Search results for " Lactic"

Microbial characterisation of fermented meat productions from the Sicilian breed "Suino Nero dei Nebrodi"

2012

Two traditional sausage products (“salsiccia” and “salame”) processed from the raw meat of the Black Sicilian swine “Suino Nero dei Nebrodi” were microbiologically investigated during the manufacturing and ripening stages. Both products were dominated by lactic acid bacteria (LAB), especially rod-shaped types. The concentration of enterococci was consistent in salame. Coagulase-negative cocci increased slower than LAB. Yeasts showed an increasing trend during the ripening of both products. Enterobacteriaceae were counted at a constant level of about 105 CFU/g in both products, while pseudomonads diminished during ripening. Coagulase-positive staphylococci, Listeria monocytogenes and Salmone…

Preparation and characterization of PLLA-HA scaffolds for bone tissue engineering

2013

In this work, the possibility to produce composite - Poly-L-lactic acid (PLLA) and Hydroxyapatite (HA) - porous scaffolds via Thermally Induced Phase Separation for bone tissue engineering applications was investigated. Several PLLA/HA ratios were tested (70/30, 50/50, 30/70 and 20/80 wt/wt) and the as-obtained scaffolds were characterized via Scanning Electron Microscopy (SEM), Wide Angle X-Ray Diffraction (WAXD) and compression test. The results showed that the presence of HA does not influence the phase separation process. Morphological analysis revealed an open structure with interconnected pores and HA embedded in the polymer matrix. This evidence was confirmed by WAXD analysis; where …

Study of green Sicilian Table Olive Fermentation Through Microbiological, Chemical, Hs-Spme and Sensory analyses

2011

Use of fortified pied de cuve as an innovative method to start spontaneous alcoholic fermentation for red winemaking

2016

Background and Aims: Some wineries, in order to promote the growth of yeasts able to ferment grape musts, traditionally produce wines using the ‘pied de cuve’ method. The aim of the present work was to study the performance of fortified pied de cuve (FPdC) prepared by addition of wine. Method and Results: Two FPdCs were prepared with the addition of wine at 1.5 and 3% (v/v) of ethanol to the musts and allowed to spontaneously ferment. The FPdCs were then added to fresh bulk musts in order to accelerate the spontaneous alcoholic fermentation (AF). Interestingly, several Saccharomyces cerevisiae strains isolated during the pied de cuve preparation were detected at the highest concentration th…

Evolution of the lactic acid bacterial biofilms on different wood typologies applied for the production of vats intended for cheese making

2017

The present work was carried out to evaluate the lactic acid bacterial biofilms formation on wooden vat produced with seven different woods, derived from trees species grown in Sicily. The biofilm formation on the wooden surfaces was performed as reported by Gaglio et al. Microbiological and scanning electron microscopy analyses did not show differences in terms of microbial levels and composition within the neoformed biofilms (Fig.1). The specific investigation of Salmonella spp., Listeria monocytogenes, Escherichia coli and positive-coagulase staphylococci did not generate any colony for all vats before and after microbial activation. Lactic acid bacteria (LAB) populations dominated the s…

Development of new dairy products using raw ewe’s milk to produce a “Swiss” type cheese

2022

Transfer, composition and technological characterization of the lactic acid bacterial populations of the wooden vats used to produce traditional stre…

2015

The biofilms of 12 wooden vats used for the production of the traditional stretched cheeses Caciocavallo Palermitano and PDO Vastedda della valle del Belìce were investigated. Salmonella spp. and Listeria monocytogenes were never detected. Total coliforms were at low numbers with Escherichia coli found only in three vats. Coagulase-positive staphylococci (CPS) were below the enumeration limit, whereas lactic acid bacteria (LAB) dominated the surfaces of all vats. In general, the dominance was showed by coccus LAB. Enterococci were estimated at high numbers, but usually between 1 and 2 Log cycles lower than other LAB. LAB populations were investigated at species and strain level and for thei…

Molecular characterization of dominant bacterial population in “Vastedda della Valle del Belice” cheese: preliminary investigation

2010

The sensory characteristics of raw-milk cheeses are linked to the cheese-making process, to the environmental factors as animal feeding and to the biochemical and microbiological composition of the milk. In this report we temped to characterize the microflora in the typical Sicilian historical cheese as Vastedda della valle del Belice. Each cheese was previous subjected to microbial isolation on specific media (M17 and MRS). The colony obtained on the solid medium were subject to biochemical tests and DNA extraction. The microbial diversity occurring in the strains was evaluated by PCR, RFLP and sequencing targeted on 16S ribosomal DNA. A number of closest relatives species of lactic and co…

BATTERI LATTICI CON ATTIVITA’ ANTIBATTERICA ISOLATI DA FORMAGGI TRADIZIONALI SICILIANI

2013

The study was conducted on typical Sicilian cheeses made from raw cow milk (Caciocavallo Palermitano) and sheep milk (Vastedda della valle del Belice PDO e Pecorino PDO). Genotypic identification of the LAB isolates was carried out by 16S/23S rRNA sequencing. a total of 400 bacteria strains were isolated and genotypically identified as Lactobacillus spp., Lactoccoccus spp., Pediococcus spp., Leuconostoc spp., Enterococcus spp. and Streptococcus spp. Evaluation of bacteriocin-producing LAB was investigated in vitro using the “spot on the lawn” method (2) aganist Listeria monocytogenes, Staphylococcus aureus, Salmonella enteritidis and Escherichia coli. Results showed a predominance of LAB sh…

Poly lactic acid based foams prepared via thermally induced phase separation (TIPS): A method to tune the crystallinity

2012

Blends of Poly-L-Lactic Acid (PLLA) with two Poly-Lactic Acid (PLA) in different proportions (90/10 and 70/30) were utilized in order to produce biodegradable and biocompatible scaffolds for soft tissue engineering applications. The scaffolds were produced via thermally induced phase separation (TIPS) starting from ternary systems where dioxane was the solvent and water the non-solvent. Morphology was evaluated by Scanning Electron Microscopy (average pore size and interconnection). Moreover a DSC analysis was carried out on the as-obtained scaffold in order to obtain information about theirs thermal properties (enthalpy of melt and crystallization). The results showed that is possible to p…