technical and economical evaluation on the use of reconfiguration systems in some EU countries for PV plants
2017
This paper shows the technical and economical evaluation of the application of a reconfiguration system for photovoltaic (PV) plants, considering the incentives system in some European Union countries. The reconfiguration system is an alternative to the distributed maximum power point tracking technique which used to increase the power production in the PV plants under the mismatch phenomenon. The reconfiguration techniques employ a microprocessor-based or field-programmable gate array-based system that modifies the layout of the PV plant through the change of the connections among modules. After having presented the main features working of the PV reconfiguration system allowing the improv…
Analysis of compressor architectures in MOS current-mode logic
2010
This paper is concerned with the design and the comparison of different compressor architectures for high performance multipliers in MOS current-mode logic (MCML). More specifically, three architectures have been designed for 3-2, 4-2 and 5-2 compressors and two architectures for 7-2 compressors. The various implementations for each type of compressor have been compared one another. This investigation indicates that the architectures based exclusively on three-level MCML gates are the most suitable for MCML implementation in terms of speed, power consumption and area. Design guidelines are provided to improve compressor performance. All the compressors were designed in a TSMC 180nm CMOS tec…