Search results for " Tim"

Tracking Control of Networked Multi-Agent Systems Under New Characterizations of Impulses and Its Applications in Robotic Systems

2016

This paper examines the problem of tracking control of networked multi-agent systems with multiple delays and impulsive effects, whose results are applied to mechanical robotic systems. Four kinds of impulsive effects are taken into account: 1) both the strengths of impulsive effects and the number of nodes injected with impulses are time dependent; 2) the strengths of impulsive effects occur according to certain probabilities and the number of nodes under impulsive control is time varying; 3) the strengths of impulses are time varying, whereas the number of nodes with impulses takes place according to certain probabilities; 4) both the strengths of impulses and the number of nodes with imp…

Robustness with Respect to Delay Uncertainties of a Predictor-Observer Based Discrete-Time Controller

2006

This paper focuses on the delay-dependent stability problem of a discrete-time prediction scheme to stabilize possible unstable continuous-time systems. The delay-dependent stability condition is expressed in terms of LMIs. The separation principle between the proposed predictor and a state observer is also proved. The closed-loop system is shown to be robust with respect to uncertainties in the knowledge on the plant parameters, the delay and the sampling period. The proposed scheme has been tested in a real-time application to control the roll angle in a prototype of a quad-rotor mini-helicopter.

Novel concept for stabilising a hydraulic circuit containing counterbalance valve and pressure compensated flow supply

2016

In this paper, a novel concept for stabilising a hydraulic system containing a counterbalance valve and a pressure compensated flow supply is presented. The concept utilizes a secondary circuit where a low-pass filtered value of the load pressure is generated and fed back to the compensator of the flow supply valve. The novel concept has been investigated theoretically and experimentally. A linear model has been developed to verify the improved stability conditions. The novel concept has been implemented on a single boom actuated by a cylinder. The results show that the pressure oscillations in an otherwise unstable system can be suppressed with the novel concept. This happens without any c…

Finite-time stability and stabilisation for a class of nonlinear systems with time-varying delay

2014

This paper is concerned with the problems of finite-time stability FTS and finite-time stabilisation for a class of nonlinear systems with time-varying delay, which can be represented by Takagi–Sugeno fuzzy system. Some new delay-dependent FTS conditions are provided and applied to the design problem of finite-time fuzzy controllers. First, based on an integral inequality and a fuzzy Lyapunov–Krasovskii functional, a delay-dependent FTS criterion is proposed for open-loop fuzzy system by introducing some free fuzzy weighting matrices, which are less conservative than other existing ones. Then, the parallel distributed compensation controller is designed to ensure FTS of the time-delay fuzzy…

Ultrasonic Welding of PBT-GF30 (70% Polybutylene Terephthalate + 30% Fiber Glass) and Expanded Polytetrafluoroethylene (e-PTFE)

2021

The ultrasonic welding of polymeric materials is one of the methods often used in practice. However, each couple of material subjected to ultrasonic welding is characterized by different values of technological parameters. Therefore, the main objective of the research presented in this paper is to optimize the parameters for the ultrasonic welding of two materials, namely PBT-GF30 (70% polybutylene terephthalate + 30% fiber glass) and expanded polytetrafluoroethylene (e-PTFE). In this sense, the research was carried out considering a plate-type part made of PBT-GF30, which had a thickness of 2.1 mm, and a membrane-type part made of e-PTFE, with a thickness of 0.3 mm. The condition imposed o…

A strategic oscillation simheuristic for the Time Capacitated Arc Routing Problem with stochastic demands

2021

Abstract The Time Capacitated Arc Routing Problem (TCARP) extends the classical Capacitated Arc Routing Problem by considering time-based capacities instead of traditional loading capacities. In the TCARP, the costs associated with traversing and servicing arcs, as well as the vehicle’s capacity, are measured in time units. The increasing use of electric vehicles and unmanned aerial vehicles, which use batteries of limited duration, illustrates the importance of time-capacitated routing problems. In this paper, we consider the TCARP with stochastic demands, i.e.: the actual demands on each edge are random variables which specific values are only revealed once the vehicle traverses the arc. …

Comparison of KVP and RSI for Controlling KUKA Robots Over ROS

2020

In this work, an open-source ROS interface based on KUKAVARPROXY for control of KUKA robots is compared to the commercial closed-source Robot Sensor Interface available from KUKA. This comparison looks at the difference in how these two approaches communicate with the KUKA robot controller, the response time and tracking delay one can expect with the different interfaces, and the difference in use cases for the two interfaces. The investigations showed that the KR16 with KRC2 has a 50 ms response time, and RSI has a 120 ms tracking delay, with negligible delay caused by the ROS communication stack. The results highlight that the commercial inferface is more reliable for feedback control tas…

Efficient Transport Protocol for Networked Haptics Applications

2008

The performance of haptic application is highly sensitive to communication delays and losses of data. It implies several constraints in developing networked haptic applications. This paper describes a new internet protocol called Efficient Transport Protocol (ETP), which aims at developing distributed interactive applications. TCP and UDP are transport protocols commonly used in any kind of networked communication, but they are not focused on real time application. This new protocol is focused on reducing roundtrip time (RTT) and interpacket gap (IPG). ETP is, therefore, optimized for interactive applications which are based on processes that are continuously exchanging data. ETP protocol i…

PolyACO+: a multi-level polygon-based ant colony optimisation classifier

2017

Ant Colony Optimisation for classification has mostly been limited to rule based approaches where artificial ants walk on datasets in order to extract rules from the trends in the data, and hybrid approaches which attempt to boost the performance of existing classifiers through guided feature reductions or parameter optimisations. A recent notable example that is distinct from the mainstream approaches is PolyACO, which is a proof of concept polygon-based classifier that resorts to ant colony optimisation as a technique to create multi-edged polygons as class separators. Despite possessing some promise, PolyACO has some significant limitations, most notably, the fact of supporting classific…

2020

A soldier’s occupational physical task requirements are diverse and varied. However, the type of physical training that most effectively improves soldiers’ occupational task requirements has not been studied previously. The purpose of this study was to determine the important strength characteristics for soldiers during a repeated simulated military task course, and the type of training that may be effective to improve these abilities during a specialized military training period. Forty-two (n = 42) soldiers participated in the study. They were divided into three training groups; a soldier task-specific training group (TSG, n = 17), a strength training group (STG, n = 15), and a control gro…