Search results for " SPECT"
showing 10 items of 11464 documents
Comprehensive analysis of photoinitiators and primary aromatic amines in food contact materials using liquid chromatography High-Resolution Mass Spec…
2018
Abstract A comprehensive strategy for the analysis of UV-ink photoinitiators and primary aromatic amines (PAAS) in food-packaging materials such as, juice tetrabricks, pouches and bags has been developed using liquid chromatography coupled to Orbitrap High-Resolution Mass Spectrometry (LC-Orbitrap-HRMS). The methodology includes both quantitative target analysis and post-run target screening analysis. The quantitative method was validated after a previous optimisation of the single-stage Orbitrap fragmentation through the Higher-Energy Collisional Dissociation (HCD) Cell. Overall, the quantitative method presented recoveries ranging from 78% to 119%, with a precision (RSD) lower than 20%, f…
Modelling IR Spectra of Sulfonated Polyether Ether Ketone (SPEEK) Membranes for Fuel Cells
2020
Authors acknowledge support from LSC project No 2014/666 ERDF and students ( ) support from project 2DP/2.1.1.1.0/14/APIA/VIAA/009.
II) Wood pellets for home heating can be considered environmentally friendly fuels? Heavy metals determination by inductively coupled plasma-optical …
2016
Abstract The aim of the present study was to determine the concentrations of twelve potentially hazardous elements in wood pellet ashes obtained by the combustion of 13 pellet brands for sale in Italy, the impact of adding the ashes to soils and health risk of operator due to dust exposure. Samples were analysed by Inductively Coupled Plasma Optical Emission Spectrometry. The concentrations of heavy metals in ashes from stoves ranged from 0.41 to 7.2 mg kg − 1 for As, from 1.3 to 12 mg kg − 1 for Sb, from 1.8 to 12 mg kg − 1 for Zn, from 0.23 to 0.8 mg kg − 1 for Pb, from 0.18 to 2.8 mg kg − 1 for Ni, from 0.09 to 1.0 mg kg − 1 for Cd, from 0.46 to 3.4 mg kg − 1 for Cr, from 0.94 to 2.7 mg …
To incinerate or not? - Effects of incineration on the concentrations of heavy metals and leaching efficiency of post-precipitated sewage sludge (RAV…
2020
The major element and heavy metal concentrations of post-precipitated sewage sludge (PPS) and its ash residue (PPA) were determined using microwave digestion followed by inductively coupled plasma optical emission spectrometry (ICP-OES) and mass spectrometry (ICP-MS). To the best of our knowledge, this has not been previously done. In both PPS and PPA the heavy metal concentrations were clearly below the average concentrations than those encountered in sewage sludge in Europe. The leaching efficiency of the metal (Al/ Fe) used as a precipitation agent from post-precipitated sludge and its ash residue with phosphoric acid was also investigated with previously optimized leaching conditions. T…
Automatic mass spectra recognition for Ultra High Vacuum systems using multilabel classification
2021
Abstract In Ultra High-Vacuum (UHV) systems it is common to find a mixture of many gases originating from surface outgassing, leaks and permeation that contaminate vacuum chambers and cause issues to reach ultimate pressures. The identification of these contaminants is, in general, done manually by trained technicians from the analysis of mass spectra. This task is time consuming and can lead to misinterpretation or partial understanding of issues. The challenge resides in the rapid identification of these contaminants by using some automatic gas identification technique. This paper explores the automatic and simultaneous identification of 80 molecules, including some of the most commonly p…
Direct laser welding of pure titanium to austenitic stainless steel
2018
Abstract Direct butt joining of pure titanium to 316L stainless steel with continuous Yb:YAG laser was performed with variation of the beam offset from joint line. Mechanical properties of samples were evaluated by tensile tests and three-point flexural tests. The fractured surfaces and cross sections of welds were examined by scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS) and X-ray diffraction (XRD). Tensile properties of welds were strongly determined by the beam offset from joint line and are well described by Weibull statistics. Ultimate tensile strength of 174 ± 69 MPa and ultimate flexural strength of 297 ± 48 MPa were obtained. Brittle fracture took place in…
Microscopic Revelation of Charge-Trapping Sites in Polymeric Carbon Nitrides for Enhanced Photocatalytic Activity by Correlating with Chemical and El…
2019
The influences of chemical and electronic structures on the photophysical properties of polymeric carbon nitrides (PCNs) photocatalysts, which govern the microscopic mechanisms of the superior photocatalytic activity under visible-light irradiation, have been resolved in this work. Time-resolved photoluminescence and in situ electron paramagnetic resonance measurements indicate that the photoexcited electrons in the fractured PCNs swiftly transfer to the C2p-localized states where the trapped photoelectrons exhibit longer lifetime compared to those in the ordinary PCNs. Moreover, the structure deviation at the carbon (Cb) atoms around the bridging sites of heptazine ring units, where trappe…
Synthesis and Cytotoxicity of 1,4-Dihydropyridines and an Unexpected 1,3-Oxazin-6-one
2016
Eight heterocycles have been prepared in a one-pot reaction manner based on the Hantzsch dihydropyridine synthesis. The synthesis afforded seven dihydropyridines (DHP) and one unexpected 1,3-oxazin-6-one. Their structures were confirmed based on NMR spectroscopy and mass spectrometry. The obtained products have been evaluated for their cytotoxicity against eight cancer cell lines and one normal cell line. Two halogenated DHPs (7 and 8) displayed cytotoxicity toward all the nine tested cancer cell lines with IC50 values from 4.10 to 58.90 μm, while others showed selective activities. DHPs (7 and 8) bearing a Me group at C(2) and C(6) as well as a halogenated substituent at C(4′) were more an…
'Palaeoshellomics' reveals the use of freshwater mother-of-pearl in prehistory
2019
The extensive use of mollusc shell as a versatile raw material is testament to its importance in prehistoric times. The consistent choice of certain species for different purposes, including the making of ornaments, is a direct representation of how humans viewed and exploited their environment. The necessary taxonomic information, however, is often impossible to obtain from objects that are small, heavily worked or degraded. Here we propose a novel biogeochemical approach to track the biological origin of prehistoric mollusc shell. We conducted an in-depth study of archaeological ornaments using microstructural, geochemical and biomolecular analyses, including ‘palaeoshellomics’, the first…