Search results for " conversion"
showing 10 items of 447 documents
The generalized H-point standard-additions method to determine analytes present in two different chemical forms in unknown matrix samples. Part II. C…
2000
The generalized H-point standard-additions method (GHPSAM) is used in order to obtain the total Cr(VI) and chromate concentration in water samples whose matrices are completely unknown. Moreover, a new methodology, which is a modification of the GHPSAM, is proposed for the simultaneous determination of the two major chemical forms of Cr(VI) present in the sample. The method is based on the location of spectral intervals where the behaviour of the interferent absorbance can be considered as linear. From these intervals, the analyte concentration free from bias error can be estimated. Spiked samples of dig and harbour water measured in the UV–visible spectral region have been tested to check …
Efisiensi Biaya Pakan Melalui Pemanfaatan Rayap Pohon (Coptotermes sp.) dalam Pembesaran Ikan Mas Komet(Carassius auratus auratus)
2017
Tujuan penelitian ini yaitu mengetahui pertumbuhan relatif ikan mas komet dengan persentasi pakan rayap dan pelet, rasio konversi pakan dan efisiensi pakan dari masing-masing perlakuan, dan menganalisis biaya pakan yang dikonsumsi. Perlakuan pada penelitian ini menggunakan pakan rayap dan pelet dengan persentase yang berbeda. Perlakuan A = rayap 20% ; pelet 80%, B = rayap 40% ; pelet 60% dan C = rayap 60% ; pelet 40%. Hasil penelitian menunjukkan bahwa persentase pakan rayap dan pelet memberikan pertumbuhan relatif yang lebih baik pada perlakuan A 0,42 gram, B 0,10 gram dan C 0,26 gram. Nilai FCR yang terbaik diperoleh oleh perlakuan A 2,04 diikuti oleh C 3,3 dan B 7,9. Begitu pula dengan n…
Should TiO2 nanostructures doped with Li+ be used as photoanodes for photoelectrochemical water splitting applications?
2017
[EN] Different TiO2 nanostructures, nanotubes and nanosponges, were obtained by anodization of Ti under stagnant and hydrodynamic conditions. Samples were doped with Li+ before and after annealing at 450 degrees C during 1 h. The nanostructures were characterized by different microscopy techniques: Field Emission Scanning Electron Microscopy (FE-SEM) and Raman Confocal Laser Microscopy. Additionally, Incident Photon-to-electron Conversion Efficiency (IPCE), photoelectrochemical water splitting and stability measurements were also performed. According to the results, TiO2 nanostructures doped before annealing present the worst photocurrent response, even if compared with undoped samples. On …
Polychromatic femtosecond fluorescence studies of metal–polypyridine complexes in solution
2011
Femtosecond-resolved broadband fluorescence studies are reported for[ M(bpy)(3)](2+) (M = Fe, Ru), RuN3 and RuN719 complexes in solution. We investigated the pump wavelength dependence of the fluorescence of aqueous [ Fe(bpy)(3)](2+) and the solvent and ligand dependence of the fluorescence of Ru-complexes excited at 400 nm. For all complexes, the (MLCT)-M-1 fluorescence appears at zero time delay with a mirror-like image with respect to the absorption. It decays in <= 30-45 fs due to intersystem crossing to the (MLCT)-M-3 states, but a longer lived component of similar to 190 fs additionally shows up in RuN719 and RuN3. No solvent effects are detected. The very early dynamics are character…
Study of the Chemical Conversion of Aluminum Alloys by Coupling CFDE and EQCM
2004
The ability of the channel flow double electrode (CFDE) technique and electrochemical quartz crystal microbalance (EQCM) for studying in situ chromate phosphate conversion coating on 5182 aluminum alloys was explored. It was first demonstrated that aqueous Cr(VI) can be analyzed quantitatively with the CFDE technique by reduction into Cr(III) on a graphite electrode. Samples used for EQCM were quartz plated by physical vapor deposition using a 5182 alloy target, allowing thin layers of aluminum alloys with a similar chemical composition to be obtained. EQCM was adapted in order to account for the hydrodynamic conditions in an industrial process, by placing the quartz in a flow cell. In orde…
Intersystem crossing in Fe(II) coordination compounds
1994
Fe(II) spin-crossover systems can be quantitatively converted from the low-spin (LS) to the high-spin (HS) state well below the thermal transition temperature by irradiating either into the metal-ligand charge transfer or d-d absorption bands, and even in low-spin systems a transient population of the HS state can be achieved. This fact can be made use of to determine HS → LS relaxation rate constants for a wide variety of Fe(II) spin-crossover and low-spin systems. The HS → LS relaxation shows strong deviations from an Arrhenius behaviour, with nearly temperature-independent tunnelling below ∼70 K and a thermally activated process above ∼100 K. The range of more than 12 orders of magnitude…
Effect of raster resolution and polygon-conversion algorithm on landslide susceptibility mapping
2016
The choice of the proper resolution in landslide susceptibility mapping is a worth considering issue. If, on the one hand, a coarse spatial resolution may describe the terrain morphologic properties with low accuracy, on the other hand, at very fine resolutions, some of the DEM-derived morphometric factors may hold an excess of details. Moreover, the landslide inventory maps are represented throughout geospatial vector data structure, therefore a conversion procedure vector-to-raster is required.This work investigates the effects of raster resolution on the susceptibility mapping in conjunction with the use of different algorithms of vector-raster conversion. The Artificial Neural Network t…
Efficient generation of energetic ions in multi-ion plasmas by radio-frequency heating
2017
We describe a new technique for the efficient generation of high-energy ions with electromagnetic ion cyclotron waves in multi-ion plasmas. The discussed ‘three-ion’ scenarios are especially suited for strong wave absorption by a very low number of resonant ions. To observe this effect, the plasma composition has to be properly adjusted, as prescribed by theory. We demonstrate the potential of the method on the world-largest plasma magnetic confinement device, JET (Joint European Torus, Culham, UK), and the high-magnetic-field tokamak Alcator C-Mod (Cambridge, USA). The obtained results demonstrate efficient acceleration of 3He ions to high energies in dedicated hydrogen–deuterium mixtures.…
Wireless battery chargers for portable applications: Design and test of a high-efficiency power receiver
2013
In this study, the authors present a 5 W wireless battery charger for handheld devices. Efficiency-related issues are addressed. A power receiver architecture which improves power conversion efficiency is proposed. Design hints are provided for further applications. Comparison with a conventional architecture is provided as well. Laboratory prototypes of both the proposed and the conventional architectures have been realised. Both prototypes are tested by using the same power transmitter to perform a valuable comparison. As shown by the experimental results, in the receiver side power conversion efficiency is increased up to 99% thanks to the proposed solution.
An over-the-distance wireless battery charger based on RF energy harvesting
2017
An RF powered receiver silicon IC (integrated circuit) for RF energy harvesting is presented as wireless battery charger. This includes an RF-to-DC energy converter specifically designed with a sensitivity of -18.8 dBm and an energy conversion efficiency of â¼45% at 900 MHz with a transmitting power of 0.5 W in free space. Experimental results concerned with remotely battery charging using a complete prototype working in realistic scenarios will be shown.