Search results for " Interface"
showing 10 items of 1741 documents
Optimized bath for electroless deposition of palladium on amorphous alumina membranes
2006
A new bath for the electroless deposition of palladium on anodic alumina (AA) membranes is proposed. It was found that the optimal conditions for the uniform deposition of palladium, with minimal damage to the AA membranes, were under conditions of pH 8.4 and plating times shorter than 30 min. The deposited Pd layer was detected by X-ray diffraction (XRD) and energy dispersive X-ray (EDX) analysis. The morphology of the AA membrane before and after plating was examined by scanning electron microscopy (SEM). EDX analysis revealed that palladium was deposited only on the surfaces of the membrane and Sn ions, coming from the sensitizing bath, were incorporated into the palladium layer. EDTA in…
X-ray Photoelectron-spectroscopy Investigation of Pumice-supported Nickel-catalysts
1995
Pumice-supported nickel catalysts, prepared by the method of slow homogeneous precipitation with urea, were analysed by x-ray photoelectron spectroscopy (XPS). By comparison with similarly prepared silica- and alumina-supported nickel catalysts, a preferential interaction of Ni2+ with Al3+ of the support has been determined. A quantitative XPS analysis indicated large segregation of nickel to the surface. The treatment with H2 at 673 K and 1073 K produced a partial reduction of Ni+2 to Ni0. The extent of the reduction was largest at 1073 K and in this case the reduced Ni in the metallic phase was detectable by x-ray diffraction. A decrease of the Ni 2p/Si 2p intensity ratio occurring in the…
Study by static SIMS, XPS and UPS of the adsorption of cyanogen on (100) Ni surfaces
2000
Abstract The interaction of cyanogen with (100) Ni surfaces at room temperature was studied using secondary ion mass spectrometry in a static mode, and photoemission spectroscopies (XPS and UPS). It has been shown that cyanogen is adsorbed on this nickel surface in a dissociative mode: atomic carbon and nitrogen are present on the surface as well as CN fragments. These adsorbed species have been characterized by XPS and UPS. Increasing the temperature in the 400 K range increases the rate of the dissociation reaction of CN into atomic carbon and nitrogen. Moreover carbon is found to dissolved into the bulk for temperatures as low as 475 K. No evidence has been found of a polymerized form of…
Trace Analysis of Plutonium and Technetium by Resonance Ionization Mass Spectrometry Using an Atomic Beam and a Laser Ion Source
1990
A method for low level detection of plutonium and technetium is described with a detection limit of less than 107 atoms. Plutonium is a very toxic element due to its radioactive decay as well as its chemical behaviour. It was released to the environment in large amounts during the fifties and sixties of his century, principally by nuclear-weapon tests and some accidents. As a result about 0.4 − 4 mBq per gram 239Pu(T1/2 = 24390 y), corresponding to 4 × 108 − 4 × 109 atoms, can be found in the Northern Hemisphere in soil samples.
A surface EXAFS study of thin nickel deposits on (110) TiO2 surfaces
1997
Abstract The first stages of nickel deposition on a clean (110) TiO 2 surface were studied using surface extended X-ray absorption fine structure (EXAFS). Experiments were performed on two kinds of nickel deposits, one of 0.8 equivalent monolayers and another of 1.6 equivalent monolayers. Depositions were performed on well characterized TiO 2 (110)-p(1 × 1) surfaces. The correlation of Auger experiments with EXAFS results showed that no islands were present on the surface; only two-dimensional growth of nickel was observed. Moreover, it was shown, in the case of the thinner deposit, that a model with nickel atoms forming chains in the channels determined by oxygen atoms on the surface is co…
Determination of the Absolute Density of Fe3+ and Ni2+ Ions in Langmuir-Blodgett Films
1996
By means of the Langmuir–Blodgett (LB) technique, mono- and multilayers of Ni2+ and Fe3+ containing fatty acid salts are transferred onto silicon wafers. After thermal treatment, oxidic layers can be produced. The absolute amounts of Fe3+ and Ni2+ ions per monolayer of LB film were measured and calculated by three different methods. In the case of nickel, the amount expected from theory and preparation conditions was obtained experimentally. In contrast, about twice the number of Fe3+ ions as expected is transferred. An explanation can be given by the presence of hydroxide groups bound to iron. The mean film thickness of the oxidic layers after thermal treatment was estimated where the thic…
Monte Carlo Simulations of Parallel Charged Platelets as an Approach to Tactoid Formation in Clay
2013
The free energy of interaction between parallel charged platelets with divalent counterions has been calculated using Monte Carlo simulations to investigate the electrostatic effects on aggregation. The platelets are primarily intended to represent clay particles. With divalent counterions, the free energy for two platelets or two tactoids (clusters of parallel platelets) shows a minimum at a short separation due to the attraction caused by ion-ion correlations. In a salt-free system, the free energy of interaction has a long-range repulsive tail beyond the minimum. The repulsion increases for tactoids with larger aggregation numbers, whereas the depth of the free-energy minimum is graduall…
A Lightweight, User-Controlled System for the Home
2006
This paper explores how we designed, with input from some elderly persons, a multi-agent user-controlled network for the home. The system was designed to support the elderly in living longer at home with minimal support. We describe how our work attempts to tackle issues such as privacy, control of personal space, and enjoyment within the home. As the number of elderly individuals’ increases, a certain amount of information gathering or support may be required to assist the elderly in their homes. However, we strongly believe that we should preserve people’s privacy in their homes and ensure that any artifact we propose is seen as enjoyable, aesthetically pleasing and, most importantly, not…
La resistenza di interfaccia calcestruzzo poroso-terreni a grana fina per il consolidamento di pendii mediante trincee drenanti profonde
2022
Le trincee drenanti profonde rappresentano uno dei metodi più efficaci per la mitigazione del rischio da frana, in pendii con falda idrica. Esse sono realizzate mediante pannelli o pali secanti. Il riempimento è costituito di calcestruzzo poroso o materiale granulare. Se le trincee sono adeguatamente “innestate” nel terreno stabile e il materiale di riempimento ha sufficiente resistenza e rigidezza come il calcestruzzo poroso, si ha ulteriore in-cremento di resistenza a taglio per effetto shear keys, oltre a quello derivante dalla riduzione delle pressioni in-terstiziali. L’incremento di resistenza è dovuto sia alla resistenza all’interfaccia calcestruzzo–terreni sia a quella intrinseca del…
Tribological properties of thin films made by atomic layer deposition sliding against silicon
2018
Interfacial phenomena, such as adhesion, friction, and wear, can dominate the performance and reliability of microelectromechanical (MEMS) devices. Here, thin films made by atomic layer deposition (ALD) were tested for their tribological properties. Tribological tests were carried out with silicon counterpart sliding against ALD thin films in order to simulate the contacts occurring in the MEMS devices. The counterpart was sliding in a linear reciprocating motion against the ALD films with the total sliding distances of 5 and 20 m. Al2O3 and TiO2 coatings with different deposition temperatures were investigated in addition to Al2O3-TiO2-nanolaminate, TiN, NbN, TiAlCN, a-C:H [diamondlike car…