Search results for " Fourier Transform"
showing 10 items of 431 documents
Chemometric determination of lipidic parameters in serum using ATR measurements of dry films of solvent extracts
2013
Attenuated total reflectance (ATR) infrared spectroscopy of dried organic extracts of serum samples has been evaluated as a fast method for the determination of triglycerides, cholesterol, high density lipoprotein (HDL) and low density lipoprotein (LDL). After careful selection of solvents based on green parameters, serum samples were extracted using hexane-isopropanol and ethyl acetate-ethanol mixtures. Microscopy studies and comparison with standard spectra were performed in order to investigate whether the proposed methodology is suitable for the quantification of lipids in serum samples. The results of these preliminary studies confirmed that the variations in the IR spectra of sample e…
Capillary electrokinetic fractionation mass spectrometry (CEkF/MS): Technology setup and application to metabolite fractionation from complex samples…
2014
Capillary electrokinetic fractionation (CEkF) is investigated as a new, simple, and robust approach for semipreparative and analytical sample analysis based on pKa -dependant pH-driven electrophoretic mobility. CEkF was optimized with contactless conductivity detection and conducted with 10 kV reverse voltage for 10 min, then coupled on/at-line to ESI/MS. We propose a semi-empirical model with 14 representative compounds based on the correlation between sample/medium pH regulating the partial charge, the electrokinetic loading of the capillary and intensity (I) of analytes. According to the model, an empirical function (I = f (pH)) could be derived to calculate the acid dissociation constan…
New insights in the formation of silanol defects in silicalite-1 by water intrusion under high pressure.
2010
International audience; The "water-silicalite-1" system is known to act as a molecular spring. The successive intrusion-extrusion cycles of liquid water in small crystallites (6 × 3 × 0.5 μm(3)) of hydrophobic silicalite-1 were studied by volumetric and calorimetric techniques. The experiments displayed a decrease of the intrusion pressure between the first intrusion-extrusion cycle and the consecutive ones, whereas the extrusion pressures remained unchanged. However, neither XRD studies nor SEM observations revealed any structural and morphological modifications of silicalite-1 at the long-range order. Such a shift in the value of the intrusion pressure after the first water intrusion-extr…
Cubic smoothing splines background correction in on-line liquid chromatography–Fourier transform infrared spectrometry
2010
A background correction method for the on-line coupling of gradient liquid chromatography and Fourier transform infrared spectrometry (LC-FTIR) is proposed. The developed approach applies univariate background correction to each variable (i.e. each wave number) individually. Spectra measured in the region before and after each peak cluster are used as knots to model the variation of the eluent absorption intensity with time using cubic smoothing splines (CSS) functions. The new approach has been successfully tested on simulated as well as on real data sets obtained from injections of standard mixtures of polyethylene glycols with four different molecular weights in methanol:water, 2-propano…
Photoactivity of Nanostructured TiO2 Catalysts in Aqueous System and their Surface Acid-Base, Bulk and Textural Properties
2007
This work reports on the characterisation and determintion of the photocatalytic activity of some TiO2 catalysts prepared using TiCl4 as precursor. The samples, consisting of suspensions, dispersions or powders of nanonstructured anatase or rutile phases, were obtained in very mild conditions, i.e., by boiling the solution obtained after hydrolysis of TiCl4 at atmospheric pressure: it is worth noting that no calcination was necessary to obtain photoactive phases. The samples were characterised by X-ray diffraction (XRD), determination of the BET specific surface area (SSA), scanning electron microscopy (SEM) observations and diffuse reflectance spectroscopy (DRS). FT-IR spectroscopy was use…
Preparation and characterization of Al2O3 supported TiO2 catalysts employed for 4-nitrophenol photodegradation in aqueous medium
1998
Abstract In this paper the preparation and some bulk and surface characterizations of set of Al2O3 supported TiO2 photocatalysts are reported. The powders were home prepared by a wet impregnation method using titanium (IV) isopropylate. The impregnation was followed by thermal treatments and this procedure was repeated several times in order to obtain samples with different amounts of TiO2. The solids were characterized by X-ray diffraction, specific surface area determination, scanning electron microscopy coupled with an electron microprobe used in an energy-dispersive mode and diffuse reflectance spectroscopy. Moreover, all of them were tested as photocatalysts by using different kinds of…
Preparation, Characterization, and Photoactivity of Polycrystalline Nanostructured TiO2 Catalysts.
2004
Various preparations of nanostructured TiO2 starting from Ti(iso-OC3H7)4 or TiCl4 are reported. The samples were characterized by X-ray diffractometry, specific surface area and porosity determinations, scanning and transmission electron microscopy, and diffuse reflectance spectroscopy. 4-Nitrophenol photodegradation in aqueous medium was employed as a probe reaction to test the photoactivity of the catalysts. The photoactivity of some samples derived from Ti(iso-OC3H7)4 was found comparable with that of commercial powders. Calcination after the hydrolysis process was necessary to achieve crystallization of the particles before using them as photocatalysts for the reaction studied. The samp…
Preparation and characterisation of TiO2 (anatase) supported on TiO2 (rutile) catalysts employed for 4-nitrophenol photodegradation in aqueous medium…
1999
Abstract In this paper the preparation of two sets of polycrystalline photocatalysts prepared by supporting TiO2 (anatase) on TiO2 (rutile) or Al2O3 is reported. The powders were prepared by a wet impregnation method using titanium(IV) isopropylate. The impregnation was followed by thermal treatment and this procedure was repeated several times in order to obtain samples with progressively increasing amounts of TiO2 (anatase). The photocatalytic activity of all of the specimens was tested by carrying out the 4-nitrophenol photodegradation, used as a “probe” reaction, in aqueous medium and in different kinds of batch photoreactors. The solids were characterised by X-ray diffraction (XRD), sp…
Hyperbranched Polyglycerol-Based Lipids via Oxyanionic Polymerization: Toward Multifunctional Stealth Liposomes
2010
We describe the synthesis of linear-hyperbranched lipids for liposome preparation based on linear poly(ethylene glycol) (PEG) and hyperbranched polyglycerol (PG). Molecular weights were adjusted to values around 3000 g/mol with varying degrees of polymerization of the linear and the branched segments in analogy to PEG-based stealth lipids; polydispersities were generally low and below 1.3. The hydrophobic anchors were introduced into the lipid structures as initiators for the anionic polymerization of ethylene oxide and are either based on cholesterol or on different aliphatic glyceryl ethers. Complete incorporation of the apolar initiators was evidenced by MALDI-ToF analysis at all stages …
Synthesis and antimicrobial activity of new bromine-rich pyrrole derivatives related to monodeoxypyoluteorin
2006
The synthesis and antimicrobial activity of new pyrrole derivatives structurally related to monodeoxypyoluteorin are described. The insertion of a keto or methylene spacer between the phenol group and the pyrroloyl moiety of brominated 2-(2'-hydroxybenzoyl)pyrroles leads to a decrease of the antibacterial activity.