Search results for " Polyethylene"

Surface AFM microscopy of unworn and worn samples of silicone hydrogel contact lenses

2008

Abstract: Purpose. To evaluate the qualitative and quantitative topographic changes in the surface of worn contact lenses (CLs) of different materials using atomic force microscopy (AFM). Methods. The topography of five different CL materials was evaluated withAFM over a surface of 25 lm2 according to previously published experimental setup. Average roughness (Ra) and root mean square (Rms) values were obtained for unworn and worn samples. Results. The Ra value increased for balafilcon A (11.62–13.68 nm for unworn and worn samples, respectively), lotrafilcon A (3.67–15.01 nm for unworn and worn samples, respectively), lotrafilcon B (4.08–8.42 nm for unworn and worn samples, respectively), g…

1990

The countercurrent extraction method recently developed for the continuous polymer fractionation (CPF) was applied to linear polyethylene (Mw = 55 kg/mol; Mn = 16,7 kg/mol). At temperatures higher than 130°C, moderately concentrated solution of polyethylene were extracted to remove the low-molecular-weight components. Discontinuous fractionation experiments served to detect the best suited solvents. Diphenyl ether was chosen to demonstrate that the present extraction can be performed even with the same single solvent used to prepare the feed. For very high-molecular-weight polymers, mixed solvents are, however, normally better than single ones, since they allow an easier tailoring of thermo…

Combined SANS and SAXS experiments in polyolefins-hydrogenated oligocyclopentadiene (HOCP) blends

1998

Abstract Lamellar morphology in semicrystyalline polymer blends (iPP/HOCP and HDPE/HOCP) is investigated by means of Small Angle X-ray Scattering (SAXS) and Small Angle Neutron Scattering (SANS). The investigated blends present a complex phase diagram, as they show a miscibility gap. SAXS scattering curves of blends lying outside the miscibility gap can be analysed in the frame of the psuedo two phase model. In order to describe the complex morphology of blends lying inside the miscibility gap, the SANS technique revealed necessary. In this paper a novel method to describe the morphology of these complex systems by means of SANS is presented.

Influence of a sterically hindered amine on the photo-oxidation of low density/linear low density polyethylene blends

1990

Abstract Low density/linear low density polyethylene blends show a rate of degradation of the mechanical properties during photo-oxidation which increases with the content of the linear polymer. The use of a sterically hindered amine as UV stabilizer greatly improves the resistance of these blends to UV irradiation. The effectiveness of the stabilizer increases with the content of linear low density polyethylene.

Boceprevir is highly effective in treatment-experienced hepatitis C virus-positive genotype-1 menopausal women

2014

AIM: To investigate the safety/efficacy of Boceprevirbased triple therapy in hepatitis C virus (HCV)-G1 menopausal women who were historic relapsers, partial-responders and null-responders. METHODS: In this single-assignment, unblinded study, we treated fifty-six menopausal women with HCV-G1, 46% F3-F4, and previous PEG-α/RBV failure (7% null, 41% non-responder, and 52% relapser) with 4 wk lead-in with PEG-IFNα2b/RBV followed by PEGIFNα2b/RBV+Boceprevir for 32 wk, with an additional 12 wk of PEG-IFN-α-2b/RBV if patients were HCV-RNA-positive by week 8. In previous null-responders, 44 wk of triple therapy was used. The primary objective of retreatment was to verify whether a sustained virolo…

Effect of electron beam irradiation and plastic deformation on molar mass of medical grade ultra-high molecular weight polyethylene

2010

Badano wpływ sterylizacji metodą napromieniania strumieniem elektronów oraz deformacji plastycznej (zgniatania, rys. 1) polietylenu ultrawielkocząsteczkowego (UHMW-PE), stosowanego do wytwarzania panewek endoprotez stawu biodrowego, na masę molową polimeru. Stwierdzono, że sterylizacja wpływa na utleniającą destrukcję makrocząsteczek polimeru, której stopień zależy od użytej dawki promieniowania (zmniejszenie masy molowej masowo średniej). Procesowi temu towarzyszy sieciowanie makrocząsteczek (wzrost udziału frakcji nierozpuszczalnej). Z kolei sama deformacja plastyczna wydaje się nie mieć wyraźnego wpływu na proces degradacji. Tymczasem łączne zastosowanie obydwu czynników zewnętrznych pro…

The Effect of Impact Pressure on Positron Lifetime in Ultra High Molecular Weight Polyethylene (PE-UHMW)Chirulen®1120

2010

The paper presents the results of investigations of the effect of impact pressure (in the range of both elastic and plastic deformations) on the parameters of the positron lifetime spectra in PE-UMHW polymer known under the trade mark Chirulen1120. The changes in the long-living component of the positron lifetime spectrum, connected with the annihilation of o-Ps in the pick-off process, are analyzed in dependence on the impact energy. The impact duration in the Charpy’s tests depending on the impact energy was measured, too. The dependencies of the radius of the volume of empty spaces in which the positronium annihilates, on the impact pressure were determined applying the Eldrup-Tao model.

Immobilization of natural anti-oxidants on carbon nanotubes and aging behavior of ultra-high molecular weight polyethylene-based nanocomposites

2014

The use of natural antioxidants is an attractive way to formulate nanocomposites with extended durability and with potential applications in bio-medical field. In this work, Vitamin E (VE) in the form of α-tocopherol and Quercetin (Q) are physically immobilized on the outer surface of multi-walled carbon nanotubes (CNTs). Afterward, the CNTs-VE and CNTs-Q are used to formulate thermally stable ultra high molecular weight polyethylene based nanocomposites. The obtained results in the study of the thermo-oxidation behavior suggest a beneficial effect of the natural anti-oxidant carbon nanotubes systems. The unexpected excellent thermo-resistance of the nanocomposites seems to be due to a syne…

α-Tocopherol-induced radical scavenging activity in carbon nanotubes for thermo-oxidation resistant ultra-high molecular weight polyethylene-based na…

2014

?-Tocopherol, a natural antioxidant molecule, was physically immobilized on the outer surface of multi-walled carbon nanotubes (CNTs), and the resulting functionalised particles (f-CNTs) were dispersed in ultra-high molecular weight polyethylene aiming at improving its thermo-oxidation resistance. The success of the functionalization was assessed through spectroscopic and thermal analysis, and the influence of the filler on the thermo-oxidative stability of the nanocomposites was investigated through rheological analyses and infrared spectroscopy. We found that the addition of only 1 wt.% of f-CNTs brings about a surprisingly high oxidation resistance, with a five/ten-fold increase of the i…

Synthesis of Ultra-High-Molecular-Weight Polyethylene

1984

The catalytic activity of organometallic Ti-Al complexes with donor ligands in the low-pressure polymerization of ethylene was studied. These complexes were obtained by the reaction of ethylaluminium compounds like AlEt2Cl or Al2Et3Cl3 and titanium compound of the type Ti(OR)nCl4-n (where: R = C2—C10 alkyl, C6H5, C6H4X; X — m-CH3, p-CH3, m-OCH3, p-OCH3, m-Cl, p-Cl, p-Br; n = 1—4). The optimum conditions for the synthesis of these compounds, as well as their physico-chemical properties were studied by means of EPR and polarographic methods. The effect of the type and number of OR ligands in a catalytic system on the yield of polyethylene and on its properties was examined. Ti-Al catalysts wi…