Search results for " Macchine E Azionamenti Elettrici"

A simple and accurate model of photovoltaic modules for power system design

2014

A Low-cost, Real-time Monitoring System for PV Plants based on ATmega 328P-PU Microcontroller

2015

This paper presents a real-time monitoring system for PV power plants based on a microcontroller Atmega328P-PU. The proposed system, whose performances can be relatively close to those achieved with commercial monitoring systems, is simple, low-cost and open source technology-based. In addition, a user interface, capable to communicate through a wireless network by using a standard communication protocol IEEE 802.15.1, is here presented. From the experimental tests described and discussed in this paper it is demonstrated that the proposed monitoring system provides, with adequate accuracy, all the information about the operating status of the PV plant, even during fault conditions.

A Innovative Monitoring Underwater Buoy Systems (MUnBuS) for Marine and Rivers installation with IR-Cam, Instrumental Telemetry and Acoustic Data Acq…

2015

The proposed low cost systems shows the results obtained in the implementation and testing in marine environment of a Innovative Monitoring Underwater Buoy Systems for Marine and Rivers installation with IR-Cam, Instrumental Telemetry and Acoustic Data Acquisition Capability (MUnBuS). This concerning a innovative Monitoring Underwater Buoy Systems that can be remotely controlled from the ground, air, satellite and sea and from a Center of Supervision Telecontroller And Data Acquisition and Monitoring (Mobile-STADAM Center). The Buoy is hosts for the radio or satellite communication equipment, the downloading and telemetering data equipment and the photovoltaic power supply, board and underw…

A security and surveillance application of the innovative Monitoring Underwater Buoy Systems (MUnBuS) on the Protected Marine Area (AMP) of capo gall…

2015

The proposed low cost systems shows the results obtained in the implementation and testing on real security application to Protected Marine Area surface and submarine environment of a innovative Monitoring Underwater Buoy Systems (MUnBuS) for installation with IR-CCTV-Cam, ultrasonic dolphin warning system and Green Laser Perimeter Detection. This concerning innovative Monitoring Underwater Buoy Systems that can be remotely controlled from the ground, air, satellite and sea and from a Center of Supervision Telecontroller And Data Acquisition and Monitoring (Mobile- STADAM Center). The Buoy is hosts for the radio or satellite communication equipment, the downloading and telemetering data equ…

An inertial system for the production of electricity and hydrogen from sea wave energy

2015

This paper aims at describing a small scale prototype of a complete wave energy converter system for hydrogen production promoting the opportunity of installation in Sicily, in the Mediterranean Sea. The opportunity to produce hydrogen from sea-water identifies ocean wave energy as the most promising solution for electricity generation including hydrogen production and storage. Even if hydrogen is considered one of the most promising secondary sources, criticism arises from both the academic and the industrial world mainly because hydrogen production requires electricity consumption. Furthermore, safety problems concerning hydrogen storage and transport are actually the main hindrance to fu…

A small scale prototype of a wave energy conversion system for hydrogen production

2015

In this paper a small scale prototype of sea wave energy converter for hydrogen production and storage is presented. Laboratory prototypes of the wave energy converter device and sea water electrolyzer are presented. Experimental results are shown. A cost-effective and efficient power electronics system is designed. Experimental waveforms of the wave energy converter are imported in the power electronics simulation model to simulate the whole system as closely as possible to its effective behavior. Simulation results are shown to test the efficiency of the proposed solution.

A device for PV modules I-V characteristic detection

2013

In this paper an electronic load suitable for the PV module I-V characteristic curve fast detection is presented. This device is designed in agreement with the IEC 82 Techinical Committee Standard since it allows the detection of the characteristic starting from voltage values even lower than 3% of the PV module open circuit voltage. The device main features are short time characteristc detection (2 s), limited ripple of the detected characteristic and low cost. Its validation is carried out by comparing measured data with data from simulations. Simulations are carried out considering two different commercial PV modules and by implementing in Matlab-Simulink environment the four lumped para…

Investigation of motor current signature and vibration analysis for diagnosing rotor broken bars in double cage induction motors

2012

This paper investigates the detectability of rotor broken bars in double cage induction motors using current signature and vibration analysis techniques. Double cage induction motors are commonly used for applications where successive loaded starts-up are mandatory. Experimental results were performed under healthy and faulty cases, and for different load conditions using each technique. Rotor broken bars fault detection based on sideband current components may fails due to the presence of inter bar currents that reduce the degree of rotor asymmetry, yielding to a decrease of the magnitude of these spectral components. But inter bar currents produce core vibrations in the axial direction, w…

Design, sizing and set up of a specific low cost electronic load for PV modules characterization

2013

In this paper, the design, sizing and set-up of a specific low cost electronic load, based on a DC-DC step-down converter, suitable for the PV module I - V characteristic curves determination, is described. In particular, for its set up, a low cost and user friendly micro-controller has been employed in order to generate the PWM signal. The measures carried out connecting the electronic load prototype to a commercial PV module are here presented and discussed. The conceived electronic load has allowed the determination of 80% of the PV module characteristic curves in 2 s. This low measurement time, lower than the time intervals in which weather conditions may change, allows to assume as con…

Performance of the Shape of Partial Discharge Signal Wireless Probes

2013

This paper focuses on the evaluation of the performances of three different antenna sensors suitable of Partial Discharge (PD) measurements. Monopole, triangular and spherical antennas were simulated by means of the surface moment method. The transmitting system is modeled by a power electronic device with a fault current between two metal plate. The shape of the simulated transmitted and received signals have been compared to verify the sensor the provides the best fidelity among the three. The auto-correlation function and the Pearson correlation index are adopted here for the comparison. A discussion on the dynamic characteristic of the different antenna probes and their use in different…